Top 20w Led Module

iJDMTOY LED Pod Light Fog Lamp Kit Compatible with 2017-2020 Ford Raptor, Includes (4) 20W (2) 10W CREE LED Cubes, Foglight Location Mounting Brackets & On/Off Switch Wiring Kit

  • Complete LED foglamp kit includes (2) 3" amber 20W CREE LED pods, (2) 3" white 20W CREE LED pods, (2) white single-row 10W high power CREE spot beam LED pods, (1) set of industry grade metal constructed lower bumper opening area/location bracket mounts and dual relay wire harness w/ in-line fuse and on/off switch.
  • Easy to install LED fog/driving light kit features a 100% bolt-on installation procedures with no modification, cutting or drilling required.
  • Clevely utilize the factory lower bumper opening and upgrade them to total 100W high power off-road killer LED lighting for a super bright output, allow you to completely RULE THE NIGHT!.
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • -Arduino MEGA R3 (generic high quality) + USB cable -6xAA Battery holder (9VDC) -WiFi ESP8266 module -Model Bluetooth Master / Slave HC-05 -Box with plastic cells (organizer of components) -Shield for prototypes + Mini-Breadboard -Large Breadboard (830 points ) -Dupont Cables 10 * Female-Female + 10 * Male-Female + 10 Male-Male -Cable Jumper for breadboard -6 Push Buttons with multicolored caps -Joystick Module type PS2.
  • -RC-522 RFID Module with white RFID Card and RFID Keychain -High-precision RTC Real-Time Clock Module DS3231 and EEPROM AT24C32 -PIR Presence Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 *....
Check Stock

ENEGON 10000mAh Power Bank Fast Charging 12V/1.65A(PD 20W Max) with USB-C Wall Plug, Portable Chargers Slim Cell Phone External Battery Pack for iPhone 14 13 12 11 Pro Max Plus XR SE

  • ✅【20W Speedy Charging】Both of the Power Bank and Wall Charger can provide PD 20W max charging speed. 10000mAh capacity of this slim PD power bank is enough to top up iPhone 13 for 2.6 times, Samsung Galaxy S20 for 2.0 times or Pixel 3 XL for 2.3 times..
  • ✅【Charge 3 Devices at Once】ENEGON 10000mAh PD power bank is equipped with a 20W USB-C port plus two 18W USB 3.0 ports to support simultaneous charging for up to 3 devices..
  • ✅【Everything You Need】Provide fast charging to your phone or tablet wherever you are, and when you run out of juice, simply connect the included PD wall charger to fully recharge the power bank in less than 3 hours..
  • ✅【LED Digital Display】The Smart LED Digital Display shows the accurate status when charging and discharging. Especially show you if it’s fast charging or not. A green charging mark will display when it’s fast charging..
  • ✅【What You Get】10000mAh PD Portable Charger * 1.
  • User Manual * 1. We provide 24/7 friendly customer support and 18-month warranty and....
Check Stock

Artiva USA 70\ Modern Slim LED Torchiere Floor Lamp with Reading Light and Remote, Satin Nickel, 70\h

  • Compare to regular 200W halogen Lamp, Artiva 25W LED Lamp will save over $40 each year of your electricity bill (based on 6-hrs per day usage and 11 cents per kilowatt).
  • Exclusive 20W Super Bright Touch Dimming Switch Torchiere LED technology (2500 lumens) and Super Bright 5W(500 lumens) Reading Light. rated over 25000 hrs. Lasts over 22 years based on 3 hrs. of usage per day. 2500 lumens use only 20W of energy.
  • Modern Slims Design with Remote Control Switch.
Check Stock

Oval Halo Ring Spotlight , Ourbest Led Motorcycle Driving Lights, 20W Fog Auxiliary Lights Work Pods For Trucks Tractor Off Road Boat(2Pcs, White)

  • Super Bright- Motorcycle Led Spot Lights are designed as spot beam with Halo Ring, White color and Super Bright..
  • High Performance-Lower Power Consumption + High Efficiency of Heat Dissipation: aluminum housing helps dissipate heat quickly so it can work for longer time..
  • Waterproof + Dustproof - Design: IP68 rated waterproof, Shock and vibration resistant design makes it perfect for outdoor activities..
  • Application- 20W Oval Fog Light fits for cars, auto, motorcycles, motorbikes, trucks, offroad, SUV, ATV, boats, trailer, forklift, crane, dozer, tractor, automotive, vehicles..
  • Package- 2* 20W Led LED spot lights, mounting bracket, mounting Screw. Very Easy to install..
Check Stock

Auxbeam 3 Inch LED Light Bar 20w LED Pods Fog Lights Square Cube Lights Spot Beam Driving Light Waterproof for Offroad Truck 4WD SUV ATV UTV Pack of 2

  • 3 inch led light bars with 4D Fish eye hyperspot lens, is extremely bright even in daytime but consuming little power. It is designed to project light....
  • 20W LED spot light bars with softer light no glare, will not dazzle the on-coming traffic. Its pending aperture system blocks unused light for a clean....
  • It has full aluminum housing for extra durability while doubling as heat sink. It has about 50,000hrs life time with IP67 rated....
  • 3" 20W led light bars apply to off road vehicle lighting, emergency & rescue lighting, ATV/UTV/Golf cart lighting, Boat& marine lighting, agriculture....
  • Package Included: 2 x 20W LED spot light.
Check Stock

Pomelotree LED Window Lights LED Module Lights Waterproof Storefront Lights Business Decorative Lights 12V 5050 LED Lights for Advertising LED Signs Business Store Light 100FT RGB (10 Packs)

  • 【Enough brightness】- 3 LEDs for each module light, which ensure the brightness of your store, advertisements or any other attractive signs. There are three colors with the light: red, green and blue, which can be switched between these three colors through the remote control. All Accessories are included (10 strands of LED Lights 100 feet long in total, 2 Power Plug, 2 Remote controller)..
  • 【Premium commercial LED light】- IP68 waterproof LED module lights with sticky Self-Adhesive tape on the back of each module, which is convenient for you to install. There are sm-4p connectors on the end of each strand of LED module light. It will be much easier for you to connect the lights. Just plug. No need to crimp male female connectors any more. You should pay special attention to the positive and negative poles of the connectors to avoid short circuit..
  • 【Type】- 5050 SMD module, 12V DC input voltage. With ABS plastic material, Waterproof led window lights can work in -20~60℃. Besides, the color of the plastic will not gradually become yellow after long-term using. You can cut it each led into the length you want, DIY your own LOGO or Lighted Store Signs..
Check Stock

SainSmart USB 4 Channel Relay Automation (5V)

  • NOYITO 2-Channel Micro USB Relay Module is equipped with a stable USB to serial port chip and a microcontroller. It can use the serial port debugging software to send serial commands on the computer to control the opening and closing of the 2-channel relay..
  • Onboard high performance microcontroller chip, CH340 USB control chip.With power LED indicator and relay status LED.On-board 2-channel 5V, 10A/250VAC, 10A/30VDC relay, long relay life, can work 100,000 times continuously..
  • Module with overcurrent protection and relay diode freewheel protection..
  • NOYITO 8-Channel Micro USB Relay Module ASIN：B09RGTSHHW.
  • NOYITO 4-Channel Micro USB Relay Module ASIN：B09RGVQXXT.
Check Stock

WICHEMI 2 Pack Storefront Lights 100ft 200 Pieces 3 Led 5050 SMD LED Light Module Storefront RGB Window Strip Light Super Bright Waterproof Business Decorative Light for Store Advertising Signs

  • 【Enough Brightness】- 2 Pack, total 200 feet, 400pcs is 300W. 3 LEDs for each module light, which ensure the brightness of your store, advertisements or any other attractive signs. There are 7 colors with the light: red, green, blue, purple, yellow,white, light blue. which can be switched between these 7 colors through the remote control..
  • 【Premium Commercial LED Light】- IP68 waterproof LED module lights with sticky Self-Adhesive tape on the back of each module, which is convenient for you to install. Just plug. No need to crimp male female connectors any more. You should pay special attention to the positive and negative poles of the connectors to avoid short circuit..
  • 【Ideal Decorative Light】- 5050 SMD module, 12V DC input voltage. With ABS plastic material, Waterproof led window lights can work in -20~60℃. Besides, the color of the plastic will not gradually become yellow after long-term using. You can cut it each led into the length you want, DIY your own LOGO or Lighted Store Signs. ideal for indoor and outdoor different DIY applications.
  • 【Energy-saving】- Low power consumption, high energy efficient. The business decorative window lights can make your signs attractive with less cost. Packing included: 2 x 10 x 20Pcs 3 LED Module St....
Check Stock

Titoe CNC Machine 40W Wood Engraving Cutting Machine 10W Output Power Portable Mini Engraver Router Kit w/Eye-Protection for DIY Marking Wood Metal Leather(Engraving Area 420x400mm)

  • ✅【Desktop CNC Machine】Titoe 4240 CNC features a powerful 20W module which adopt the most advanced jet compression technology to reduce the beam to 0.08 x 0.08 mm.Easily cut 5mm wood or 3mm acrylic easily..
  • ✅【40W Moddule】Equipped with a aluminum heatsink and cooling fan, this can help the heat dissipate faster and ensure the module works continuously. This module can work at full power for 8 hours. The service life can be up to 10,000 hours.
  • ✅ 【Wide Application】Engraving area:420*400mm.
  • Widely used on different materials such as paper, bamboo, wood, leather PCB board, aluminum , metal, glass, etc..
  • ✅ 【New Eye Protection Design】The engraver with protective cover perfectly protects your eyes when it working. filter light for 97%. You and the people around can watch engraver without wearing goggles. Double limit switches can protect the engraving machine for good and stable operation perfectly.
  • ✅【 Wide Software Compatibility】compatible with LightBurn and Grbl, supports Win 7 / Win 8 / Win 10, and Mac system.You can directly carve by importing a picture..
Check Stock

Longer RAY5 Laser Engraver 130W, Higher Accuracy Laser Engraver 20W Output Power, 3.5"Touch Screen APP Offline Control, DIY Engraver Tool for Metal/Glass/Wood, Cutting Area 14.7"x14.7"

  • 【Strong Cutting Ability】Ray5 20W has a 20W optical output powerful laser module, which comes with the most advanced laser enhancement technology and enhance the cutting capacity of this machine. It can cut 0.59"/15mm pine wood and 0.31"/8mm acrylic in one pass, 25mm wood and 35mm acrylic multiple passes, and cut 0.002"/0.05mm stainless steel..
  • 【More detailed and Multi-Color Engraving】Longer RAY5 20W laser engraver with a newly upgraded 32 bits chipsets motherboard works more smoothly and stable. The advanced built-in 256-bit color scale with 0.08 * 0.1mm ultra-fine laser focus area achieves a finer engraving result and a higher contrast effect. And an air-assisted interface is reserved, which can be easily matched with various air pumps, and more clean surfaces..
  • 【3.5" color Touchscreen & 4 Connection Methods】The Longer RAY5 laser cutter has a built-in 3.5-inch color touchscreen with a user-friendly interface. You can directly operate the machine through the touchscreen, such as checking the engraving progress, adjusting the engraving speed, or other operations. Particularly totally User-Friendly Laser Engraver, this laser engrave....
Check Stock