Top Insulation For Water Pipes

Frost King F17XAD Pre-Slit Tubular Fiberglass Cover with self-Sealing Jackets (Bulk) for 3" Pipes

  • Commercial grade high temperature self sealing fiberglass tube 1/2″ thick and 3 feet long with reinforced foil & paper wrap.
  • Used for pipes immediately exiting furnace and water heaters, where foam pipe insulation might not be appropriate.
  • If your ductwork and your hot water pipes are not properly insulated or not insulated at all, you could be wasting up to 40% of your monthly home energy bill.
  • Frost King’s pipe and duct insulation solutions not only save you money, they’ll make your air conditioning and hot water heater work quickly and efficiently.
Check Stock

Midline Valve 8434P Sillcock Pipe Chrome Plated Brass Body Frost 1/2 inch PEX Connection and 3/4 inch Hose Bib Lead Free, 12

  • Commercial grade high temperature self sealing fiberglass tube 1/2″ thick and 3 feet long with reinforced foil & paper wrap.
  • Used for pipes immediately exiting furnace and water heaters, where foam pipe insulation might not be appropriate.
  • If your ductwork and your hot water pipes are not properly insulated or not insulated at all, you could be wasting up to 40% of your monthly home energy bill.
  • Frost King’s pipe and duct insulation solutions not only save you money, they’ll make your air conditioning and hot water heater work quickly and efficiently.
Check Stock

HEATIT JHSF1 Self Regulating Pre-Assembled Heating Cable 75-feet 120V Roof deicing and Pipe freeze Protection

  • 6 ft. water pipe heating cable, 42 watt, black color.
  • Stops metal and rigid plastic pipes from freezing down to -40°F — built-in thermostat automatically turns heating on when pipe temperature is below 42.8° F (close to freezing) and turns heating off once pipe is warmed to 55.4° F (well above freezing).
  • A single 6 foot heating cable is suitable for 6 foot to 8 foot long pipes that are 3/8 inches to 3/4 inches in diameter, or for 6 foot long pipes that are 1 to 1-1/2" in diameter. NOTE: Use only for water filled plastic (including PEX) or metal pipes. Not for use with anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines, and so on..
  • Features grounded plug with indicator light.
  • Pre-assembled, easy to install using the included instructions. Materials required (not included) are: aluminum foil (recommended for plastic pipe), fiberglass plumbing pipe insulation, fiberglass tape or similar with temperature rating 175° F or higher..
Check Stock

High Density Foam Insulation Tape Adhesive, Seal, Waterproof, Plumbing, HVAC, Weather Tape for Windows, Pipes, Cooling, Air Conditioning, Weather Stripping for Doors, Craft Tape (33Ft x 1/8'' x 1'')

  • ▶Ultra-strong and Non-Degumming◀ High quality and ultra-strong adhesive backing that ensures this insulation foam tape stays in place indefinitely once applied, it will not peel off..
  • ▶Good Sealing◀ This foam in the sponge tape is made to provide a completely airtight seal..
  • ▶Made for Optimum Durability◀ It offers excellent water resistance, weather resistance, temperature resistance, thermal insulation and chemical resistance. You are guaranteed optimum durability every time you choose our adhesive seal craft tape for your insulation needs..
  • ▶Closed Cell Foam◀ High density, this makes the foam tape ideal for weather stripping cabinets or insulation tapes for wrapping pipes sheet metal panels where an air-tight seal is required..
  • ▶Ideal for Industrial and Residential Use◀ This one-sided foam insulation tape is designed for both industrial and commercial use, such as doors, vents, windows, air conditioners, pipes and so on..
Check Stock

High Density Foam Insulation Tape Adhesive Rubber Strip, Seal, Door Insulation Foam Tape Weatherstrip, Waterproof, HVAC, Pipes, Foam Strips Air Conditioning, Weather Stripping Foam(33Ft x 1/8’’ x 2’’)

  • ▶Ultra-strong and Non-Degumming◀ High quality and ultra-strong adhesive backing that ensures this insulation foam tape stays in place indefinitely once applied, it will not peel off..
  • ▶Good Sealing◀ This foam in the sponge tape is made to provide a completely airtight seal..
  • ▶Made for Optimum Durability◀ It offers excellent water resistance, weather resistance, temperature resistance, thermal insulation and chemical resistance. You are guaranteed optimum durability every time you choose our adhesive seal craft tape for your insulation needs..
  • ▶Closed Cell Foam◀ High density, this makes the foam tape ideal for weather stripping cabinets or insulation tapes for wrapping pipes sheet metal panels where an air-tight seal is required..
  • ▶Ideal for Industrial and Residential Use◀ This one-sided foam insulation tape is designed for both industrial and commercial use, such as doors, vents, windows, air conditioners, pipes and so on..
Check Stock

HEATIT HISD 18-feet Pipe Heating Cable with Built-in Thermostat

  • ...t in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat

  • ...t in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 12-feet Pipe Heating with Built-in Thermostat, Black

  • ...to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black

  • ...to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HMQQ Foam Tubing Black Pipe Insulation Foam Tube 1 Inch Id Rubber Tubular Pipe Insulation 6.2ft Length /0.79inch Wall/Flame Retardant/Waterproof/Easy to Install/13 Sizes

  • ...moisture-proof: closed-cell foam structure, each air chamber is in a closed state and does not absorb water at all. Waterproof and moisture-proof, long service life. Good seismic performance: high resilience, reducing the vibration of hot and cold water in the pipeline..
  • ♦♦♦High-density rubber and plastic pipe insulation cotton jacket, the quality can withstand the test. The thermal conductivity is low. When the average temperature is 0°C, the thermal conductivity is 0. Better thermal insulation effect. It is cold and frost-resistant, so you don’t have to worry about water pipes freezing due to the weather..
  • ♦♦♦Fire-resistant and flame-retardant: Contains a large amount of flame-retardant and smoke-reducing materials, which is not easy to burn in fire. The fire will go out if you leave it. Ensure safety and reliability..
  • ♦♦♦Environmental protection materials, non-toxic and harmless, wide application range: suitable for pipeline insulation, industrial pipelines, external air conditioning units, construction industry, automobile air conditioning pipelines, etc..
Check Stock

M-D Building Products 50150 Pipe Insulation, Black

  • Stops condensation on cold pipes to prevent water damage.
  • Easy to install. Tube Pipe Insulation- 3/8 inch Wall - 3/4 inch x 6 feet.
Check Stock

Generic Repair Tape 1 Roll Widely Application Repair Multipurpose Insulated Tape White

  • With strong tensile strength, good extensibility and dielectric properties, this insulating tape is waterproof and flame retardant, resistant to high and low temperatures, making it environmentally safe..
  • With the simple and convenient use of this insulating tape and its wide range of applications, it is suitable for all kinds of pipes and can help you solve problems such as water leaks in household pipes..
  • It is constructed of silica gel material..
  • The length of this insulation tape is 150cm and width is 2.5cm..
  • It is suitable for water pipe repairing, cable repairing, appliance repairing and so on..
Check Stock