Top 5v Motors

Stepper Motor HAT for Raspberry Pi,Jetson Nano Onboard Dual DRV8825 Motor Controller Built-in Microstepping Indexer Drives Two Stepper Motors Up to 1/32 Microstepping 5V 2.5A

• Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano.
• Protection features: Overcurrent Protection (OCP), Thermal Shutdown (TSD), VM Undervoltage Lockout (UVLO).
• Integrates 5V regulator, allows providing power to Raspberry Pi.
• 6 available microstepping modes, configured with the DIP switches: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step.
• Adjustable motor drive current via potentiometer, maximum 2.5A current output.
• Onboard dual DRV8825 motor controller IC with built-in microstepping indexer, drives two stepper motors, easy to use.
• Onboard multi connector options for stepper motors in different specifications.

Dilwe RC Boats 370 Water Cooling Pump with Motor Waterproof JR Plug Pump for RC Aircraft Carriers, Warships, Battleships

• Waterproof DesignThe RC water pump is waterproof and works well in water, JR plug suitable for plug into the receiver, plug and play..
• Long Working TimeUnder the condition of 5V voltage, the pump works continuously for 15 hours and pumps water continuously..
• Application forPut it to work normally, the temperature will be hot, but it belongs to the normal range and will not affect the use, suitable for RC aircraft carriers, warships, battleships, etc. on a series of remotecontrolled ships that require water cooling for motors and ESCs..
• Stable PerformanceThe power supply method is not to take power from the receiver, the battery used is greater than 2S and the voltage is between 728V, which is need to use a stepdown module to make the operation more stable..
• Special NoteThe RC water pump is suitable for installation on remote control boats that require water cooling with watercooled motors and without waterabsorbing steering gear..

L298P Shield R3 DC Motor Driver Module 2A H-Bridge 2 way For Arduino UNO 2560 NW

• Motor controller L298P, Drives 2 DC motors or 1 stepper motor.
• Max current 2A per channel or 4A max (with external power supply).

ZTW 30A ESC with 5V/2A BEC Output for Fixed Wing Airplane 2-4S LIPO (30A BEC)

• Super smooth, accurate and programmable throttle linearity and throttle response..
• Over temperature protection ,low voltage cut off protection ,signal loss protection and so on..
• Strong BEC output 2A/5V continuous and peak to 3A..
• Supporting high RPM motors and programmable by programming card and transmitter ..
• High efficiency with low resistance and low heat MOSFET and CPU.

SparkFun Auto pHAT Compatible with Raspberry Pi Google Coral NVIDIA Jetson and More All in One Robotics Package Quickly add functionality to Single-Board Computers Drive 2 Small DC Motors & 4 servos

• 4245 PSOC and 2-channel motor ports programmable using Qwiic library. On board ATTINY84A supports up to two DC motor encoders. PWM control for up to four servos..
• 5v pass-through from RPi. Uninhibited access to the RPi camera connector & display connector. USB-C for powering 5V rail (Motors/Servos/backpowering Pi).
• On board ICM-20948 9DOF IMU for motion sensing accessible via Qwiic library.
• Qwiic connector for expansion to full SparkFun Qwiic ecosystem. External power inputs broken out to PTH headers. Designed for stacking, full header support & can use additional pHATs on top of it.
• Raspberry Pi or other Single-board computer not included..

Hobbywing Ezrun 5V C4 Cooling Fan & 44 x 65mm Motor Heat Sink System RC Motor Fan For 1/8 Car#86080130 Blue,Get funshobby decal

KEYESTUDIO L298P Motor Driver HAT Shield GPIO for Raspberry Pi Model B/B+/A+/2/3/4 Zero and Zero W, High-Power Motor Speed Control Board Dual H Bridge with IR Receiver

• This Motor Driver HAT gives your Raspberry Pi the ability to drive two DC motors, with drive current up to 2A..
• Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards like Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B and later versions.
• Reserved I2C SPI control pins, allows to work with other control boards and sensors. Comes with an IR receiver for communication with an infrared remote controller..
• Included 4x M2.5*20MM screws, 4 xM2.5*10MM copper pillars, 4x M2.5 Nuts. Easy to install on your RPi board. Please note Raspberry Pi board, remote control and motors in the photos are Not Included!.

Art of Drone, Vol. 1 - Subliminal - Hi-Tech Drones and Sound Constructions Carved out of Real World Sound Ambiences

• ... Long Flight Time】: Come with 2 intelligent batteries which support up to 50 minutes flight in total. Please charge the battery with 5V/3A or 5V/2A wall charger. It takes about 6.5 hours to fully charge the battery..
• 【Level 6 Wind Resistance】: The low noise brushless motors plus the level 6 wind resistance provide you a quieter and stable flight experience. Its ability to hover in one spot without worrying about it moving around makes filming simple and enjoyable as you watch on your phone..
• 【9800ft Video Transmission】: The F7GB2 drone has extended video transmission range up to 3km/9800ft, providing you crisp images and smooth video..
• 【Safe to Fly and Back】: F7 drone will return to home automatically when the signal is lost, low battery or the Return to Home is pressed. Don't have to worry about losing your drone..

QPKING Electric System Circuit Tester,Automotive Electrical System Tools,9V-30V Electrical System Diagnostic Tool With 2.4-inch LCD Display

• ...is not only able to display the parameter curve diagram of the tested component, such as voltage, frequency, time, etc, but also can test the common automotive relay, like 5-terminal relays, and 4-terminal relays..
• [Component Activation&Injector Mode]: It can generate "Active" signals for components, such as lights, motors, and other on-board electronic devices. Also different pulse signals can be output to the injector, which provides 4 pulse modes to better detect the condition of the injector..
• [0-5V Power Supply&Voltage Alarm]: Capable of setting 0-5V output voltage, used to verify the wiring condition of the tested component. Equipped with voltage setting alarm. If a short circuit or fault causes the voltage to be greater than or less than the set value, the device will alarm..
• [Multi-language Feature]: 14 languages supported, English, Spanish, German, Russian, Italian, Polish, Portuguese, French, Vietnamese, Malaysian, Filipino, Indonesian, Arabic and Thai..

Dual Way Bidirectional Brushed 5A ESC 2S-3S Lipo Speed Control for RC Model Boat Tank 130 180 Brushed Motor Spare Parts

• Dual-way 5A Brushed ESC support 2S-3S Lipo..
• Suitable for 1/35 RC model cars,tanks,4WD RC cars..
• Small size with built-in capacitor module..
• The strong resistant current capability, excellent heat dissipation. Multiple protections: Throttle signal loss protection/Out of control..
• Note: Above 5A will burn out the ESC, 130, 180 brush motors are recommended. And Power supply should be 5V and signal input is PWM if not work well..

ACEIRMC 8pcs L298N Motor Driver Controller Board DC Dual H-Bridge Robot Stepper Motor Control and Drives Module for Arduino Smart Car Power MEGA R3 Mega2560

• When you are driving voltage (above logo for the 12 v input, can actually accept input range is 7 to 12 v) for 7 v to 12 v, can make to onboard power supply 5 v logic, when using the onboard after 5 v power supply, interface of + 5 v The power supply does not input voltage, but can yield 5V voltage for external use..
• The chip manual proposes to support 35V, but according to the book When the maximum voltage is applied to the maximum voltage of 298 conservative applications to 24V, for example, the motor with a rated voltage of 18V shall be driven.
• Great for for Arduino DIY Smart Car Robot Power MEGA R3 Mega2560 Duemilanove, if driving voltage is more than 12V, use external standard 5volt TTL outputs to switch the H-bridge circuits.
• No assembly required. This L298N board comes ready to go. Just wire up motors and power, easy to use.
• Double H bridge design, can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors, high efficient.

sb components Motor Driver Board for The BBC Micro bit 2 Channel DC Motors and 3 Channel Servos Motors Motor Driver for Micro bit BBC microbit Motor Driver Board

• micro:bit edge connector, directly pluggable.
• 2x DC motor interfaces, 3x servo interfaces.
• Integrates 5V regulator, up to 3A output current.
• Onboard multi connector options for DC motors in different specifications, onboard standard servo headers.