Top Clamp on Gas Flow Meters

JMCUHYD Manual Siphon Pump For Gas Oil Water Fuel Hand Transfer Pump With Siphon Hose & Clamp Portable Fuel Transfer Pump

  • ...e into the fuel tank,a few squeezes of the bulb will get the flow of fluid started, put the lower tube into the container,and the fluid will flow automatically.
  • 【SIPHON PUMP AND HOSE SET】Rubber bulb x1, Reinforcement Ring x 2, 3.9 ft hose x 1, 2.6 ft hose x 1, Shut-off clamp x 1 ".
  • 【RUBBER BALL】 The siphon bulb is made of high quality rubber, and has a built-in one-way valve to prevent backflow. Durable for long time use..
Check Stock

Keg Disconnect Ball Lock MFL Ball Lock Fittings Keg Connectors – Keg Coupler Stainless Ball Lock Keg Fittings 12-Piece

  • DISPENSE YOUR FAVORITE BEVERAGES: Use the G. Francis Ball Lock Keg Fitting Ball Locks 12-Piece Ball Lock Quick Disconnect Set with Liquid & Gas Disconnects, Swivel Nuts, & Hose Clamps to ferment and dispense craft cocktails, soda, and other beverages from your existing keg.
  • USE YOUR KEG: Each of the ball lock keg connectors (fittings) have an approximate 2.2-inch height and 1.3-inch outside diameter (5.6cm x 3.3cm) and is compatible with ball lock Cornelius (Corny) kegs and keg couple adapters for homebrewing.
  • Hose clamps have 0.2-inch to 0.5-inch (6-12mm) diameter while the barbed swivel nuts have 5/16-inch outside diameter (OD) fitted for 1/4-inch or 3/16-inch inside diameter (ID) hoses on your 3, 5, or 10 gallon keg.
  • BUILT TO LAST: Keg ball lock quick disconnects and hose clamp wings constructed from ABS plastic that resists rust and corrosion.
  • Swivel nuts and clamps constructed from food-grade stainless steel for maximum strength and longevity.
  • INSTALL EASILY: Tighten the swivel nut connecting the flare fitting before use.
  • Ensure correct fittings are installed on input and output posts – Light gray disconnect for gas inlet and black disconnect for fluid outlet.
Check Stock

Argon Co2 Professional Gas Flow Meter Tester Flowmeter peashooter for Mig Tig Welder Welding

  • Professional Ggs Flow Tester / Meter Peashooter Style.
  • Flowmeter tester scaled from 0 - 25 litres per minute in one litre graduations, used for testing the gas flow at the Mig or Tig torch.
  • Simply place the tester over the Mig or Tig gas nozzle and the gas flow is measured from the top of the ball, can be used for all gases..
  • Designed to check gas flow on Tig or Mig torches..
Check Stock

Plastic Hose Clips, Heavy Duty Speedy Double Snap Grip, Nylon Adjustable Fuel Line Air Water Hose Tube Clamp, White, Pack of 10, 9.1-10.2mm

  • WIDE APPLICATIONS ---- The clamp is mainly used to clamp the hoses to regulate the flow or cut off the hoses..
  • HIGH QUALITY ---- The materials used in all our products are of high quality POM plastic, good elasticity, clamping force. These plastic clamp Will definitely meet your needs in the process of use..
  • VARIOUS SIZE ---- In this package, We prepared 4 Sizes Plastic tube clamp clips, Including Diameter 0.4Inch, 0.49Inch, 1.18Inch, 1.37Inch. These siphon hose shut off clamp can Adjusts rate of flow with great precision, Easy to use and very convenient..
  • POWER FUNCTIONS ---- The small two sizes Tube Clamp with single position on/off gives positive shut-off with fingertip control.
  • Use for thin-walled tubing under 3mm (³⁄₁₆") O.D. In addition two Sizes Tube Clamp have a 15-position stepped adjustment that controls flow from full open to complete closure.
  • fits tubing from 8 to 15mm (⅛ to ⁷⁄₁₆") O.D..
  • THE BEST SERVICE ---- If you have any questions during the use of the product, please feel free to contact us, we will help you solve all your problems as soon as possible. To provide you with the most satisfactory shopping experience..
Check Stock

CarBole External In Line Fuel Pump: 116 PSI High Pressure Unversal 12V Electric Pump Injection Systems Replacement for 0580464070 With Mounting Bracket Clamp (Red)

  • 100% brand new and high quality. Universal external in line fuel pump. Does not need to be mounted inside the tank.
  • Operation Pressure: 5-8bar (72.5-116 psi).
  • Flow Rate-120LPH at 6.0bar (about 31.7GPH at 87PSI).
  • Flow Rate-100LPH at 7.0bar (26.4GPH at 101.5psi).
  • Replaces 0580464070 and others but not OEM. Great for use with Mega Squirt and other aftermarket systems.
  • This pump is used for turbo/non turbo gas fuel injection systems up to 250bhp.
  • this is a universal fit pump and depending on your application some adapting will be required, installation may require skill and knowledge, no instructions are included.
  • Adopted Fuel Injection Molding Technology to upgrade the plastic parts of the product, which makes the fuel pump more durable, corrosion resistance and improve the service life of the pump.
  • Package including: 1pc high flow external fuel pump, 1pc Mounting Clamp, 2pcs rubber connection covers, 2pcs insulated terminals, 2pcs nuts, 2pcs gasket, 1pc bolt for bracket.
  • NOTE: It can only be used for gasoline and diesel, and CAN NOT be used for fuel containing methanol or ethanol, nor is it suitable for pumping water or oil..
Check Stock

HPDMC Oil-Free Hookah Dive System Third Lung Serface Vacuum Pump for Snorkeling (550W)

  • ...ified by filter. Discharge clean air for diving breathing..
  • Filtration for breathing air (Active carbon filter): The outlet air purification depends on the activated carbon and molecular sieve, so filter elements must be replaced periodically, especially for breathe purpose. The deepest working distance is up to 30 meters for one hose.
  • 10-15 meters for both if connects to two hoses..
  • Direct driven type compressor: This air compressor is the main body of the electromechanical air source device. It is the device that converts the mechanical energy of the primary motion (usually the motor) into the gas pressure energy, and is the pressure generating device for compressed air. The pump block unit is composed of crankcase, crankshaft, cylinder, piston, intake and discharge valves, connect rod , bearing etc..
  • Application: Widely used in Kayak Dive, Hookah Dive, Long Hose Gauge Scuba Diving, Commercial Boat Cleaning, Pool Cleaning, Dive Inspection, Lobstering Diving Propeller inspection etc..
Check Stock

IKENIUP One Stop Gas Appliance Hook Up Kit, 22'' Stainless Steel Flexible Gas Connector with 1/2''Brass Gas Shutoff Valve for Gas Log, Gas Dryer, Garage Heater, Gas Stove, Wall Heater and Fireplace

  • ...are x 3/8" Male Pipe & 1/2" Male Flare x 3/8" Female Pipe), 1/2" brass gas shut off valve, and yellow gas pipe thread seal tape. It has everything needed for installing most gas appliances and easy to install..
  • HIGHLY DURABLE & LONG SEVERITY LIFE - Made of High Quality 304 Stainless Steel. Designed for safe, optimal flow rate, the flow capacity is up to 150K BTU. This dryer gas line kit is 100% Leak Tested, CAS certified.
  • it has good air tightness, durability, rust and corrosion resistance. It is the perfect choice for hooking up your gas appliances..
  • CORRUGATED DESIGNED - The stainless steel gas line is designed with corrugation, which has high-level flexibility and is not easy to be damaged. Can be better used in a narrow range. Also, the corrugated gas line connector has staggered spacing every 2 inches to eliminate noise..
  • BRASS GAS SHUT OFF VALVE - The shut off valve is a great feature that allows you to directly shut off the flow instead of operating on the appliances. It is convenience for servicing appliances or summer shutdown..
  • COMPATIBLE WITH MOST GAS APPLICANTS - Our universal gas dryer installation kit is suitable for gas log, gas stove, gas dryer, wall mounted heater, garage heater, fireplace, and so on. It can be used indoor or outdoor..
Check Stock

LZQ-7 Flowmeter 2-20LPM Acrylic Air Gas Flowmeter with Control Valve for Measuring Controlling Gas Flow

  • This gas meter is connected to hose to measure unidirectional gas flow.
  • Made of high quality acrylic, it is transparent and can hold up to 0.6MPa pressure.
  • It is simple to use, and has 8mm barbs for convenient connection to hoses.
  • Can measure blast furnace gas, coke oven gas, coal gas, air, nitrogen, acetylene, phosgene, hydrogen, natural gas, liquefied petroleum gas, hydrogen peroxide, flue gas, methane, butane, chlorine gas, methane, carbon dioxide, , compressed air, argon.
  • Mainly used for detecting the flow, control flow and can be used in industry.
Check Stock

Balacoo Shut Off Clip - 24pcs Siphon Hose Flow Control Clamp Shut Off Plastic Tubing Clip with Gear

  • The hose clamp is widely used in analytical instruments, laboratories, pharmaceutical industry, chemical industry, gardening and other fields..
  • Adjustment pipe clamps can all be done with one hand. Very convenient..
  • 6 position tube lock: multiple gears can control the flow rate..
  • The Tube Clamps Kit is suitable for garden micro-spray and other fields that need hose flow control and stop flow..
  • The Shut Off Hose Clamp is mainly used to clamp the hoses to regulate the flow or cut off the hoses..
Check Stock

Gas Flowmeter, LZQ-7 Flowmeter 1-10LPM Flow Meter with Control Valve for Oxygen Air Gas

  • INSTRUCTIONS -- This gas meter is connected to hose to measure unidirectional gas flow.
  • MADE OF HIGH QUALITY ACRYLIC -- Made of high quality acrylic, it is transparent and can hold up to 0.6MPa pressure.
  • IT IS SIMPLE TO USE -- It is simple to use, and has 8mm barbs for convenient connection to hoses.
  • MEASURABLE GAS -- Can measure blast furnace gas, coke oven gas, coal gas, air, nitrogen, acetylene, phosgene, hydrogen, natural gas, liquefied petroleum gas, hydrogen peroxide, flue gas, methane, butane, chlorine gas, methane, carbon dioxide, oxygen, compressed air, argon.
  • MAINLY USED FOR -- Mainly used for detecting the oxygen flow, control oxygen flow and can be used in industry.
Check Stock

JohnDow Industries JDI-FST15 15-Gallon Gravity Fed Steel Portable Fuel Station Gas Can Red

  • FAST & EFFICIENT TO Fill: The 8ft kink free hose of the gas caddy ensures maximum flow and the tank is filled at the fastest speed.Wide diameter neck provides a larger opening for fill, without spilling or waste of fuel. And ergonomic hand crank, labor-saving and improve efficiency..
  • SAFE: Friction will cause static electricity in the process. The design of anti-static grounding clamp,it can prevent accidental static discharges and eliminate static electricity , so its safe to use. The fuel caddy is deal for storage of gasoline and diesel..
  • MOVABLE & EASY TO USE: Wheel and Hand pusher design for easier mobility and transportation. The design of easy to read vent/fuel level gauge makes it convenient for you to observe the remaining oil in the. Reversible rotary hand pump can suck the fuel remains in the kink free hose back to the fuel tank ,convenient and waste free..
  • LARGE CAPACITY: 30 gallon large capacity fuel storage space design. The fuel transfer tank is ideal for gas powered lawn and garden tools, automobiles, ATVs and a wide range of fuel powered pieces of equipment..
  • STURDY & DURABLE: The gas tank is made of high quality material. Heavy-duty iron tank is sturdy and durable,not easy to deform.Therefore, it has a long service life..
Check Stock

Argon Co2 Gas Flow Meter Scale Tester Measure Flowmeter for Mig Tig Welder Welding 1PK

  • Suitable for the Nozzle Caliber range of 4 - 30mm.
  • Flowmeter tester scaled from 0 - 25 litres per minute in one litre graduations, used for testing the gas flow at the Mig or Tig torch.
  • Simply place the tester over the Mig or Tig gas nozzle and the gas flow is measured from the top of the ball, can be used for all gases..
  • Designed to check gas flow on Tig or Mig torches..
Check Stock