Top Frsky Taranis Case

SAUJNN Jumper T8SG Plus V2.0 Hall Gimbal OLED Display Advanced Multi-protocal Transmitter JR/FrSKY Compatible Module

  • High Quality Universal RC Controller Carrying Case Bag for Jumper WFLY RadioLink FrSky Transmitter.
  • Durable, portable and lightweight, fit for most RC radio transmitter, like Jumper T8SG Plus V3, T12 Pro,T16 Pro Hall V2, T18 T18 Pro, T18 Lite, WFLY WFT07, WFT09, ET07, WFT07, RadioLink AT9, AT9S, AT10 and FrSky X9D.
  • Two-way z1pper design and rubber handle , well protect your device from bumps dents and scratches.
  • High-density foam interior with pre-cut compartments for the transmitter and accessories.
  • Note: Some transmitter might require trimming of the foam insert to fit properly.
Check Stock

FrSky XM Plus Mini Receiver up to 16CH 1.6g Full Range fit for Micro Drone XM

  • Notes： Flash the internal RF module of the ACCST transmitter to V2 version, and then bind the XM+ RXSR receiver.This insanely tiny 2.4GHz diversity....
  • XM Plus Receiver supports failsage function for all channels. Protect your perfectly henever the control signal is lost for a period of time.
  • Up to 16CH from SBUS ( CH1-CH15 for PWM, CH16 RSSI for FC,such as F3, Naze32 flight controller ). Compatible ------ Compatible with Frsky X9D Plus X9E....
  • weight:1.6g, Dimension: 21.5*12*3.5mm(L x W x H).Frsky XM Plus mini receiver is perfect for those racers who are looking to lower their AUW,....
  • FrSky XM Plus is dual antenna ( Frsky XM is only one), with dual antenna, it has strong anti-interference, make sure you can control your drone....
Check Stock

Happymodel Mobula7 Quadcopter Indoor Four-axis 2S 75mm Brushless Whoop Racer Drone BNF---V2 Upgraded Frame (receiver for Frsky NON-EU Standard Version)

  • Option: Basic Version (comes with USB Lipo/LIHV Charger)//Standard Version(comes with 1S06 6 way Lipo/LIHV charger). Receiver option: Frsky Non-EU version support NON-EU Frsky transmitter D8/D16 compatible.
  • Flysky version support both AFHDS and AFHDS-2A protocol transmitter.
  • DSM2/DSMX version support DSM2 and DSMX compatible Spektrum transmitter.
  • Frsky EU-LBT version support Frsky EU-LBT firmware transmitter.
  • Item Name: Happymodel 2S 75mm Brushless Whoop racer drone BNF.
  • New Crazybee F3 PRO Flight controller 1-2s Lipo compatible.
  • 2S whoop more powerful and more flight time.
  • New 0802 Powerful and High efficiency Brushless motor and Smooth ESC.
  • Betaflight support , multi flight mode: ACRO/AIR/ANGLE.
  • Betaflight OSD support ,easy to get RSSI, Voltage ,current from your goggles(DSMX version no RSSI output).
  • Smartaudio ready , change VTX bands, channels via OSD (Adjust the settings and the PID of the flight controller via OSD).
Check Stock

The Drone Racing League

  • 2.Built  with the Frsky R-XSR receiver,so you can bind this drone to your Frsky radio controller.
  • 3.Pre-tuned and freestyle setup, everything you need is just bind-and-fly.
  • 4.This 5inch analog fpv drone design for professional pilot,Recommended: 1300mah 6s lipo battery..
  • 5.When you have any question,just write to us at first time,we will provide best customer service..
Check Stock

BETAFPV LiteRadio 1 Radio Transmitter with CC2500 System 8CH Remote Controller Support FPV Simulator Compatible for FPV Racing Drone Fly and FPV Beginners Teenagers - Frsky D8 Mode 2

  • ...e for adolescents or those who prefer to use mini radio transmitter. Also suitable for beginners to learn to fly drones, and a good choice as a gift to kids or friends. What is more, a more affordable opportunity for schools or training centers..
  • 【Support Simulator】Not only can bind quadcopters that are built in Frsky or Futaba receiver but also support USB joysticks mode, which means that beginners can learn and practice through simulators before they start a real flight. Support majority flying simulators like Liftoff, DRL/DCL, Uncreashed, Orqa FPV. More convenient for practicing and charging at the same time..
  • 【CC2500 System】Build in CC2500 2.4G system, it supports Futaba S-FHSS/Frsky FCC D16/Frsky LBT D16/Frsky D8 protocols, which are mainly used in the market. LiteRadio 1 Radio Transmitter is compatible with many BNF quadcopters with such receivers..
  • 【Spare Gimbals】Two grip styles for pilots, LiteRadio 1 Radio Transmitter comes with thumb stick ends out of the factory, which features a flat surface and larger space to be able to roll thumbs around. Besides, we prepare two pinch stick ends in the package for those who like to control between fingers and thumbs..
  • 【BETAFPV Configurator】BETAFPV Configurator supported, you can adjust the ....
Check Stock

HAPPYMODEL Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX RC Toy Gift (25000KV Frsky)

  • Flight Controller: (Frsky SPI RX Version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR.
  • (Flysky SPI RX Version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS.
  • Receiver Option: Internal SPI Frsky Version (Compatible with ACCST D8/D16, Recommend Non EU transmitter D8 mode).
  • Internal SPI Flysky version(Compatible with AFHDS 8CH and AFHDS-2A 14CH Flysky transmitter).
  • Motor Speed Option: SE0802 KV25000(Race Edition).
  • Onboard 4in1 ESC : Support BLHeliSuite Programmable.
  • AIO 4IN1 Crazybee F4 Lite Flight Controller built-in 5.8G VTX.
  • Extreme Light 1S 65mm Brushless Whoop only 20g.
  • Runcam Nano3 The Lightest 1/3 CMOS 800TVL Camera.
Check Stock

BETAFPV F4 1S Brushed Flight Controller with SPI Frsky D8 Receiver Support OSD Customized RGB Lights with 55mm BT2.0 Connector Power Cable Compatible for 1S Brushed Drone Like Beta65S

  • 【Upgrade】Classical BETAFPV F4 1S brushed flight controller V2.0 comes back with a new cross particular shape, and it adopts BT2.0 connector cable instead of BT2.0. It is compatible with Beta65S 1S brushed whoop drone..
  • 【Protocol】Build-in CC2500 chip, the default protocol is configured to Frsky D8 out of the factory and can be adjusted to  Frsky D16 FCC, Frsky D16 LBT, or Futaba. Pilots could set up the protocol according to their needs in Betaflight Configurator..
  • 【Cable】The power cable applies BT2.0 connector instead of PH2.0, which solves the problem of voltage sag, and the discharge can be more efficient, bringing this board a better performance on function for power and responsiveness..
  • 【RGB】It supports custom RGB lights on the Betaflight configuration, you can DIY it by your hobby, which makes your drone unique from others..
  • 【Support】Firmware and Cli Dump file for F4 Brushed Flight Controller, some basic guidance and typical FAQ, please visit our official website..
Check Stock

HAPPYMODEL Mobula6 1S 65mm Brushless Drone Mobula 6 RTF 19000KV Frsky Version with LiteRadio 2 Radio Transmitter Mode 2 19000KV Motors

  • Receiver option: Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode).
  • Motor speed option: SE0802 KV19000(Regular Edition).
  • Extreme light 1S 65mm Brushless whoop only 20g , Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera.
  • 8CH Remote Controller System: Bayang Protocol / Frsky Protocol.
  • Controller LED Light: Green-Power On / Red-Warning / Blue-Normal.
Check Stock

HAPPYMODEL Mobula6 HD 1S 65mm Brushless Quadcopter Mobula 6 HD FPV Racing Drone RTF Frsky Version with LiteRadio 2 Radio Transmitter Mode 2

  • Receiver option: Internal SPI Frsky version (Compatible with ACCST D8/D16, Recommend D8 mode).
  • Mobula6 HD Come with Runcam Split3-lite 1080P HD DVR , Extreme light 1S 65mm Brushless HD only 27g.
  • LiteRadio 2 Radio Transmitter System: Bayang Protocol / Frsky Protocol.
  • Transmitter LED Light: Green-Power On / Red-Warning / Blue-Normal.
  • Package include: Mobula6 HD + LiteRadio 2 Radio Transmitter ( Mode 2 ).
Check Stock

Happymodel Mobula6 Quadcopter Indoor Four-axis 1S 65mm Brushless Bwhoop Drone BNF AIO 4IN1 Crazybee F4 Lite Flight Controll Built-in 5.8G VTX Parts Without Remote Controller (25000KV Frsky RX)

  • Flight controller: (Frsky SPI RX version) CRAZYBEE F4 Lite Frsky version Firmware target: CrazybeeF4FR.
  • (Flysky SPI RX version) CRAZYBEE F4 Lite Flysky version Firmware target: CrazybeeF4FS.
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21.
  • Current: 5A continuous peak 6A (3 seconds).
  • OnboardFrsky SPI D8 receiver Version: SPI BUS receiver Frsky D8 compatible.
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m.
  • OnboardFlysky SPIreceiver Version: SPI BUS receiver.
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m.
Check Stock

Happymodel Mobula6 1S 65mm Brushless Whoop Drone Mobula 6 BNF AIO 4IN1 Crazybee F4 Lite Flight Controller Built-in 5.8G VTX (Frsky RX,19000KV)

  • Flight controller: CRAZYBEE F4 Lite Firmware target: Frsky SPI RX version is CrazybeeF4FR.
  • Flysky version is Crazybee F4FS. Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready. Built-in Betaflight OSD(SPI Control). Built-in 5.8G VTX. Built-in SPI Frsky/Flysky receiver. Built-in 5V 1A BEC. Built-in voltage detection..
  • Onboard 4in1 ESC: MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_7.HEX Default protocol: DSHOT600.
  • Runcam Nano3: Horizontal Resolution: 800TVL Lens : 2.1mm(M8) FOV 160° Signal System: PAL/NTSC Non Switchable Day/Night: Color.
  • Onboard 5.8g 40-CH 25mw VTX: Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels Smartaudio ready.
Check Stock

FrSky Taranis X9D Plus 2019 ACCST D16 /Access Telemetry Radio Open TX for FPV (Silver)

  • Compatibility: ACCST D16 and ACCESS receivers Communication ProtocolACCST D16 /ACCESS Feel Free to Choose.
  • Classic Taranis form factor design Easy launch momentary button.
  • Program navigation button High-speed module digital interface.
  • Installed with ACCESS protocol Supports spectrum analyzer function.
  • Supports SWR indicator warning G9D potentiometer gimbal Supports wired training function.
Check Stock