Top Differential Input Voltage Range

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 3)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

Juried Engineering LM324N LM324 Quadruple Independent High-Gain Frequency-Compensated Operational Amplifier Op-Amp IC DIP-14 14-PIN DIP Breadboard-Friendly (Pack of 10)

  • The LM324 consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply or split supply over a wide range of voltages..
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA Typical, Wide Supply Ranges:003c/b003e Single Supply: 3 V to 32 V Dual Supplies: ±1.5 V to ±16 V.
  • Low Input Bias and Offset Parameters - Input Offset Voltage: 3 mV Typical - Input Offset Current: 2 nA Typical - Input Bias Current: 20 nA Typical.
  • Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground.
  • Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: 32 V.
Check Stock

DP10007 Oscilloscope Probe, DP10007 100MHZ 700V Probe, High Voltage Accessory for Voltage Testing

  • The attenuation rate is 10X, which can be used in any brand of oscilloscope, meet the needs of floating measurement..
  • DP series high‑voltage differential probes, specially designed for the measurement of high‑voltage differential signals..
  • High‑voltage differential probes sample high‑impedance isolation between input and output to protect person safety..
  • The power supply adopts USB DC 5V output and has a USB interface, which is easy to use and carry..
  • Convert the input high voltage signal to low voltage signal for oscilloscope observation and analysis..
Check Stock

Juried Engineering TL072CP TL072 IC JFET Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 5)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (1 Piece)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (Pack of 10)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL074CN TL074 Quad Low-Noise JFET-Input Operational Amplifier Breadboard-Friendly IC DIP-14 (1 Piece)

  • The TL074 Quad JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit.
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL064CN TL064 Quad Low-Power JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-14 (Pack of 5)

  • Typical Supply Current: 200 µA (Per Amplifier), Latch-Up-Free Operation, High Slew Rate: 3.5 V/µs Typical.
  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Common-Mode Input Voltage Range Includes VCC+, Output Short-Circuit Protection.
  • High Input Impedance: JFET-Input Stage, Internal Frequency Compensation.
Check Stock

Juried Engineering TL084CN TL084 Quad High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-14 (Pack of 10)

  • Low Power Consumption: 1.4 mA/ch Typical.
  • Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL072CP IC Dual Low-Noise JFET-Input Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

EC Buying AD620 High Accuracy Low Power Programmable Instrumentation Amplifier Module Voltage Amplifier Module Differential Amplifier Single-Ended/Differential Small Signal/Small Amplifiers Module

  • ...ensor interfaces. Also features low noise, low input bias current, and low power consumption. The module has a fixed voltage output..
  • ♥Basic Features: ✭Module Name AD620 Instrument Programmable Amplifier ✭Module size:50mm * 50mm ✭Module power supply: 5V-24V ✭Module input signal type: single-ended signal or differential signal ✭Module signal input and output range: the input signal range is within 100 microvolts of the power supply, and the output signal range is within the power supply ✭Module bandwidth: AD620: 120KHz (G=100), AD623: 800KHz (G=1), AD620/623 is lower than 50KHz at high gain, and higher than 1MHz at low gain.
  • ♥ Other Features: ✭Module gain: When there is no solder slip, the AD620 will zoom by 10 times by default, and the AD623 will zoom by 20 times by default. During welding slip, AD620: G=1+50K/Rg, AD623: G=1+100K/Rg ✭Maximum magnification of the module: more than 2000 times (actual measurement), due to the large gain of the waveform frequency band, it is recommended to use multi-stage amplification with high gain ✭Fixed output voltage: 5V-10V (default delivery 5V).
  • ♥ Other parameters: ✭Common mode rejection ratio: AD620: 100dB (minimum, G=10).
  • AD623: 90dB (minimum, G=10) ✭Input bias current: AD620: 1.0nA (max....
Check Stock

Juried Engineering TL072IP TL072 Dual Low-Noise JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-8 (1 Piece)

  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock