Top Audible Continuity

Fluke 325 Clamp Multimeter AC-DC TRMS

  • Digital clamp meter measures AC current to 400 amp, AC and DC voltage to 600V, and resistance to 4 kilohms.
  • True RMS sensing meter provides accurate readings when measuring linear or non-linear loads, regardless of waveform.
  • Jaw opening measures current in a conductor up to 30mm without touching or interrupting the circuit.
  • Audible continuity sensor confirms that the circuit conducts electricity.
  • Meets IEC safety standard 61010-1, and is rated for CAT IV installations to 300V and CAT III installations to 600V.
Check Stock

Amprobe AM-500 Digital Multimeter

  • listed by 3rd party safety labs CSA, ACMA, and has been assessed to meet high safety, health, and environmental protection requirements within the European Economic Area (EEA).
  • Verify presence of AC and DC voltage in electrical sockets, extension cords, batteries and other electrical circuits.
  • Measurements: Voltage up to 600V AC/DC, AC/DC Current and Resistance.
  • Install, troubleshoot or repair light fixtures, fans or appliances.
  • Micro amps function to troubleshoot flame sensors used in gas appliances.
  • Audible continuity Diode Test Data hold Auto power off Low battery warning.
Check Stock

Tenma 72-1020 40,000 Count 4-1/2 Digit True RMS Benchtop Multimeter DMM

  • DC Voltage : 600mV, 3V, 12V, 60V, 300V, 1,000V.
  • DC Current : 120µA, 3mA, 30mA, 300mA, 10A.
  • Resistance : X1Ω, x100Ω, x1kΩ, x10kΩ.
  • Input Impedance : 20kΩ/V (DC), 9kΩ/V (AC).
  • Dimensions : 6.7"(H) × 4.9"(W) × 1.9"(D).
Check Stock

Fluke Networks PTNX8-DLX Pocket Toner NX8 Coax Cable Tester Deluxe Kit

  • Test VDV cables for continuity, AC and DC voltage, opens, shorts, 50-75 Ohm termination, and polarity/dial tone..
  • Interchangeable adapters to connect to any voice, data or video cables.
  • Eight ID caps for testing eight cables at once.
  • Auto shut-off and low-voltage circuit protection.
Check Stock

Extech MN24-KIT Electrical Test Kit

  • MN24 Digital Multimeter with large, easy to read display measures AC/DC Voltage, DC Current, Resistance, and Continuity and features Diode and Battery tests.
  • Included 40130 Non Contact Voltage Detector detects AC Voltage from 100VAC to 600VAC with a Flashing LED and Audible beeper.
  • Included ET15 Receptacle Tester tests for faulty wiring in 3 wire outlets with a standard North American 3 prong Plug.
  • Everything you need to stay safe and work smart on DIY home electrical projects.
  • The MN24 KIT includes the MN24 Digital Multimeter, Multimeter Test Leads, 40130 Non Contact Voltage Detector, ET15 Receptacle Tester, Storage Case.
Check Stock

Fluke 324 True RMS Clamp Meter

  • Digital clamp meter measures ac current to 400 amp, ac and dc voltage to 600v, and resistance to 4 kilohms.
  • True RMS sensing meter provides accurate readings when measuring linear or non linear loads, regardless of waveform.
  • Jaw opening measures current in a conductor upto 30 millimeter without touching or interrupting the circuit.
  • Audible continuity sensor confirms that the circuit conducts electricity.
  • Meets IEC safety standard 61010 1, and is rated for CAT IV installations to 300V and CAT III installations to 600V.
  • CAT IV 300V/CAT III 600 Volt safety rating.
Check Stock

Mastech MS2115A True RMS DIGITAL DC/AC CLAMP METERS Multimeter Amp Voltage R HZ

  • The Mastech TP8268 is an auto/manual ranging digital multimetera newer version of MS8268 belongs to MS8261 series.
  • With many great features such as NCV and back-lit LCD Screen.
  • DC 1000V/20A 200KHz 200uF 40Mohm Relative Measurement hFE Diode Check Continuity.
Check Stock

Tekpower TP8268 AC DC Auto/Manual Range Digital Multimeter with NCV Feature Mastech MS8268 Upgraded

  • The Mastech TP8268 is an auto/manual ranging digital multimetera newer version of MS8268 belongs to MS8261 series.
  • With many great features such as NCV and back-lit LCD Screen.
  • DC 1000V/20A 200KHz 200uF 40Mohm Relative Measurement hFE Diode Check Continuity.
Check Stock

Amprobe AM-530 True-RMS Electrical Contractor Multimeter with Non-Contact Voltage Detector and Temperature

  • Voltage up too 600V AC/DC, AC/DC current, resistance and frequency.
  • True-rms feature to accurately measure voltage and current in all conditions, including noisy environments affected by harmonics.
  • Capacitance for start-up and run capacitors.
  • Audible continuity, non-contact voltage detection and built-in flashlight.
  • Diode test and duty cycle for troubleshooting applications.
Check Stock

Tekpower TP8268 AC/DC Auto/Manual Range Digital Multimeter with NCV Feature Mastech MS8268 Upgraded MS88

  • The Tekpower TP8268 is Upgrade model of MS8268,an auto/manual ranging digital multimetera, newer version of MS8268 belongs to MS8261 series.
  • With many great features such as NCV and back-lit LCD Screen.
  • DC 1000V/20A 200KHz 200uF 40Mohm Relative Measurement hFE Diode Check Continuity.
Check Stock

General Technologies Corp GTC CM100 1 mA to 100 Amps AC/DC Low Current Clamp Meter

  • AC/DC current measurement from 0.001 up to 100 A. which makes it a great tool for measuring parasitic draws and AC/DC voltage measurement up to 600 volt.
  • Small jaw: 1.2 inches (W) x 0.53 inches (D) (300x13.4millimeters) with clamp opening up to 1/2 inch (12.5 millimeters).
  • Peak and Data hold functions with one rotary switch operation.
  • 2 readings per second sampling and continuity check with audible indicator.
  • Test leads soft carrying deluxe pouch and batteries included.
Check Stock

Tekpower TP8268 AC/DC Auto/Manual Range Digital Multimeter with NCV Feature Mastech MS8268 Upgraded MS88

  • The Tekpower TP8268 is Upgrade model of MS8268,an auto/manual ranging digital multimetera, newer version of MS8268 belongs to MS8261 series.
  • With many great features such as NCV and back-lit LCD Screen.
  • DC 1000V/20A 200KHz 200uF 40Mohm Relative Measurement hFE Diode Check Continuity.
  • Relative Measurement for the ranges, Tekpower 1 year warranty In USA.
Check Stock