Top Arduino Pwm Controller

WSDMAVIS 2Pcs PWM to Voltage Module 0% -100% PWM Converted to 0-10V Voltage Digital Analog Signal Converter for PLC Signal Interface Switching

  • The PWM transfer voltage module LC-LM358-PWM2V converts the PWM digital signals into 0 to 10V analog signals.Allowable error:5%..
  • It can be used as signal interface switching for PLC or other industrial control boards. The output voltage is regulated by adjusting the duty ratio of the PWM..
  • The modules are small in size and easy to use in different places.Easy to operate, fine tuned by potentiometer..
  • MCU embedded technology.Work Voltage:DC 12V-30V(Power requirements:> 100MA).
  • Select the PWM signal input level range through short-circuit.The peak of 4.5V to 10V level. The short cap install in ‘5V’. This level is used for normal controller or 5V MCU.
  • The peak of 12V to 24V level, so inserted in 24V. The short cap install in ‘24V’. This level is used for normal PLC controller..
Check Stock

CHANCS Mini Electric Motor 775 DC 12V/24V With Drill Chuck and PWM DC Motor Speed Controller

  • This is a DIY combination of motor, bracket, B10 drill chuck，and 20A PWM speed controller, it can be used with a saw blade to become a mini saw..
  • 【The specification of motor:】 Rated Voltage: DC 12V, Unloaded Speed: 10000RPM, Load Speed: 8800RPM. Rated Voltage: DC 24V, Unloaded Speed: 20000RPM, Load Speed: 17600RPM. Starting current: 4-5A Motor Body Diameter: 42mm, Motor Body Length: 66.5mm, Shaft Length: 16mm, Shaft Diameter: 5mm..
  • 【The specification of bracket:】 Length: 50mm, Width: 52mm, Height: 53mm, Mounting hole diameter: 4mm, Thickness of bracket: 3mm..
  • 【The specification of the speed controller:】 Input Voltage: DC 10V-DC 60V (Ultra wide working voltage)； Output voltage: linear under load； Control Power: 0.01-1200W； Rated Current: 10A； Max Current: 20A (Long-term use of 10A, 450W or less, pay attention to keep the module free of heat dissipation conditions.)； PWM Duty Cycle: 0%-100%； PWM Frequency: 25Khz； Product Size(L x W x H): 77*45*28mm；.
  • 【Attention:】 1.About the PWM, please do not connect AC power directly(Such as:110V AC),the input volt of this controller should be DC 9V-60V,otherwise it will be burned out. 2.Make sure the positive and negative connections are correct before powering on the motor speed contro....
Check Stock

FlexSolar 60W Portable Waterproof Solar Panel Charger kit and FlexSolar 30A 12V/24V PWM Solar Charge Controller

  • 【Compatible with Mutiple Battery Types】 FlexSolar PWM Solar Charge Controller with 30A Rated Charge/Discharge Current is Compatible With 12V or 24V System and Suitable for Sealed Lead Seal, Gel,Flooded and Lithium battery..
  • 【Efficiency PWM Solar Charge Controller】FlexSolar Solar Charge Controller adopts advanced PWM Control Method and The Charging Conversion Efficiency is Up 75-80%..
  • MULTIPLE PORTS & OPTIMIZED CHARGING】-The voltage switchable USB2.0 port, QC3.0 port, DC port, and Type-C port are ready to charge smartphones, tablets, laptops, power stations, coolers, and more. An intelligent chip automatically identifies connected devices and adjusts output current to offer the fastest possible charging speed..
Check Stock

ACEIRMC ESP8266 ESP-12 ESP-12F NodeMcu Mini D1 Module for WeMos Lua 4M Bytes WLAN WiFi Internet Development Board Base on ESP8266 ESP-12F for Arduino,Compatible with WeMos D1 Mini 5pcs

  • This is D1 mini, it is a mini NodeMcu Lua WiFi board based on ESP-8266EX..
  • D1 Mini NodeMcu Lua 4M Bytes WLAN WiFi Internet Development Board Base on ESP8266 ESP-12F for Arduino, Compatible with WeMos D1 Mini..
  • 11 digital input / output pins, all pins with interrupt / PWM / I2C / support 1 line (except D0).
  • 1 analog input(3.2V max input). Micro USB....
  • WIFI development board,4M bytes.5V 1A switching power supply (switching power supply）onboard..
  • Our D1 mini development board compatible with Arduino WeMos and can be programmed in the compatible for Arduino IDE..
Check Stock

DC Motor Speed Controller PWM Speed Controller DC 12V 24V 60V 500W Electric Motor Speed Control Regulator Power Wheels Speed Controller With PWM Signal Generator Driver Module

  • 【High Grade Material】 This PWM Motor Speed Controller is made of premium quality circuit board material, which has a good durability and wear-resistance to ensure a long term service..
  • 【Soft-s【Soft-start protection】 The motor controller has a soft-start protection function that can effectively reduce the inrush current, protect the motor and prolong the life of the motor.tart protection】 The motor controller has a soft-start protection function that can effectively reduce the inrush current, protect the motor and prolong the life of the motor..
  • 【Digital Encoder Button】 The digital encoder knob can adjust the motor speed, which is more accurate and consistent to control the engine speed than ordinary potentiometers..
  • 【Features】 The duty cycle maximum and minimum limits can be set, as well as the PWM output frequency..
  • 【Wide Input Voltage Range】 This PWM DC Motor Speed Controller supports a widely input voltage from DC 9V-60V, and it fits to 12V 24V 36V 48V power supply, at the same time the output current is 12A, power 500w, which ensures a widely application. You can use this Adjustable Motor Controller in different occasions upon different purposes..
Check Stock

Arctic F9 PWM PST - Value Pack (5pc) - Standard Low Noise PWM Controlled Case Fan with PST Feature

  • Innovative DESIGN enables quiet and efficient ventilation: The innovative design of the fan blades improves the air flow and facilitates a highly efficient ventilation. The impeller was designed with a focus on minimzing the noise level yet delivering the desired airflow and pressure. Air flow – 43 CFM. Noise level – 0.3 sone.
  • Perfect case fan regulation with PWM: the PWM function allows the motherboard to run the fan precisely at its necessary speed. This guarantees the required cooling and minimizes the noise level.
  • Pwm Sharing Technology (PST) lowers noise: The PST assures That all of your fans listen to one control signal. E.G. You share the CPU cooler’s PWM signal and assure that your case fans stand down at low load and spin up whenever necessary.
  • Long service life: The fluid Dynamic Bearing comes with an oil capsule that avoids lubricant leakage. Thus this bearing is as quiet as a sleeve bearing but comes with a significantly higher service life.
  • Fan controller Made in Germany: The Arctic F8 PWM PST fan is well known for high airflow at a comfortable noise level. The real improvement is the motor and controller. Our German engineers made this fan work at lower speed When performance is not needed.
Check Stock

BougeRV Solar Panel Starter Kit 200 Watt, 9BB Mono Cells with 30A 12V/24V PWM Negative Ground Solar Controller, Solar Cables, and Mounting Z-Brackets for Camping and Off-Grid (100W*2)

  • One Purchase For Your Project. Totally 200 watts system, a one-stop installation kit contains 2 pieces of 100-watt solar panels, 1 of 20FT/10AWG solar to controller cable, 1 pair of 14-10AWG M/FF and F/MM Y connectors, 1 pair of 8FT/10AWG controller to battery cable, and 1 set of 8 units mounting z brackets..
  • 1-on-1 Solar Solution by BougeRV Tech Support & Warranty. BougeRV promises an 18-month product warranty & 25-years power warranty and a lifelong friendly service for you. Please contact us whenever you have any problem with BougeRV solar panel. We will provide you with a professional guide to building a solar system..
  • 9BB Cell Design. More Busbar, More Power. BougeRV 100W solar panel uses the high-level 9BB cell design, which has a 22.8% highest conversion rate. Increase the receptive surface of the cell.
  • a narrower ribbon decreases the covered area by 22%. It can charge a 12V or 24/48V battery by connecting several solar panels in series..
  • Negative Ground PWM Controller. BougeRV new version PWM charge controller has a negative ground design, allowing it to be compatible with more vehicle systems without worryi....
Check Stock

SparkFun MicroView - OLED Arduino Module

  • 26mm x 26mm x 10 mm, Arduino IDE 1.0+ Compatible.
  • 12 Digital I/O Pins (3 PWM), 6 Analog Inputs, Breadboard Friendly DIP Package.
Check Stock

QWORK Solar Charge Controller, 30A Adjustable Parameter Backlight LCD Display and Timer, 1 Piece

  • 30A Solar Charge controller: LCD display, one-click operation, automatic disconnection when the battery is full, automatic memory data storage..
  • Wide Application: Ideal for solar power generation systems, smart homes, solar chargers, solar ventilation systems, solar light boxes, solar billboards, solar warning lights and so on..
  • Multi-Layer Protection: Built-in overcurrent, short circuit protection, reverse connection protection and open circuit protection are all automatic recovery without damaging the controller..
  • Light Control and Time Control: The controller has light control and time control..
  • Three-Stage PWM Regulation Charging: Three-stage PWM regulation charging mode is adopted, including direct charging, lifting charging and floating charging. The controller is used to realize efficient and fast intelligent charging, and the service life of the battery is effectively prolonged..
Check Stock

Fingerprint Heartbeat Detector

  • This sensor kit comes with 37 basic sensors and modules, which is good for learning basic knowledge about sensors. The main controller is Not Included..
  • It comes with detailed tutorials which include pictures and code and 37 projects, explained step by step. Note we provide arduino tutorials, without Raspberry Pi tutorials..
  • Each module has 3-4 pins broken out that make it easy to plug into a solderless breadboard or hook up to with DuPont wires. They are intended to be used with the Arduino platform, but can also be used with the Raspberry Pi platform as well..
  • Packed well in nice box, also each item packed well separately..
  • High quality kit for those beginners who are interested in programming. 100% compatible with Arduino R3, MEGA 2560, NANO, Raspberry pi and more..
Check Stock

Signal Generator, Multi-Function LHT00SU1 Oscilloscope 2 Channel Input Virtual Oscilloscope Logic Analyzer USB Logic Analyzer

  • 【Supported Protocols】Serial Peripheral Interface, IIC, UART, SMBus, I2S, CAN, Parallel, Custom, Search, Async, 1-Wite, PS / 2.
  • 【Multi Purpose】8-channel logic analyzer, Data Logger. PWM controller, Frequency generator. Frequency meter, Remote controller.
  • 【Dual Channel】Dual channel voltmeter, Mixed signal oscilloscopes and logic analyzer, Dual input oscilloscope (single, 16Msps, 3MHz bandwidth).
  • 【Frequency Meter】PWM controller, Frequency generator. Frequency meter, Remote controller.
  • 【100% Guarantee】High quality product, we promise to do everything possible to satisfy all customers. However, if you are not 100% satisfied with our service or our products, simply contact us. We are always at the side of our customers to support and continuously seek new ways to improve.
Check Stock

Raspberry Pi User Guide

  • This sensor kit comes with 37 basic sensors and modules, which is good for learning basic knowledge about sensors. The main controller is Not Included..
  • It comes with detailed tutorials which include pictures and code and 37 projects, explained step by step. Note we provide arduino tutorials, without Raspberry Pi tutorials..
  • Each module has 3-4 pins broken out that make it easy to plug into a solderless breadboard or hook up to with DuPont wires. They are intended to be used with the Arduino platform, but can also be used with the Raspberry Pi platform as well..
  • Packed well in nice box, also each item packed well separately..
  • High quality kit for those beginners who are interested in programming. 100% compatible with Arduino R3, MEGA 2560, NANO, Raspberry pi and more..
Check Stock