Top F32ttl74alto
Yamaha Alto Sax Mouthpiece 4C
- Material: the alto saxophone mouthpiece cushion is made of good quality rubber, which will not harm to your health.
- It's a good accessory of saxophone and clarinet.
- Package contents: you will receive 4 sheets, each sheet has 8 pieces mouthpiece cushions, the size of alto mouthpiece pad is about 2.7 x 2 cm/ 1.06 x 0.78 inch, 0.8 mm in thickness.
- Adhesive: this soft rubber pad with adhesive, which allows the teeth firmly fixed to the mouthpiece without slipping, no residue/ adhesive will be left on the instrument while peeling off.
- Wide application: the alto mouthpiece pad can protect the saxophone flute head and protect the teeth of the players, which is a great accessory for alto/ tenor saxophones beginners and suitable for the alto saxophone, tenor saxophone, and clarinet.
- Tip: after using these mouthpiece pads, please place it in a ventilated area and avoid direct sunlight.
Check StockSKYNEO Clarinet Cleaning Kit, Saxophone Cleaning Kit, Clarinet & Saxophone Care Kit, Maintenance Kit with Case for Wind & Woodwind Instrument
- CLARINET CARE KIT: 8 Pieces clarinet cleaning kits include 1 clarinet cork grease, 1 clarinet swab, 1 clarinet cleaning cloth, 1 alto sax reed case, 1 clarinet thumb rest cushion, 1 key brush, 1 screwdriver and storage case..
- SAX CLEANING KIT: Cork grease for alto saxophone keep saxophone, clarinet, flute lubricated smoothy. Alto sax cork grease safe, odorless, cork lubricant for clarinet, saxophone, bass clarinet, and more. Thumb rest make your finger feel more comfortable..
- CLEAN CLARINET ACCESSORIES: Microfiber Saxophone cleaning swabs and another clarinet cleaning cloth. Alto sax swab with rope head, tenor sax swab soft and absorbency, easy to pull through, flute cleaning cloth will easy to remove saliva inside saxophone, clarinet, flute etc..
- ALTO SAX CLEANING KIT: Saxphone mouthpiece brush and clarinet cleaning dust brush will easy to remove any dirt, grime and residue inside the trumpet, clarinet, alto saxophone. Sax cleaning kit keep your alto sax clarinet maintenance and healthy. Clarinet mouthpiece brush helps to clean without scratching your music instruments..
- CONVENIENT TENOR SAX CLEANING KIT: Sax cleaning kit comes with a light hanging case. Clarinet care kit the case has a portable hard zipper and a compartment, easy storage and keep neat ....
Check StockPlastic Reeds For Alto Sax, 3pcs Plastic Alto Saxophone Mouthpiece Reeds Strength 2.5 Repair Reed Accessory Black Plastic Reeds For Alto plastic alto sax reed
- [Suitable for] Alto saxophone reed set accessory is suitable for saxophone beginners. From beginners to professionals, from students to teachers, from classic..
- [Perfect Gift] Alto Sax Reeds Professional Reed is suitable for alto saxophone, easy to install and use. A nice gift for students, teachers, family children, a good and helpful accessory for saxophonists..
- [Quality Material] The clarinet saxophone reeds are made of high quality resin, safe, non-toxic, durable, with high corrosion resistance and moisture resistance, not easily affected by humidity change..
- [Good Choice] Our alto saxophone reed has a price that normal students can afford while having a warm and resilient voice..
- [Convenient to Use] No need to wet it before use, easy to use and convenient. Clarinet Reeds Comes in a pack of 3 pieces of reeds, enough for long term use..
- [Quality Material] The clarinet saxophone reeds are m....
Check Stock21 Pcs Alto Saxophone Mouthpiece Kit - Includes Metal Ligature 2.5 Reeds Cushions Pads and Plastic Cap
- 【Alto Sax Saxophone Metal Mouthpiece】- Designed for alto sax. Comes out with a pretty good sound. Made of up of metal Brass, have enough durable and solid. Saxophone 5C/ 6C/ 7C/ 8C Mouthpiece for you to choose..
- 【Sax Saxophone Mouthpiece】- 1. Comes with a metal cap to keep it clean and a metal buckle to fasten reed (The reed is not included).
- 2. Metal ligature offers secured holding of the reed,metal material ensures its longevity.
- 3. Design facilitates harmonics, streamline ensures player's comfort..
- 【Soprano Metal Sound Saxophone Mouthpiece & Alto Sax Tone】- The tone is brightly concentrated, supporting fast playing and continuous bright super treble overtones. Easy to obtain a balanced, clear, and focused tone in any octave, ideal for professionals and beginners..
- 【Ideal Gifts for Musical Lovers】- This Metal Alto Sax Saxophone Mouthpiece with Mouthpiece Patches Pads Cap Buckle Suitable for novice or professional saxophonists. also can be as a christmas or birthday gift for your Sax lovers..
- 【Package Includes】-1 x Saxophone Mouthpiece.
- Jazz Tenor Alto Sax Saxophone Mouthpiece with Cap and Ligature, Soprano Metal Sound Saxophone Mouthpiece Alto Sax Tone 5C/6C/7C/8C..
Check StockXstyle Trombone Marching Lyre ClampOn Silver Metal Plating Marching Music Clip Lyre for Saxophone
- Hold your music tightly and stably: these lyres for alto sax are available to fit your alto/ tenor saxophone nicely, which can keep stable when you play.
- And you just need to use the clamp to fix your music, easy to operate, and ready to provide you with nice use experience.
- In exquisite workmanship: made of stainless steel and applying metal plating, the band flip folder shows an elegant visual effect, coming with a delicate silver surface, not easy to wear your instrument itself, and can be inlaid into your instrument nicely, you can use them with confidence.
- Nice alto saxophone music combination: you will receive 2 pieces of alto saxophone lyres from the package, sufficient quantity to meet your daily uses and replacement needs, and you can also share with others.
- Portable and light in weight: each alto sax flip folder measures approx. 10 cm/ 3.94 inches in length, while the round mouth measures approx. 0.4 cm/ 0.16 inches in diameter, which is convenient for you to carry and use.
- Applicable occasion: adopting with round moth design, the tenor sax lyre is suitable for the saxophone with a circular interface, nice for being alto/ tenor saxophone marching music clip, please check your instrument model carefully.
Check Stock100PCS CD4053 CD4053B CD4053BE DIP-16 Analog Multiplexer IC
- It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
- The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
- Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
- This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
- Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
Check StockAnalog Multiplexer Single 8:1 ñ9 Volt 20 Volt 16-Pin Plastic DIP Tube
- The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
- It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
- Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
- Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
- This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
Check Stock650nm 660nm Adjusted Red Laser Line Dot Cross Laser Diode Module 3V-5.5V 100mW Laser Dot/Line/Cross Module Focusable 13mmx42mm with US Power Adapter and Heatsink
- Wavelength: 532nm, Output power: 95-120 mW.
- Operating voltage: DC 12V, Operating Current: 003c500mA.
- Reverse polarity protection: Yes, with automatic identification of positive and negative.
- Laser Module Size:74 x 30 x 30mm , Circuit Board size:71.5 x 35 x 20mm.
Check Stock20PCS CD4053 CD4053B CD4053BE DIP-16 Analog Multiplexer IC
- Process Digital Signals: Because the multiplexer can also process digital signals, you can use it to transfer TTL level serial data to multiple devices through pipe or transfer from multiple devices..
- High Level: Drive it to high level, and it will completely disconnect the common pins (all switches are disconnected)..
- Scope of Application: It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
- 16 Channel Analog Multiplexer: This is a very convenient 16 channel CD74HC4067 analog, digital multiplexer, demultiplexer..
- Bidirectional Internal Switch: With a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
Check StockGodox AD200 200Ws 2.4G TTL Speedlite Flash Strobe 1/8000 HSS Monolight with 2900mAh Lithium Battery and Bare Bulb Flash Head to Provide 500 Full Power Flashes Recycle in 0.01-2.1 Second
- Godox AD200 Pocket Flash Speedlite has tiny Body, Interchangeable bare bulb flash heads and speedlite flash head, fast recycle time up to 0.01-2.1s, fast duration up to 1/13000s, When using Godox 2.4G wireless X system. Godox AD200 Speedlite Monolight is compatible with Canon E-TTL, Nikon i-TTL and Sony TTL etc..
- 200Ws, GN60(m ISO 100, with AD-S2 standard reflector, @28mm) and GN52 (m ISO 10, @35mm). Stable color temperature at 5600 ± 200K over the entire power range. Professional lithium battery pack has large capacity(14.4v/2900mAh)to provide 500 full power flashes and 0.01-2.1s fast recycling.
- 8 steps of power adjustment (1/1~1/128)offer better light effects. Godox AD200 Speedlite Monolight is Fully support flash exposure compensation. 1/8000s high speed sync, first curtain sync, second curtain sync, modeling lamp(speedlite head only), manual flash, multi flash, C.Fn custom setting, etc..
- GODOX AD200 pocket Speedlite Monolight has strong power with lightweight and great portability. Easily packed in your pocket. With master slave function,Godox AD200 Speedlite Monolight can be Used in combination with Godot TTL camera flashes, TTL outdoor flashes, etc..
- Built-in Godox 2.4G wireless X system and fully support of TTL functions,Use Godox 2.4G wireless X....
Check StockAnalog Devices ADG509ATQ Analog Multiplexer
- 【16-channel Analog Multiplexer】- This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
- 【Used for】- It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
- 【Process Digital Signals】- Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
- 【Bidirectional Internal Switch】- The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent cross talk, please turn off the switch first and then on..
- 【Note】- Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected). Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering..
Check StockFOVERN1 Alto Sax Saxophone Plastic Mouthpiece with Cap Metal Buckle Reed Kit for Alto Saxophone Saxophone Parts
- Material: the alto saxophone mouthpiece cushion is made of good quality rubber, which will not harm to your health.
- It's a good accessory of saxophone and clarinet.
- Package contents: you will receive 4 sheets, each sheet has 8 pieces mouthpiece cushions, the size of alto mouthpiece pad is about 2.7 x 2 cm/ 1.06 x 0.78 inch, 0.8 mm in thickness.
- Adhesive: this soft rubber pad with adhesive, which allows the teeth firmly fixed to the mouthpiece without slipping, no residue/ adhesive will be left on the instrument while peeling off.
- Wide application: the alto mouthpiece pad can protect the saxophone flute head and protect the teeth of the players, which is a great accessory for alto/ tenor saxophones beginners and suitable for the alto saxophone, tenor saxophone, and clarinet.
- Tip: after using these mouthpiece pads, please place it in a ventilated area and avoid direct sunlight.
Check Stock