Top High Voltage Differential Probe

Extech MO290 – Pinless Moisture Meter and Ir Thermometer

  • Programmable high/low moisture and humidity alarms.
  • Automatic calculation of differential temperature to determine condensation point.
  • Non-contact infrared thermometer with 8:1 distance to spot ratio and 0.95 fixed emissivity.
  • Easy to read, large dual display with a back light feature.
  • Pinless measurement depth to 0.75 inch below the surface, Remote pin-type probe for contact moisture readings 3 feet cable length.
Check Stock

Dixell XR60CX-5N1C1 Digital Thermostat Controller with Defrost Compressor Control of Evaporator Fans 230V/50-60Hz Programmable-Commercial for Refrigeration

  • The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again.In case of fault in the thermostat probe the start and stop of the compressor are timed through parameters COn and COF..
  • Two defrost modes are available through the tdF parameter:defrost through electrical heater (tdF= EL) and hot gas defrost (tdF = in).Other parameters are used to control the interval between defrost cycles (IdF), its maximum length (MdF) and two defrost modes: timed or controlled by the evaporator?s probe (P2P).At the end of defrost dripping time is started, its length is set in the FSt parameter. With FSt =0 the dripping time is disabled..
  • Forced activation of fans This function managed by the Fct parameter is designed to avoid short cycles of fans, that could happen when the controller is switched on or after a defrost, when the room air warms the evaporator. Functioning: if the difference of temperature between the evaporator and the room probes is more than the value of the Fct parameter, the fans are switched on. With Fct=0 t....
Check Stock

Micsig DP10013 High Voltage Differential Probe 1300V 100MHz 3.5ns Rise Time 50X/500X Attenuation, Tektronix P5200A P5205A P5210A

  • Lightweight and portable, easy to carry..
  • Designed for the measurement of high voltage differential signal, to meet the demand for floating measurement..
  • Power supply USB DC 5V output, more portable while Oscilloscope has USB interface..
  • Simple design, it is easy and safe to use..
  • Maximum differential test voltage (DC+ACPK-PK): 130V (50X), 1300V (500X).
Check Stock

Non-Contact Voltage Tester Pen - Dual Range AC Voltage Tester 12V/48V-1000V, Live/Null Wire Circuit Detection Tester Breakpoint Finder Electrical Outlet Voltage Detector, Measure AC Circuit Tester

  • Safety and Security: Non-contact voltage tester has passed the CE CAT III 1000V CAT IV 600V test certification. When the ac electrical tester pen detects a voltage, the probe will flash red and beep, the higher the detected voltage, or the closer it is to the voltage source, the dual range voltage detector will beep at a higher frequency. The ac socket tester detects low voltage and neutral and triggers a yellow flashing light, and detects high voltage and live wire triggers a red flashing light.
  • Non-Contact: The ac circuit tester uses a non-contact method to measure voltage, with an NCV induction probe for detecting ac voltage, you only need to place the tip of an electric circuit detector near an outlet or power cord to detect the presence of voltage.The dual range circuit voltage tester is a safe double insulation, you don't have to worry about being shocked, voltage detector tool is very safe, and it is an ideal device to help determine the neutral or live line and breakpoint testing.
  • Dual Range: The electrical current tester detects standard voltage and low voltage ranges (12-1000V AC / 48-1000V AC), making the measurement more flexible and accurate. NCV sensitivity is automatically adjusted from low to high, low sensitivity can detect doorbells, ....
Check Stock

COOPER Cooper-Atkins SRH77A-E 1 and 2 Zone Temperature/Humidity Thermistor Instrument with 1075 General Purpose Puncture Probe, 4011 Pipe Strap Probe and 5028 Humidity Probe, -40°F to 300°F Temperature Range

  • Measures temperature differential between two zones, relative humidity, and wet bulb temperature.
  • Temperature range is -40 to +300 degrees F/-40 to +150 degrees C with + or - 0.3 or 0.5% accuracy.
  • Humidity range is 10 to 95% RH (90% RH non-condensing) with 0.1 degree or 1% resolution.
  • Sealed keypad protects the instrument from dust and moisture.
  • Includes humidity/thermistor instrument, puncture probe, pipe strap probe, humidity probe, and hard-sided carrying case.Battery Life:90 hours.
Check Stock

Micsig 700V 100MHz High Voltage Differential Probe kit 3.5ns Rise Time 10X/100X Attenuation Rate Oscilloscope Probe Kit Accessory DP10007

  • Widely Used: The attenuation rate is 10X/100X, widely used in any brand of oscilloscope..
  • Maximum differential test voltage (DC+ACPK-PK): 70V (10X), 700V (100X). You can safely measure floating voltages up to 700V and have a bandwidth up to 100 MHz..
  • Easier and Safer Use: High voltage differential probes sample high impedance isolation between input and output to protect person safety. Power supply USB DC 5V output, more portable while Oscilloscope has USB interface..
  • Versatile Kit: All 6 pieces with three different connectors help to test various on different occasions, including 2 alligator clips, 2 hook clips and 2 pincer clips..
  • Applications: Floating Measurements, Switch-Mode Power Supply (SMPS), Motor Drive Design, Power Device Testing & Evaluation, Power Converter Testing & Design..
Check Stock

Non-Contact Voltage Tester with Adjustable Sensitivity, LCD Display, LED Flashlight, Buzzer Alarm, Dual Range 12V-1000V/48V-1000V & Live/Null Wire Judgment - Tacklife VT02

  • Please press the power button for 2 seconds to switch it on.
  • ▲Non-Contact & Safe Voltage Tester – Testing can be achieved without physical contact for its NCV Inductive Probe.
  • Insulation operation ensures the safety of testing.
  • In testing AC voltage, it can automatically detect the live wire or null wire.
  • In the vicinity of the voltage to be tested, the pen will give an alarming sound；Safety Compliance：CAT.III 1000V CAT.IV 600V；CE.
  • ▲Adjustable Sensitivity & Dual Range Testing – Adjustable sensitivity makes its measurement more sensitive and flexible.
  • The Voltage Tester Pen has the dual testing range, you can adjust the sensitivity according to your needs(12-1000V AC or 48-1000V AC).
  • Automatic Recognition of Voltage Intensity.
  • In using, the NVC sensor of probe can automatically identify the voltage and display it on the LCD screen, simple and clear.
  • ▲High Definition LCD Screen & Low Battery Indicator – When testing the voltage, the brightness bar on the screen will tell you the voltage intensity.
  • The screen will light up in red or green to distinguish the Live/Null Wire.
  • When the battery voltage drops to less than 2.5 V, the flashlight of LED display reminds you to repl....
Check Stock

CMTOOL Power Circuit Probe Kit 9-30V Automotive Circuit Tester, Test Light Automotive Relay Tester Kit, Car Electrical Tester Digital Voltage Tester Continuity Tester Tool with 6m/20ft Extension Cable

  • ...pplications】Continuity Test, Signal Circuit Test, Activate Components in You Hand/Vehicle/W/Ground, Check for Bad Ground Contacts, Follow&Locate Short Circuits, Trailer Lights and Connection Test..
  • 2.【Power Circuit Probe Tester with Fast Intelligent Test】Automotive circuit tester can automatically identify the voltage value, resistance value, and positive and negative polarity of the detected circuit (red light is positive, green light is negative)..
  • 3.【Automotive Circuit Tester with Digital Multimeter Mode】Automotive circuit tester contains the common parameters of multimeters, and can quickly test the DC voltage, resistance, and diode in the circuit system, current, and frequency, bringing a lot of convenience to users..
  • 4.【Electrical Tester with Oscilloscope Function】Circuit probe tester with 6M extension test lead, can display the parameter curve diagram of the tested component, such as voltage, frequency, time, etc. Users also can observe the test results more directly by adjusting the displayed interval..
  • 5.【Power Circuit Tester Kit with Component Activation Function】There is 4 activation modes for the component activation function of the automotive probe tester, which can generate "activation" signals for components, such as ligh....
Check Stock

REED Instruments R2450SD Data Logging Thermometer

  • Displays up to 4 separate measurements simultaneously.
  • Accepts Type K, J , R, S, E, T thermocouples and RTD probes.
  • Temperature differential (T1-T2), Max/Min and Data hold functions.
  • User selectable °C, °F, Real-time data logger with integrated SD memory card.
  • Includes: Data Logging Thermometer, Beaded Wire Probe, Soft Carrying Case, & Batteries.
Check Stock

Honeywell L8148A1017 Immersion-Type Controller

  • Includes transformer to provide power for the low voltage control circuit.
  • Operating Range, High Limit: 140F to 240F.
Check Stock

Infrared Thermometer SOVARCATE Digital IR Laser Thermometer Temperature Gun High and Low Temperature Alarm -58°F~1112°F / -50℃～600℃ Temperature Probe for Cooking/BBQ/Food/Fridge/Pizza Oven/Engine

  • [AUTO OFF FUNCTION] You can save the battery energy by its automatic power off function after 10min of no measurement. On the other hand, user can also select to disable the auto power off function as needed during the measurement procedure..
  • [TEMPERATURE DIFFERENTIAL MEASUREMENT T1-T2] This thermometer not only features with Data Hold, Max/Min/Avg measurement function, but also "T1-T2 / T2-T1" calculation function. Just simply long press the T1-T / T2-T1 key to display the difference in temperature between probe 1 and probe 2..
Check Stock

Ultrasonic Distance Sensor, diymore Integrated Ultrasonic Waterproof Measuring Transducer Module with 2.5M Probe for Horizontal Distance Messurement Obstacle Avoidance Automatic Control

  • 2PCS integrated ultrasonic distance sensor with 2.5M probe, with a variety of modes that can be modified manually. Suitable for testing and teaching experiments in different occasions.
  • 【Basic Parameters】Working voltage:DC 5V.
  • 【Most Features】Small size, easy to use, strong anti-jamming,high accuracy,low voltage and low power consumption.
  • 【With 2.5M Transducer Probe 】Integrated enclosed waterproof probe, suitable for wet and harsh measuring fields. Please note that the device is waterproof, but it couldn't work underwater.
  • 【Widely Application】Distance measurement,Obstacle avoidance,Intelligent traffic control,Parking space control and industrial control so on.
Check Stock