Top Control Module

Logitech USB Unifying Receiver - 2 Pack

  • Applications: This device can be wildly used to wireless remote control,wireless audio,somatosensory devices, RFID, NFC, smart grid, smart home, etc..
  • NRF24L01 Wireless Transceiver Module with 125 Communications channels, multi-point communication and frequency hopping to meet the communication....
  • NRF24L01 wireless transceiver module built-in 2.4GHz antenna, small size, 15x29mm (including antenna).
  • it can be directly connected to a variety of....
  • The operating voltage of the wireless module is generally 3.3v, while the ordinary 51 microcontroller is 5v. This module is convenient to shop....
  • NRF24L01 Socket Breakout Adapter with NRF24L01 Wireless Transceiver Module.
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

Aideepen 5PCS DFPlayer Mini Mp3 Player Board Module Voice Decode Board Support TF Micro SD Card U Disk Audio Music

  • 【Upgrade】This is a MP3 Player Audio Voice Module, can be connected directly to the speaker.GD3200B chip replacement old YX5200 (Compatibility....
  • Supported Sampling Rates (kHz):8/11.025/12/16/22.05/24/32/44.1/48.
  • 24 -bit DAC output, support for dynamic range 90dB , SNR support 85dB..
  • The DFPlayer perfectly integrates hard decoding module, which supports common audio formats such as MP3, WAV and WMA. Besides, it also supports TF....
  • This Module with battery power supply, speaker, keypad can be used alone, or through the serial port control, as the Arduino UNO or any....
  • A variety of control modes, I/O control mode, serial mode, AD button control mode.-->If you need any questions, please feel free to contact us..
Check Stock

Honeywell Lynx Touch L5210 Home Automation/Security Alarm Kit with WiFi and Zwave Module

  • Kit Includes LYNX Touch 5210 Control Panel with Transformer and Battery Backup (3) 5815 Slim Door/Window Transmitters, (1) 5834-4 Four-button Wireless Keyfob & (1) 5800PIR-RES Wireless Motion Detector.
  • Integrated Z-Wave Support via L5100-ZWAVE Z-Wave Control Module (Included) for up to three thermostats (HVAC system or battery powered) with 1°F and 0.5°C set points Four door locks - Jammed locks reported to Honeywell Total Connect Remote Services 40 devices (lights, switches and lamp modules) 20 scenes 20 rules (event-based actions) 20 schedules (time-based actions) Sunrise/sunset lighting control Randomized lighting control.
  • Wi-Fi via L5100-WIFI Wi-Fi IP Communication Module (Included) for L5210 IEEE 802.11 B/G/N radio Supports alarm reporting Supports two-way voice LYNX Connect app supports up to four mobile iOS and Android devices. Internet Central Station Communication with L5100-WIFI or ILP5 Module.
  • Control Panel Dimensions (approx) 6.1" H x 8.5" W x 1.71" D (15.5cm H x 21.6cm W x 4.4cm D).
  • **PAID MONTHLY SERVICE REQUIRED FOR HONEYWELL'S TOTAL CONNECT REMOTE SERVICES**.
Check Stock

Electric Skateboard ESC Kit, 10S 36V Single Drive ESC Substitute Control Mainboard with Remote for DIY Electric Skateboard Longboard

  • Made of high quality chip and electronic components, single drive design can offer excellent and stable performance..
  • The solid structure of mainboard can greatly lengthen the service life. With remote receiver module, so it supports remote control..
  • The well-organized circuit board is easy to install, but needs professional skills..
  • This electric longboard skateboard control system has EMP control module with remote module, it can do as ESC do..
  • With over-voltage, under-voltage, overheating, over-current​ protection, safe and reliable to use, supports speed control, easy to use. With a LED indicator that displays signal status, speed modes, battery percentage..
Check Stock

Dorman 599-217 Front Climate Control Module Compatible with Select Chevrolet/GMC Models

  • Direct replacement - this HVAC control module is specially designed to match the appearance and function of the original unit in select vehicles.
  • Plug-and-play installation - just remove the old module, plug in new module, and vehicle performs automatic recalibration.
  • Design options - module comes with both older and newer knob designs so you can pick your preference.
  • 100% new - module is newly manufactured, not remanufactured, with state-of-the-art components.
  • Ensure fit - to make sure this part fits your exact vehicle, input your make, model and trim level into the garage tool.
Check Stock

SIEMENS 6ES7 214-1AG40-0xB0 SIMATIC S7-1200 CPU 1214C, Compact CPU

  • Programmable Control -- This module is programmable control, can achieve thousands of functions, stable and reliable working performance, built-in watchdog timer circuit, to ensure that the module for a long time to run Input high speed pulse C235, C251 and FX1N compatible.Output relay 1A output, Rated current 5A, can directly drive DC solenoid valve, AC solenoid valve, AC contactor, AC motor, etc..
  • Built-in Analog Input and Output -- Built-in Analog input AD, corresponding to internal data register D5030.(Not D8030) Built-in Analog output DA, corresponding to internal data register D5101..
  • The PLC with Two Programming Port -- The TTL interface and the 232 interface. The 232 interface, you can directly use the USB-232 serial port with a computer to download the program directly. When the PLC need to connect with the touch screen or text, can be used to conne....
Check Stock

MPC Emergency Manual Release Kit for Shaved Doors/Door Poppers

  • Built-in Relays - The new control module has built-in relays which eliminates 90% of wiring for a cleaner, faster, simplified installation. This system will shave AT LEAST an hour off the install time.
  • Single wire connections: No need to buy extra wire or make splice connections. Our new control module includes a wiring harness w/1 WIRE to run to each side of the vehicle & connect to the solenoid.
  • Programmable Safety Feature - To prevent accidents, our new control module automatically disables the door popper system if it sense that the vehicle is running.
  • Redesigned Remotes - Sleek two-button design w/a sliding cover to prevent accidental door opening while the remote is in your pockets. Press both buttons at the same time for optional trunk release!.
  • (2) Heavy-duty solenoids (45 lb. max pulling force), (2) chrome door poppers, RC receiver w/built-in relays per door, (2) 2-button 3 transmitters, (2) push buttons, steel linkage cable.
Check Stock

HiLetgo HC-05 Wireless Bluetooth RF Transceiver Master Slave Integrated Bluetooth Module 6 Pin Wireless Serial Port Communication BT Module for Arduino

  • The factory setting is slave mode, but you can set this module to master mode so that you might be able to connect to other Bluetooth 2.0 devices.HC-05 Wireless BT Module.
  • HC-05 Wireless BT Module: with this HC 05 Bluetooth module,You can quickly add the Bluetooth feature to your Arduino project, and then you can use your android phone to control some gadgets, such as: switch, LED..
  • Master and Slave 2-IN-1 HC 05 Module:Working Voltage 3.6V to 6V , Default baud rate:9600,Default pin:1234.
  • Button: Press the button, the module enter the AT mode. AT commands are executed only in AT mode..
  • 6 PIN Dopunt Cable : with this Dupont Cable, you can easily connect this HC-05 Bluetooth module to your Arduino Board.
Check Stock

Philips Hue 2-Pack Wall Switch Module (For Philips Hue lights only), White

  • KEEP YOUR LIGHTS POWERED ON AND REACHABLE: With the Philips Hue wall switch module, your lights are always on and connected to your smart lighting system..
  • CONTROL LIGHTS, ROOMS, OR A ZONE: Use your existing light switch to control your Philips Hue smart lights in a Room or Zone..
  • CYCLE THROUGH UP TO THREE LIGHT SCENES: Use your existing light switch to set up to three different light scenes..
  • BATTERY INCLUDED: The Philips Hue wall switch module includes a battery with a minimum lifetime of five years..
  • HUE BRIDGE REQUIRED: The Philips Hue wall switch module requires a Hue Bridge..
Check Stock

Power Supply, DPS3005 /DPS5005 Communication Version Bucks Power Supply Step-Down Voltage Converter(DPS3005-USB-BT)

  • The constant voltage and constant current programmable control power supply module put the collection of analog integration and digital control functions in one.DPS3005 /DPS5005 have same functions, only the technical parameters are different,for example, voltage, current ,etc.
  • This module has power-down stored function and can store 10 groups preset value.And it also has the function of extracting quickly two groups stored value. Though this module has reverse connection protection and output short circuit protection, you can muse be in strict accordance with connection description to connect. If you connect the supply power with output, the module will be burnt.
  • Compared with the traditional analog power supply, it is more convenient to quickly extract the voltage or current required. This module has many advantages, small size, advanced function, good visual effect, high operability, high-precision, being used independently, being inset into the device and been widely applied.
  • LCD display on the module has the function digital voltmeter and ammeter.You can view the preset voltage, input voltage, output voltage, the preset current, output current, output power, etc.
  • On the setting data interface, you can adjust over-voltage value, over-current value, o....
Check Stock

Fan Control Module, Radiator Cooling Fan Control Unit Module for Mazda 6 MPV Outlander Lancer 1355A124

  • Oem Number: Reference OEM 1355A124, AJ511515YA, AJY215SC0, AJY215SCO, L3361515YA, direct replacement part for the old one, for stable performance and durable..
  • Fitment Compatibility: Fit for Mazda 6 MPV Outlander Lancer. After installed, enjoying fan system working more stable when you driving..
  • Installation Tip: Turning off the engine, replace the new cooling fan module after the water in engine radiator cooled to the room temperature.
  • Avoid the external high heat source after installation.
  • Avoid sprinkling water on surrounding auto parts during the installation..
  • High Quality : Top quality fan control unit module, 100% brand new aftermarket cooling fan control module. Built to strict quality control standards, high reliability..
  • Friendly Notice: Please check part number, key parameter and information carefully before placing order this item.
Check Stock