Top Cathode Material

Adecco LLC 9 LED Glow in Dark Flashlights, 8 Pack Rubber Coated Small Flashlights with Straps, Portable Handy Lights for Camping, Hiking, Indoor, Assorted Colors

  • 【Super Bright 9 LED Flashlights】 Material is made of aluminum and covered with rubber, which is soft to the touch and durable. Provide you with plenty of light in the dark night and last for a long time..
  • 【Easy to Carry】 Kid flashlights are so handy and lightweight to keep in a desk drawer, car, or purse. A nylon lanyard is convenient to hang in any place. Ideal for everyday carries and use in all kinds of indoor and outdoor activities..
  • 【Widely Use】 Runs on 3 AAA batteries but is Not Included. The simple on/off button operation is located on the back of the flashlight. The mini flashlight is suitable for outdoor activities, hiking, adventure, camping, night fishing, walking, hunting, etc..
  • 【Kindly Note】 Please notice the anode and cathode on the battery carrier when installing the batteries. And be sure to distinguish the top(Anode) and bottom(Cathode) of the battery carrier, the flashlight won't work if the page is inserted upside down..
  • 【100% satisfied】 If you have any disappointing part, the after-sale team will solve your problem and provide satisfactory service within 24 HOURS..
Check Stock

Banner Q45VR2LP Sensor 35440

  • Head Size : 5 x 8.6mm / 0.2 x 0.34 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

Banner SM31EL Emitter 25724

  • Head Size : 3 x 5mm / 0.12 x 0.2 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

Banner SL10VB6VQ Slot Sensor 58324

  • Head Size : 5 x 8.6mm / 0.2 x 0.34 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

DC 5-12V/15-160V Stepper Motor Drive,PWM Adjustable Stepper Motor Controller Signal Generator Speed Regulator

  • Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End..
  • 3 Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ.
  • To control the stepper motor, mus connect to the driver.
  • PUL + and PUL- pulsed positive and negative.
  • EN + and EN- is to enable the positive and negative terminals.
  • DIR + and DIR- are the positive and negative directions..
  • Frequency of measurement can amount PUL and common cathode terminal (GND) two ports..
Check Stock

Festo 150857 SME-8-S-LED-24 Proximity Switch M8 3-Pin .3M Cable

  • Head Size : 5 x 8.6mm / 0.2 x 0.34 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

uxcell 20pcs Photosensitive Diode Photodiodes Light Sensitive Sensors,5mm Clear Round Head Receiver Diode

  • Head Size : 5 x 7mm / 0.2 x 0.28 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

CUTLER HAMMER E57LAL12T111SD Inductive Proximity Sensor New Old Stock

  • Head Size : 3 x 5mm / 0.12 x 0.2 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

uxcell 200pcs Photosensitive Diode Photodiodes Light Sensitive Sensors,5mm Clear Round Head Receiver Diode

  • Head Size : 3 x 5mm / 0.12 x 0.2 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

uxcell 20pcs Photosensitive Diode Photodiodes Light Sensitive Sensors,5mm Black Round Head Receiver Diode

  • Head Size : 3 x 4mm / 0.12 x 0.16 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

uxcell 10pcs Photosensitive Diode Photodiodes Light Sensitive Sensors,3mm Clear Flat Head Receiver Diode

  • Head Size : 3 x 4mm / 0.12 x 0.16 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock

uxcell 10pcs Photosensitive Diode Photodiodes Light Sensitive Sensors, 3mm Clear Round Head Receiver Diode

  • Head Size : 3 x 5mm / 0.12 x 0.2 inch (D*H).
  • Polarity: Anode (Longer Part) | Cathode (Shorter Part).
Check Stock