Top Flysky Red I3s

HOBBYMATE Flysky RC FS GT2B Radio Transmitter & FS GR3E Receiver, 3 Channel 2.4Ghz Radio Controller with Internal Rechargeable Transmitter Battery

  • The FLYSKY GT2B rc transmitter is setup for right handed use and allows quick changes to the steering and throttle trim dials, along with steering and throttle channel reversing and very useful steering dual rate dial at the tip of your fingertips..
  • FLYSKY FS-GT2B Radio Controller / Radio Transmitter with FS-GR3E Failsafe Receiver. 10 Models memory (non simultaneously)..
  • Works with most popular rc car, rc truck, crawlers, and rc boat.
  • The steering wheel has great response with the perfect amount of resistance and spring back to center perfectly. A rubber grip around the wheel ensure your fingers do not slip if they are covered in dirt or oil..
  • Powered by a 800mah 3.7v lithium battery for enhanced runtime and lighter weight..
Check Stock

Flysky FS-BS6 RC Receiver 6 Channels for Flysky FS-GT5 Rc Car Remote Controller Radio Transmitter with Gyro Stabilization System (3pcs)

  • Flysky FS-BS6 Receiver built with a gyroscope (switchable) that automatically recovers accidental drift and makes your control smarter Ultra-small and light, save the car space, reduce vehicle load.
  • 6 channel receiver Compatible with flysky RC Transmitter FS-GT2E,FS-GT2G,FS-GT2F,FS-IT4S,FS-GT5,FS-i4X,FS-i6,FS-i6X,FS-i6S,FS-TH9A,FS-TM10,FS-i8,FS-i10 transmitter.
  • FS-BS6 Receiver With Gyro Stabilization System, 20 models memory, for Rc Car, Rc Truck, Rc Crawlers and Rc Boat.
  • Have CRAWL function (climbing car mode), SVC function (smart car control mode), gyro stability function..
  • Have F.SAFE Function (Fail-Safe Protection),when the receiver can not receive the signal from the transmitter,F.SAFE Function (Fail-Safe Protection) can protect the safety of the model.
  • Easy to bind and very fast link-up, quick and extremely stable in performance.
Check Stock

Happymodel Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX (Frsky RX,19000KV)

  • Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
  • Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
  • Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
  • Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.
Check Stock

Flysky FS-NB4 2.4G 4CH Noble Radio Transmitter HVGA 3.5 inch TFT Color Touch Screen with Receiver FGR4 FGR4S Bidirectional 4-Way PPM/IBUS for RC Car/Boat

  • Build-in new FS-HF200 high frequency module, Support Online update with standard USB cable , more stable performance.
  • HVGA 3.5-inch TFT color screen, resolution 320 * 480, LCD white back light, capacities touch screen, superior look and feel.
  • The failsafe function is used to protect the model and user in case of signal loss..
  • Transmitter with 3.7V 4300mAh battery (built-in).
  • Flysky FGR4S Receiver FCC ID: N4ZFGRS4OO.
  • Type of antenna: built-in ( Note: the only receiver version have no Transmitter, Transmitter Version only come with -P receiver ).
Check Stock

HAPPYMODEL Updated Mobula6 HD 1S 65mm Brushless Quadcopter Whoop Mobula 6 HD FPV Racing Drone BNF with AIO 4IN1 Crazybee F4 Lite Runcam Split3-lite 1080P HD Camera (BNF Frsky RX)

  • Come with Runcam Split3-lite 1080P HD DVR?Max Micro SD Card Supported 64G(need Class 6 or above, recommend Class 10/UHS-I/UHS-II/UHS-III).
  • AIO 4IN1 Crazybee F4 Lite Flight Controller built-in 5.8G VTX.
  • Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode) ? Internal SPI Flysky version(Compatible with AFHDS and AFHDS-2A Flysky transmitter).
  • External DSM·2/DSM·X version(Compatible with DSM·2/X transmitters) ? External TBS CRSF NANO version(Compatible with TBS ransmitters).
  • Note:pre-order item,will be available in June 20th,before you pay,pls kindly know,(if you like this item,suggest that you can order first,first pay first send,you will get the item faster than others)thank you..
Check Stock

GoolRC Flysky FGr4S V2 Receiver, 2.4GHz 4CH AFHDS 3 Remote Control Receiver Built-in Single Antenna PWM/PPM/I-Bus Output Compatible with Flysky Noble FS-NB4 PL18 RC Transmitter for RC Car Boat

  • 2.4GHz 4 channel receiver is compatible with FlySky Noble FS-NB4 PL18 Transmitter, good for Rc Car and Rc Boat..
  • FGr4S adopts AFHDS 3, Flysky's third-generation automatic frequency hopping digital system. Easy to bind and very fast link-up, quick and extremely stable in performance..
  • It uses an internal single antenna with two-way transmission capabilities and is designed to be compact and easy to install..
  • The receiver supports PPM/i-bus/PWM data output, suitable for AFHDS3 system remote controller..
  • Ultra-small size and ultra-lightweight, effectively save space and reduce item's weight-bearing..
Check Stock

Happymodel Mobula6 Quadcopter Indoor Four-axis 1S 65mm Brushless Bwhoop Drone BNF AIO 4IN1 Crazybee F4 Lite Flight Controll Built-in 5.8G VTX Parts Without Remote Controller (25000KV Frsky RX)

  • Flight controller: (Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR.
  • (Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS.
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21.
  • Current: 5A continuous peak 6A (3 seconds).
  • OnboardFrsky SPI D8 receiver Version: SPI BUS receiver Frsky D8 compatible.
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m.
  • OnboardFlysky SPIreceiver Version: SPI BUS receiver.
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m.
Check Stock

Flysky FS-T6 6CH 2.4G LCD Transmitter with R6B Receiver for RC Helicopter Quadcopter Glider Airplane (Right Throttle（Mode 1)

  • Note : There are 2 models for chose: model 1 is Right throttle.
Check Stock

Flysky FS-GT3C 2.4GHz 3-Channel 3CH Surface Radio R/C RC Car/Boat Transmitter TX

  • FLYSKY GT3C Radio Controller and Receiver is designed for most of popular rc cars, rc truck, and rc boat, it will work with digital servo, and analog servos..
  • 2.4G Radio Controller Radio Transmitter & GR3E Receiver.
  • Comes with a rechargeable battery a USB charge cable..
Check Stock

Flysky FS-iA6B 6Ch Receiver 2.4G PPM Output with iBus Port Compatible Flysky i4 i6 i6X i10 Transmitter

  • Reliable, interference free 2.4GHz AFHDS2A signal operation.
  • Ultra light weight design for most RC cars, trucks and airplane.
  • 6 channels receiver compatible Flysky i4 i6 i10 transmitter.
  • Quick and extremely stable in performance,worth your choice.
Check Stock

4PCS RC Transmitter Stick Protector Protective Cover for Frsky X9D X7 Jumper T16 Flysky TH9X Spektrum

  • This protector can be used to protect the stick of your RC transmitter during transport..
  • The size of the center hole is proper to hold the stick without loosening.
  • It is suitable for nearly all brand radio transmitter like frsky X9D X7, flysky FSi6 FSi6X, Jumpter T16, Spektrum, Futaba, JR.
Check Stock

Bruni Screen Protector Compatible with Flysky FS-T6 Protector Film, Crystal Clear Protective Film (2X)

  • Accurately, specifically developed and compatible with FlySky FS-T6.
  • Made of scratch-resistant, highly transparent PET material and laser-cut on state-of-the-art machines.
  • This transparent Screen Protector can be applied easily and without bubbles, and can be removed or repositioned at any time.
  • No slipping - once attached, the glue-free Protective Film no longer moves - optimal edge adhesion guaranteed.
  • Optimized for use on touch displays - unadulterated display of the screen contents and no impairment of the usability with the Protector Film *** Made in Germany.
Check Stock