Top Current Input

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 3)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 10)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

KOOBOOK 2Pcs Mini DC-DC Boost Step-up Power Supply Module 3.3V 3.7V 5V 6V 7.2V 9V to 12V Voltage Regulator Converter

  • 1.2A current limiting resistor,Remove the resistance, the maximum input current can reach 2A..
  • But IC have "Over Temperature Protection" Function.It will turn off the power MOSFET automatically when the internal junction temperature is over 150....
  • DC-DC Boost module working frequency 1.0MHZ..
  • 2.54mm pin pitch,Arduiuo UNO DUE Breadboard FPGA / CPLD Development Board friendly..
Check Stock

Juried Engineering LF347N LF347 Quad High Speed JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-14 (1 Piece)

  • The LF347 devices are high-speed, JFET-input operational amplifiers.
  • Low Input Noise Current: 0.01 pA/√Hz Typical.
  • Low Total Harmonic Distortion, High Slew Rate: 13 V/ms Typical.
  • Low Supply Current: 8 mA Typical, Gain Bandwidth: 3 MHz Typical.
Check Stock

Omron EE-SX671 Slotted Optical Micro Sensor 4 Pins ! WOW !

  • Price For: Each Sensing Range Max: 5mm Output Current: 100mA Sensor Output: NPN Supply Voltage DC Min: 5V Supply Voltage DC Max: 24V Input Current: 35mA Input Current Max: 35mA No. of Channels: 1 RoHS Compliant: Yes.
Check Stock

JBL BASSPROSL Powered 8 (Renewed)

  • General Specifications Amplifier Power125W RMS Fuse20A Maximum Current Draw12A Quiescent Current Drawless than 800mA Input Sensitivity0.2V – 2V Line-Level Input.
  • 2V – 20V High-Level Input Audio Specifications Frequency Response35Hz – 120Hz Crossover Frequency50Hz – 120Hz Crossover Slope12dB/octave Bass Boost0dB to +9dB @ 70Hz.
Check Stock

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

Yosoo 1000W ZVS Low Voltage Induction Heating Board Module Tesla coil 12V-48V Flyback Driver Heater DIY

  • This section of induction heating using low-voltage DC power supply 12-48V Maximum current 20A, maximum power 1000W..
  • Tested 53V power supply when working properly..
  • Because of its moderate power, can be used for small parts DIY players do hardening, annealing and other heat treatment, Also can be used with a graphite crucible melting gold, silver, copper, aluminum and other metals, uniform heating fast, very convenient..
  • 24V input with no load current of 3A , 48V input with no load current of 6A.
  • The higher the voltage, the greater the heating current when the same thing, the effect is better, But at the same time heat is also large, so to eradicate the actual situation to select the input voltage, the general use of the words 24V or 36V power supply is enough..
Check Stock

DC Buck Boost Converter, Drok 5V-30V Step Up Down to 0.6-30V Digital Control Power Supply, 6V 12V 24V Voltage Regulator, LCD Digital Display Buck Boost Module Voltage Transformer for Golf Cart

  • Output Power: 35W, Can Reach 50W If Add a Cooling Fan..
  • Display --- Digital LCD Display, Clear & Convenient to Watch..
  • Protection --- Over Voltage Protection(OVP).
  • Note --- When Input Voltage is Lower than 4.7V, it will trigger Low Voltage Protection. Recommend to use at Input > 7V. If Input Voltage < 7V, OutPut Power will be reduced..
Check Stock

Valefod DC to DC High Efficiency Voltage Converter 24V to 12V 40A 480W Buck Converter DIY Power Supply Step-Down Transformer

  • 【High-grade DC-DC Buck Converter】It adopts premium quality electronic components and waterproof (IP68) aluminum housing. Widely used for golf cart, club car, motor, speaker, GPS, car display screen, LED strip light, air-conditioner, electric fan, solar energy, DVD and other devices that requires DC 12V voltage..
  • 【Input Voltage】 DC 24V (Input Range: 18V to 36V). A stable DC power is recommended as the input power supply, and the rated voltage supply should be within the voltage range of 18V to 36V..
  • 【Output Voltage】DC 12V (Output Current: 40A). Please NOTE the output voltage/current/power is rated..
  • 【Multiple Protections】Built-in over-temperature, over-current, over-voltage, output short- circuit protection to ensure your devices safely..
  • 【Easy to DIY】Connect INPUT wires to power source, OUTPUT wires to your load device. The wiring diagram is labeled on the back of buck converter. Please don't power on before completing the circuit and connection, do not reverse the input and output interface. ※ Two INPUT wires = Red wire(positive pole) + Black wire(negative pole). ※ Two OUTPUT wires = White wire(positive pole) + Black wire(negative pole)..
Check Stock

AGPTEK USB Wall Charger 5V 500mA for iPod, Sony, Walkmam, SanDisk MP3 MP4 Player, Fitness Tracker, Fitbit, Black

  • APPLICATION: This product is specially designed for MP3/MP4 Music Players or other deivces below 1A of input current. MP3/MP4 Music Player's normal charging input current is 500mA (0.5A). Phone charger with quick charge usually is 2A which might cause damage for music players or other deivces below 1A of input current..
  • USB INTERFACE: Simply connect with a USB cable (not included) and plug it into a socket..
  • CERTIFICATION: FCC, CE, UL, GS/TUV, ROHS..
  • INPUT VOLTAGE: 100-240V, 50/60Hz. OUTPUT: 5V/500mA..
  • MP3 Wall Charger for iPod, Sony, Walkmam, SanDisk, Fitness tracker, Fibit and AGPTEK Rocker A20 A02 M20 M20S M28 R2 G02 G05S G05W C05 A12 model etc..
Check Stock

ResMed AirMini DC Converter 38839

  • ⚠️⚠️⚠️❤Attention: ⚠️⚠️⚠️❤1.If the vehicle charger works abnormally, please open its DC terminal to check whether the fuse tube is damaged. If so, please replace the 250V 16A fuse tube, then the product can be used normally. ⚠️⚠️⚠❤2.When the vehicle charger is connected to the equipment, it can support the instantaneous maximum input voltage peak value of 10V-30V..
  • ⚠️⚠️⚠️❤3.If the product is applied on other devices than the vehicle, the DC input shall meet the following power: When its DC input is 12V, the input current should no less than 8.3A.
  • When its DC input is 24V, the input current should no less than 4A, Otherwise, the vehicle charger may not work..
  • Input DC: 12V-24V (9–32V DC MAX) Output:24V 3.75A 90W.
  • Compatible With ResMed Airsense 10 Series: AirSense 10, AirSense 10 Elite, AirSense 10 AutoSet, AirSense 10 AutoSet for Her CPAP Machine with HumidAir Heated Humidifier.
  • Fits Resmed CPAP and BiPAP Machines S10 370001 +24V 3.75A 90W.
  • ResMed AirCurve 10 Series CPAP and BiPAP machine: AirCurve 10 S BiLevel Machine, AirCurve 10 VAuto BiLevel Machine with HumidAir Heated Humidifier.
Check Stock