Top Industrial Water Testing
HEATIT HISD 18-feet Pipe Heating Cable with Built-in Thermostat
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockHEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockHEATIT HISD 12-feet Pipe Heating with Built-in Thermostat, Black
- ...ng grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockNew Stainless Steel 304 Dual Scale Liquid Filled Pressure Gauge,Premium Spa Pool Aquarium Water Pressure Gauge,2.5\ Dial Display, 1/4\ NPT Bottom Mount (2, 0-100PSI)
- Clear And Accurate: Pool Pressure Gauge Provides Accurate Readings of Filter Pressure Pump from 0 to 100 PSI..
- Product Parameters:2.5" DIAL Display, 0-300 PSI,+/-1.5% Accuracy,1/4" NPT Bottom Mount,3/4" hose adaptor.
- Applications: Swimming Pools, Spas, Hot Tubs, Aquariums Residential & commercial pressure testing of water lines,Potable water systems,Industrial Pressure test Gauges..
- Commitment:If You Are Not Happy With Your Purchase We Will Issue a 100% Refund - No Questions Asked!.
Check StockHEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black
- ...ng grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockDEWENWILS Roof Heat Cable, 6ft Heat Tape for Pipe, Gutter, Roof, Self-Regulating Cable Pre-Assembled, UL Listed
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockPropet Men's Lucas Hi Fashion Boot, Coffee, 13 XX-Wide
- BEST WATERPROOF MEN'S BOOTS - Constructed to keep your foot dry from the outside in wet conditions so you are comfortable in your everyday work. All footwear exceeds all testing requirements for protective footwear and compression resistance.
- PROVIDE PROTECTION FROM ELECTRICAL HAZARD – these industrial work boots are designed to protect the wearer from open electrical circuits up to 18,000 volts.
- ADDED PROTECTION AND SAFETY – These shoes feature slip resistant soles that have tread designs which channel water, oil and other slippery substance to create superior grip.
- CARBON SAFETY TOE – Revolutionary Carbon Nano-fiber material makes these safety toes the lightest and most advanced safety toe available today.
- METAL FREE CONSTRUCTION – Designed so no component of the shoe will scratch or mark any working conditions.
Check Stock10 Pack Activated Carbon Block ACB Water Filter Replacement – 5 Micron, 10 inch Filter – Under Sink and Reverse Osmosis System
- Protect your Water – Removes Chlorine, Pesticides, Total Organic Carbon (TOC), Bad Taste, Odor, Fine Sediments, and Industrial Solvents.
- High Standard Filtration – Verified by independent laboratory testing to meet NSF / ANSI 58 Standard.
- The Best Filtration – Efficiently packed carbon granules create full coverage filtration which means your filter lasts longer.
- Universal Standard Size – 5 Micron Activated Carbon Block (ACB) Filter, 9. 75” x 2. 5” size fits all 10” filters.
- Made to Last – Airtight vacuum sealed packaging prevents spoiling of your filter.
Check StockHeavy Duty Stainless Steel Powder Coated PVC/Vinyl Gate Hinge Set and Screws-White
- TENSION ADJUSTABILITY - Patented tension adjustment system enables you to adjust the tension for closing speed.
- POOL AND SAFETY FENCES - Rigorous testing has proven these hinges are trusted for child water safety around pools, daycares, and pet barriers.
- LOW MAINTENANCE - These self-lubricating hinges are made of industrial strength "metal replacement" polymer and stainless steel components.
- FOR METAL AND WOOD GATES - This durable gate hinge is made for use on metal or wood gates weighing up to 66 pounds with a 13/16" gate frame to fence post gap.
- COMES WITH - Two hinges, mounting brackets, and stainless steel screws. Remove old hinges before installing new hinges..
Check StockQmark WHT500 Utility Heater for Use in Well Houses, Utility Rooms, and Areas with Pipes and Machinery, 500 Watt, 240 Volt, Beige
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check StockPlastic pH Test Strips, Universal Application (pH 0.0-14.0, 0.5 pH Intervals), 100 Strips
- 【Highly accuracy and quick readout】- 4 Pack (320pcs) pH Test Strips is made of high-quality filter paper, extremely accurate and reliable, quick response within 5 seconds..
- 【Easy to use】- Ph testing strips can be recognized the acidity and alkalinity of the solution from the color change..
- 【Function】- Litmus ph test strips can be used for chemical testing, acid and alkali testing, water quality analysis, soil testing, but also used in rain water testing, pets water testing, ph strips for water, ph soap tester..
- 【Wide range】- Alkaline test strip get full PH measure range of 1-14 meets all your needs..
- 【Easy to read】- pH Test Paper can be againsted PH color chart intervals, Lightweight for convenient use and carry..
Check StockRice Lake - 12874 Cast Iron ASTM Class 7 Painted Grip Handle Test Weight, 2lb Mass
- Metric and U.S. customary grip handle weight for testing field standards and industrial devices.
- Painted cast iron weight has chip-resistant paint that resists corrosion and conforms to NIST Handbook 105-1 standard.
- Meets American Society for Testing and Materials (ASTM) E617, Class 7 specification for rough weighing operations in physical and chemical laboratories, and for force-measuring apparatus.
Check Stock