Top Header Wire

Moroso WIRE SET,ULTRA 40,SLEEVED,BBC,BLACK 73819

  • Ultra 40 Custom Fit Wire Set, Black Wire, Sleeved, BBC, Over VC/HEI.
  • 8. 65mm diameter wire with 40 ohms of resistance per foot.
  • Sleeving adds extra dielectric strength which is wire’s ability to not be affected by outside electrical pulses.
  • Sleeving extends spark plug wire life and protects against exhaust header heat, chaffing and contaminants.
  • Complete, ready to install sets available for specific engines.
Check Stock

Moroso 72550 Blue Max Spark Plug Wires, AMC V8, GM V8

  • Ultra 40 Custom Fit Wire Set, Blue Wire, Sleeved, Ford 429-460 HEI.
  • 8. 65mm diameter wire with 40 ohms of resistance per foot.
  • Sleeving adds extra dielectric strength which is wire’s ability to not be affected by outside electrical pulses.
  • Sleeving extends spark plug wire life and protects against exhaust header heat, chaffing and contaminants.
  • Complete, ready to install sets available for specific engines.
Check Stock

CZH-LABS DIN Rail Mount DSUB DB50 Male/Female Header Interface Module D-SUB Breakout Board.

  • Standard DB50 Male/Female header connectors. Male header, female header and screw terminal 1:1:1 connects for per line..
  • Rated voltage: 60V. Rated current: 1A / per pin. Operating Temperature: -20ºC to 50ºC.
  • Terminal block: Pitch 3.81mm/0.15" miniaturization screw terminal block. Wire range - 26-16AWG. Strip length - 5mm. Screws - M2,steel,Cr3+ Zn plated.....
  • FR-4 fiber glass PCB, dual copper layers..
  • High quality fireproof nylon material DIN rail mount carrier (not China low quality carrier), can support width 35mm / 32mm / 15mm rail, and the....
Check Stock

Moroso 72000 IGNITION WIRE SLEEVE, INSULATED, BLUE, 8MM

  • Available in Black, Blue and Red Closely woven fiberglass impregnated with high voltage, leak resistant silicone which adds up to 8,000 volts of extra insulation Extend spark plug wire life by adding insulation against exhaust header heat For best results, we recommend that the sleeve cover the full length of wire from spark plug boot to distributor boot and sealed with Shrink Sleeve No. 72030 or No. 72031 Nos. 72000, 72002, 72004 fits 7 & 8mm wire.
  • Nos. 72011, 72012, 72013 fits 8.65mm Ultra 40 Wire Packaged in 25' lengths.
Check Stock

Electronics-Salon Screw Terminal Block Breakout Module, for Arduino MEGA-2560 R3.

  • Terminal Block Breakout Module - for Arduino MEGA-2560 R3. the item has been soldered and assembled..
  • Terminal block pitch 3.5mm/0.138", wire size range 26AWG to 16AWG, strip length 5mm, screw M2 steel, pin header and cage copper..
  • With power on LED indicating. red reset button on the side. with a ICSP adapter connect header..
  • FR-4 fiber glass PCB, dual copper layers..
  • NOTE: the item not include Arduino Mega module.
Check Stock

Rocketek 9pin USB Header Male 1 to 4 Female Extension Card USB 2.0 Splitter Cable Connector for Motherboard Adapter Port Multiplier for CPU WiFi Receiver Fans and RGB Light …

  • ✔ Motherboard USB header splitter 1 to 4 ports Hub, wire belt shielding.
  • ✔9 Pin USB Header for PC motherboard Can Prevent short circuit outlet design. motherboard USB splitter can prevent accidental removal of circuit....
  • ✔ USB Splitter Convert motherboard USB 2.0 Female to 4 Females. High-quality electronic components.
  • ✔ 30cm 9 pin USB Header Male 1 to 4 and hub connecting.
  • ✔ Self-Stick 9 pin Motherboard USB Splitter for easy installation, automotive adhesive tape is attached on the back, can be directly fixed on the....
Check Stock

upHere 3-Pack High Airflow Quiet Edition White LED Case Fan pwm 4in for PC Cases T4WT4-3

  • PC fan splitter Y cable connects 2 computer case fans to a single motherboard fan header.
  • 1 to 2 case fan splitter connects an additional fan to....
  • Mobo 4 pin fan splitter connects to the 4-Pin header on the motherboard and splits the signal to 2 PWM fans.
  • Fans can spin at the same speed using....
  • Master / slave PWM splitter has a 4 pin fan connector a wire that sends the RPM signal to the motherboard connector for synchronizing the fan speed....
  • Double CPU fan splitter adds 4 fans with the Cost-effective 2-pack of fan header splitter.
  • Sleeved and wrapped black 4-inch PWM Y cable provides a....
  • 3-pin & 4-pin fan compatible with popular brands of computer case cooling fans Corsair Air Series AF120 80mm / Series AF140 High Airflow, Cooler....
Check Stock

Stark Thermal Wrap 1\ Wide x 50' Long - Fiberglass Heat Shield Exhaust Manifold/Header Wrap - Yellow

  • Reduce up to 90% Radiant Heat - helps shield fuel lines, brake lines, wire looms and more from radiant heat.
  • Rated for 1350°F continuous, 2000°F intermittent. Always wear safety glasses, dust mask, gloves and long sleeves are recommended when handling this exhaust header wrap.
  • Fiberglass exhaust header wrap can create more horsepower and reduce under hood temperatures.
  • 1/16" x 1" x 50' Roll fiberglass exhaust heat wrap wiht 11-3/4" stainless ties (pack of 5).
  • Special weave makes it easier to wrap around bends, and gives carbon fiber look..
Check Stock

Stark Thermal Wrap 2\ Wide x 50' Long - Fiberglass Heat Shield Exhaust Manifold/Header Wrap - Yellow

  • Reduce up to 90% Radiant Heat - helps shield fuel lines, brake lines, wire looms and more from radiant heat.
  • Rated for 1350°F continuous, 2000°F intermittent. Always wear safety glasses, dust mask, gloves and long sleeves are recommended when handling this exhaust header wrap.
  • Fiberglass exhaust header wrap can create more horsepower and reduce under hood temperatures.
  • 1/16" x 2" x 50' Roll fiberglass exhaust heat wrap wiht 11-3/4" stainless ties (pack of 5).
  • Special weave makes it easier to wrap around bends, and gives carbon fiber look..
Check Stock

Cable Matters 2-Pack 2 Way 4 Pin PWM Fan Splitter Cable - 4 Inches

  • PC fan splitter Y cable connects 2 computer case fans to a single motherboard fan header.
  • 1 to 2 case fan splitter connects an additional fan to increase airflow in your computer case.
  • Mobo 4 pin fan splitter connects to the 4-Pin header on the motherboard and splits the signal to 2 PWM fans.
  • Fans can spin at the same speed using software from a motherboard equipped with PWM control.
  • Master / slave PWM splitter has a 4 pin fan connector a wire that sends the RPM signal to the motherboard connector for synchronizing the fan speed with the other fan.
  • The computer fan splitter omits the RPM signal pin for tandem fan speeds with both fans.
  • Double CPU fan splitter adds 4 fans with the Cost-effective 2-pack of fan header splitter.
  • Sleeved and wrapped black 4-inch PWM Y cable provides a tidy look in an open computer case.
  • 3-pin & 4-pin fan compatible with popular brands of computer case cooling fans Corsair Air Series AF120 80mm / Series AF140 High Airflow, Cooler Master Blade Master 80 / Master 92, Cooler Master Hyper 212 EVO 120mm, Cooler Master JetFlo 120mm, Cooler Master SickleFlow 120mm, Cooler Master MegaFlow 200mm, Noctua NF-F12, Thermaltake WATER 3.0 Dual 240.
Check Stock

Ultra-Small RPi GPIO Terminal Block Breakout Board Module, for Raspberry Pi

  • The item has been soldered and assembled. Support for Raspberry Pi 1 Model B+, Pi 2 Model B, Pi 3 Model B, Pi 3 Model B+, Pi 4 Model B, Pi Zero, Pi Zero-W..
  • Terminal block pitch 2.54mm/0.1", wire size range 28AWG to 18AWG, strip length 4.5mm, screw M1.6 steel, pin header and cage copper..
  • FR-4 fiber glass PCB, dual copper layers..
  • 2x20 positions header connect to Raspberry Pi board..
  • Packing list: 1x terminal block breakout module, 4x M2.5x6mm screws, 4x 10mm nylon standoffs. 2x 11.5mm brass standoffs, 1x small slotted screwdriver (NOTE: the item not include Raspberry Pi Board)..
Check Stock

Moroso 73617 Ultra 40 Sleeved Wire Set in Blue, Fits Big Block Chevy, 90 Degree Plug Ends, Non HEI Distributor, Under Header Routing

  • Available in Black, Blue and Red Closely woven fiberglass impregnated with high voltage, leak resistant silicone which adds up to 8,000 volts of extra insulation Extend spark plug wire life by adding insulation against exhaust header heat For best results, we recommend that the sleeve cover the full length of wire from spark plug boot to distributor boot and sealed with Shrink Sleeve No. 72030 or No. 72031 Nos. 72000, 72002, 72004 fits 7 & 8mm wire.
  • Nos. 72011, 72012, 72013 fits 8.65mm Ultra 40 Wire Packaged in 25' lengths.
Check Stock