Top High Input output Voltage Differential

Texas Instruments LM358P Low Power Dual OP Amplifier, General Purpose, 8-Pin, -16-32 Volt, 9.81 mm L x 6.35 mm W x 4.57 mm H (Pack of 15)

  • Four independent voltage comparators that are designed to operate from a single power supply over a wide range of voltages.
  • Wide Supply Ranges Single Supply: 2 V to 36 V, Dual Supplies: ±1 V to ±18 V, Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±36 V, Low Input Offset Current: 3 nA (Typical).
  • Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typical), Low Output Saturation Voltage, Common-Mode Input Voltage Range Includes Ground.
  • Low Input Bias Current: 25 nA (Typical), Low Input Offset Voltage: 2 mV (Typical), Low Output Saturation Voltage.
  • Example Applications: Industrial, Automotive: Infotainment and Clusters, Body Control Modules, Power Supervision, Oscillators, Peak Detectors, Logic, Voltage Translation.
Check Stock

Juried Engineering TL072CP TL072 IC JFET Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 5)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (1 Piece)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL081CP TL081 High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-8 (Pack of 10)

  • The TL081CP JFET-input operational amplifier family is designed to offer a wider selection than any previously developed operational amplifier family. Each of these JFET-input operational amplifiers incorporates well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit..
  • Low Power Consumption: 1.4 mA/ch Typical, Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL074CN TL074 Quad Low-Noise JFET-Input Operational Amplifier Breadboard-Friendly IC DIP-14 (1 Piece)

  • The TL074 Quad JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit.
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Bridgold 10pcs LM339 339 Quad Differential Comparator ICS for High Voltage Digital Logic Gate Circuit, DIP14

  • Wide common mode input voltage range, Vic=0～Vcc-1.5V.
  • Input offset voltage is small, VIO=±2mV.
  • The differential input voltage range is very large, even equal to vcc.
  • The output is compatible with TTL, DTL, MOS, CMOS, etc..
Check Stock

Micsig 700V 100MHz High Voltage Differential Probe kit 3.5ns Rise Time 10X/100X Attenuation Rate Oscilloscope Probe Kit Accessory DP10007

  • Widely Used: The attenuation rate is 10X/100X, widely used in any brand of oscilloscope..
  • Maximum differential test voltage (DC+ACPK-PK): 70V (10X), 700V (100X). You can safely measure floating voltages up to 700V and have a bandwidth up to 100 MHz..
  • Easier and Safer Use: High voltage differential probes sample high impedance isolation between input and output to protect person safety. Power supply USB DC 5V output, more portable while Oscilloscope has USB interface..
  • Versatile Kit: All 6 pieces with three different connectors help to test various on different occasions, including 2 alligator clips, 2 hook clips and 2 pincer clips..
  • Applications: Floating Measurements, Switch-Mode Power Supply (SMPS), Motor Drive Design, Power Device Testing & Evaluation, Power Converter Testing & Design..
Check Stock

Juried Engineering TL072CP IC Dual Low-Noise JFET-Input Operational Amplifier & 8-Pin DIP Sockets with Machined Contact Pins Breadboard-Friendly (Pack of 10)

  • The TL072 JFET-input operational amplifiers incorporate well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low-input bias and offset currents, and low offset-voltage temperature coefficient..
  • Low Power Consumption, Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock

Juried Engineering TL064CN TL064 Quad Low-Power JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-14 (Pack of 5)

  • Typical Supply Current: 200 µA (Per Amplifier), Latch-Up-Free Operation, High Slew Rate: 3.5 V/µs Typical.
  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Common-Mode Input Voltage Range Includes VCC+, Output Short-Circuit Protection.
  • High Input Impedance: JFET-Input Stage, Internal Frequency Compensation.
Check Stock

Bridgold 20pcs TL082 082 Linear Integrated Circuit General Purpose Dual J-FET Operational Amplifier，DIP-8

  • Wide Common-Mode and Differential Voltage Ranges.
Check Stock

Juried Engineering TL084CN TL084 Quad High Slew Rate JFET-Input Operational Amplifier Op-Amp IC Breadboard-Friendly DIP-14 (Pack of 10)

  • Low Power Consumption: 1.4 mA/ch Typical.
  • Low Input Bias Current: 30 pA, Typical Low Input Offset Current: 5 pA Typical, High Slew Rate: 13 V/μs Typical.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% Typical, Wide Common-Mode and Differential Voltage Ranges, Common-Mode Input Voltage Range Includes VCC+.
  • High Input Impedance: JFET Input Stage, Latch-Up-Free Operation.
  • Example Applications: Tablets, White goods, Personal electronics, Computers.
Check Stock

Juried Engineering TL072IP TL072 Dual Low-Noise JFET-Input Operational Amplifier Op Amp Breadboard-Friendly IC DIP-8 (1 Piece)

  • Wide Common-Mode and Differential Voltage Ranges, Low Input Bias and Offset Currents.
  • Output Short-Circuit Protection, Low Total Harmonic Distortion: 0.003% (Typical), Low Noise Vn = 18 nV/√Hz (Typical) at f = 1 kHz.
  • High-Input Impedance: JFET Input Stage, Internal Frequency Compensation, Latch-Up-Free Operation.
  • High Slew Rate: 13 V/µs (Typical), Common-Mode Input Voltage Range Includes VCC+, Example Applications: Motor Integrated Systems: UPS, Drives and Control Solutions: AC Inverter and VF Drives, Renewables: Solar Inverters, Pro Audio Mixers, DLP Front Projection System, Oscilloscopes.
Check Stock