Top Cold Cathode Light - BuyWiseBest.com

LAHV90 Rainsoft AirMaster Equivalent Replacement 65501 C231924 by LSE Lighting

Brand: LSE Lighting - EPA Est. No. 96823-PA-1.
This UV replacement lamp by (LSE Lighting Brand) is fully compatible with Culligan 01017267, C231924, LAHV90, Rainsoft 65501, Air Master Ultra Ozone systems..
This UV replacement lamp by (LSE Lighting Brand) is fully compatible with Culligan 01017267, C231924, LAHV90, Rainsoft 65501, Air Master Ultra Ozone systems. All lamps listed are compatible brand (LSE Lighting) UV products. We do not sell Culligan, RainSoft, AirMaster brand lamps. All Culligan, RainSoft, AirMaster brand names, trademarks and logos are property of Culligan, RainSoft, AirMaster..

Type:Common Cathode(Note:5643 Series may be Common Cathode or Common Anode, Be suject to part number).
Five different LED Display 7 Segment are available to satisfy your different needs..

MAX7219 is an integrated serial input / output common-cathode display driver, which connects your microprocessor to a 7-segment digital LED display with 8 digits.
MAX7219 digital display control module, you can use it..
The module is compatible of 5V / 3.3V microcontroller.
Only three IO ports are used to drive the eight digit display..
Only three IO ports are used to drive the eight digit display. MAX7219 supports flicker free displays as well as cascading displays.
PCV board four corners of the fixed copper stud, which can effectively precent short circuit accidents happen..
Wiring instructions (a program, for example, you can pick any IO port definition can be modified in the program): VCC to 5V, GND to GND, DIN to P00, CLK to P02, CS to P01.
Digital tube is 0.36 inch 4-bit integrated cathode digital tube.
Note:VCC and GND do not reversed, it would burn the chip.51 MCU P0 port requires pull-up resistor, if your device does not have a pull-up resistor can be connected to other ports data lines..

CCFL Halo Eyes are made from glass and CCFL technology (Cold Cathode Fluorescent Tubing).
Makes your lights looks more luxurious and aggresive at the same time.
Listing is for two BLUE rings and a dual transformer with instructions on how to install..
We also have white, red, green, purple, and orange available. Email us if you want a different color after payment is made..

CCFL Halo Eyes are made from glass and CCFL technology (Cold Cathode Fluorescent Tubing).
Makes your lights looks more luxurious and aggresive at the same time.
Listing is for two BLUE rings and a dual transformer with instructions on how to install. (not a complete headlight assembly).
We also have white, red, green, purple, and orange available. Email us if you want a different color after payment is made..

Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End..
3 Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ.
To control the stepper motor, mus connect to the driver.
PUL + and PUL- pulsed positive and negative.
EN + and EN- is to enable the positive and negative terminals.
DIR + and DIR- are the positive and negative directions..
Frequency of measurement can amount PUL and common cathode terminal (GND) two ports..

Mount Hole Diameter: 0.31 inch / 8mm (drill an appropriate sized hole around 8 mm) Wire Detail:24awg, Length: 7.9inch / 20cm.
Led Overview: 5 Single Color each 2 pcs Total 10 pieces,Including Colour White Red Green Blue Yellow, Viewing Angle: 30 Degrees, Colored Round 5 mm Small Lens.
Voltage: 12 V(5V 6V 9V 12vdc for Different Brightness), Current: 20mA, Wattage: 0.24W( 0.25W ), Polarity: Anode "+" (Orange Wire) | Cathode "-" (Black Wire) leddiode.
Resistor: 560 Ω ohms, 1/4W 0.25W (discrepancy: ±1%), Resistor Leg Width: 0.5mm, Pre Soldered Wired with Cable.
Compatible with: Panelmount Dash Board Indicator,Car Lighting,Footwell,grill,Brake Light,Turn Signal Light,Boats,Architectural Lighting,DIY Hobby,Replacement Bezel Clip Holder,.