Top Fsk Receiver Module - BuyWiseBest.com

Drone Racing League: 2017 eSports Tryouts

...ke other versions of LiteRadio 2, which can act as a USB Joystick when connected to a personal computer, suitable for FPV novices to play FPV simulators like EREADRONE.
【About Bind】The stock firmware of the TX module manufactured by our company is ELRS V1.0.0-RC5(the fifth release candidate version) and the Lite receiver and Micro TX Module is V1.1.0.
Please note that the firmware version of the Transmitter and the receiver or the TX module should be the same one and then could be bound together. If you don't know the firmware version, please contact us directly and we will solve the problem for you..

3 x Transmitter module (433MHz) & 3 x Receiver module(433Mhz).
These modules are used for projects when you need to communicate wirelessly between 2 devices.
It is possible to increase the range by adding a small length of cable which the device will use as an aerial..
VCC voltage module operating voltage and good power filtering.
Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high pressure, and interference source.

EASYGUARD FSK technology top quality integrated Smart key RFID PKE(Passive Keyless Entry) Car Alarm system with remote start, push start button and shock alarm warning..
Main feature is PKE, remote engine start stop, push start stop button and backup touch password entry, shock warning etc.
The default spare key blade may not fit for your car, please replace it in the local locksmith to fit for your car.
can work with manual transmission car or automatic transmission car & 95% petrol cars on the market.
professional car alarm installer installation is required.
An extra bypass module (like ASIN: B00MEHBVIC or B07NSLPBG7) is required If there is a chip immobiliser in your factory OEM key fob..

Jewel cube satellite speakers are sleek and compact, and create dynamic surround sound.
Dimensions (”): Console – 15.98 W x 2.56 H x 10.16 D | Jewel Side speakers (each) – 2.6 W x 6.2 H x 2.6 L | Jewel Center speaker – 6.1 W x 2.7 H x 2.6 L | Bass module – 12 W x 12 H x 12 L.
As main components, your purchase include: One Console, 4 OnmiJewel side speakers, One OmniJewel center speaker, One Acoustimass wireless bass module, universal remote control, 2 wireless receivers, One ADAPTiQ headset and Owner’s guide.
Front and center speakers have a wired connection, while the 2-rear speakers connect to a wireless receiver and AC power mains. The rear speakers and bass module connect to the front module wirelessly.
Supported Audio formats – Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS, Multichannel PCM. Video Source compatibility – Support for six 4K/60 video sources (HDMI 2.0/HDCP 2.2).

The power supply method is not to take power from the receiver, battery used is greater than 2S and the voltage is between 7‑28V, need to use a step‑down module to make the operation more stable..
Suitable for installation on remote control boats that require water cooling with water‑cooled motors and without water‑absorbing steering gear.
Put it to work normally, the temperature will be hot, but it belongs to the normal range and will not affect the use..
Under the condition of 5V voltage, the pump works continuously for 15 hours and pumps water continuously..
It is waterproof and works well in water, JR plug suitable for plug into the receiver, plug and play..

The Happymodel 2.4GHz ELRS nano series receiver is an open source program based on ExpressLRS, we have 3 types rx module released..
On the basis of PP RX, we have developed the Nano 2.4GHz rx of ESP8285 version named EP1 and EP2. The RF module of EP1/EP2 is the same like PP RX and....
Due to the low-latency and high-refresh-rate RF module, they are very comfortable for FPV race and Long Range FPV. And very suitable for Tiny whoop....

This ir transmitter sensor module is directly launched by a single tube, it requires waveform modulation through the program..
It is suitable for infrared communication, infrared remote control, apply to a variety of platforms including for Arduino/51/AVR/ARM.
With signal indicating LED, easy to observe and debug..
Pin Definitions: (1) Output (2) Vcc (3) GND.
IR Infrared Transmitter Module Ir Digital 38khz Infrared Receiver Sensor Module For Arduino Electronic Building Block.

ADK (DIY Soldering Kit) for EverSet ES100 WWVB-BPSK Atomic Clock Receiver IC.
Hardware is compatible with Arduino - Atmega328P with Arduino Bootloader.
Includes all Parts to build the kit as shown in the Pictures - including 1x ES100-MOD Receiver Module and 1x ES100-MOD Carrier Board.
For Demo Program, Libraries, Documentation etc. see Manufacturer's Website.

...otor (5V) -Motor driver module for stepper motor ULN2003.
5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
-10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
- Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.