Top Ipl 1000w Rf 10mhz

Power Acoustik HP900S POWER ACCOUSTIC SWIVEL 2CH WRLESS HDPH

  • Power Acoustik HP-900S Swivel Ear Pad 2-Channel RF 900 Mhz Wireless Headphones.
  • 2-Channel, 900 Mhz Wireless Headphones With Swivel Ear Pads.
Check Stock

Rockville RWM1202VH VHF Wireless Dual HandHeld Microphone System/Metal Receiver

  • ...ndividual microphone volume controls. Rugged metal housing. Comfortable ergonomic composite microphone construction. Low power consumption for longer battery life..
  • System: Operating Range: 100´-200´(indoor), 65´-165´(outdoor). Channel: Two Channel. Frequency Range: 170MHz - 260MHz. Frequency Response: 80MHz-12000MHz. Frequency Width: 32Mhz. Dynamic Range: 110dB. Operating Temp: 14°F – 122°F. Oscillation Mode: Quartz Crystal. Frequency Stability: ±0.005%. Modulation Mode: VHF.Frequency Response: 80Hz – 8 KHz (±3 dB). Harmonic Radiation :< 63dBm. S/N: 60dB. RF Output Power: 10mW. Power Voltage: AC110V/ 220V - 50/60Hz..
  • Mic Battery: AA x 2. Receiver:. Sensitivity: (S/N=30dB) >2mV. De-Emphasis: 50µS. Audio Output Impedance: 600Ω. Audio Output Level.: 0-0.5V. Power Supply: AC110V /220V 50/60Hz. Current Consumption: ≤50mA. Audio Out Connector: 1/4˝ unbalanced. Transmitter:. Frequency Stability: ±0.005%. RF Output Power: ≤30mW. Modulation Mode: VHF. Maximum Deviation Range: ±50KHz. Microphone Mode: Fixed. Pre-Emphasis: 50µS. Power Supply: AA/1.5V×2. Current Consumption: ≤35mA..
Check Stock

1M-8G RF Power Meter Power Attenuation Set Digital Display Signal Strength Module Radio Frequency Power Meter

  • Large Range: The measuring power range of this RF power meter is -60~-5 dBm (External RF attenuator can be extended to 100dBm), and the frequency range is up to 8000MHz..
  • Specific Feature: The RF power meter is light, compact and convenient, with a measurement power resolution of 0.1 dBm, and an output interface SMA_K..
  • Clear Display: This RF power meter comes with an LED screen, the data is clear and straightforward, and it is easy to use..
  • Standard Structure: The precise mechanical structure of the RF power meter makes the measurement accurate, convenient and reliable..
  • Quality Assurance: The RF power meter has been inspected many times before it leaves the factory to confirm the quality..
Check Stock

Rockville, 2 RWM1202VH VHF Wireless Dual Handheld Microphone System w/Mic Receiver v2

  • ...metal housing , Comfortable ergonomic composite microphone construction, Low power consumption for longer battery life.
  • Specifications of RWM1202VH: System: Operating Range: 100'-200'(indoor), 65'-165'(outdoor), Channel: Two Channel, Frequency Range: 170MHz - 260MHz, Frequency Response: 80MHz-12000MHz, Frequency Width: 32Mhz, Dynamic Range: 110dB, Operating Temp: 14°F – 122°F..
  • Oscillation Mode: Quartz Crystal, Frequency Stability: 0. 005%, Modulation Mode: VHF, Frequency Response: 80Hz – 8 KHz (3 dB), Harmonic Radiation : < 63dBm, S/N: 60dB, RF Output Power: 10mW, Power Voltage: AC110V/ 220V - 50/60Hz, Mic Battery: 9V.
  • Receiver: Sensitivity: (S/N=30dB) >2mV , De-Emphasis: 50µS , Audio Output Impedance: 600O , Audio Output Level. : 0-0. 5V , Power Supply: AC110V /220V 50/60Hz , Current Consumption: =50mA , Audio Out Connector: 1/4" unbalanced , Transmitter: Frequency Stability: 0. 005% , RF Output Power: =30mW , Modulation Mode: VHF , Maximum Deviation Range: 50KHz , Microphone Mode: Fixed , Pre-Emphasis: 50µS , Power Supply: AA/1. 5V×2 , Current Consumption: =35mA.
Check Stock

Mirkit x Baofeng Radio UV-5R MK3X 5 Watt FCC Approved 2022 2100 mAh Li-ion Battery, Tri-Band Radio Mirkit Edition and Neck Strap Lanyard Mirkit Ham Radio Operator

  • ...Audio Gain Settings, In depth user's guide, Auto Power Off Function, Channel Mode Editing Settings, Auto Scan, Scanning Resume, and Variable Frequency Scanning, Quad Watch Delay Time, Randomization Privacy Mode, Builds upon previous generation UV-2501+220.
  • Frequency Range: 144-148MHz (VHF), 222-225MHz (1.25M), 420-450MHz (UHF).
  • Broad (Wide) / Narrowband (Narrow) Selectable.
  • Recommended Accessories: Pair UV-25X4 with the Nagoya TB-320A Antenna (and RB-50 Magnetic Mount) for easy installation. The PC04 FTDI Cable is recommended for easy computer programming.
  • Dual Watch monitoring VHF/UHF and 220Mhz: The 220 MHz band antenna lowpass filter is switched with a relay and the 2 meter lowpass filter and 70 cm highpass filters are switched with PIN diodes - resulting in a audible relay switch noise when monitoring 220MHz with VHF/UHF simultaneously. A relay that completely isolated the 220 MHz RF filter won't impact the RF performance of the 2 meter/70 cm bands. If monitoring multiple 220MHz or VHF/UHF simultaneously the relay is not heard or used..
  • Tribander Mobile Radio Kit Includes: BTECH UV-25X4, Speaker Mic, 6 foot DC Cable with Cigarette Plug Connector, Radio & Mic Brackets, Mounting Hardware, and User Guide.
Check Stock

Winegard HDA-200 Distribution Amplifier Adjustable Gain 5-1000 MHz 24dB

  • Single Rf Output With A 5mhz-42mhz, 2-way Bi-pass At +12db Gain.
Check Stock

1-600MHz RF Signal Power Meter Logarithmic Detector -74dBm to 18dBm Radio Frequency Detection

  • The detector is is used for RF signal power detection of frequency range between 1MHZ and 600MHZ.
  • It can detect a rf signal of power from -74dBm to 18dBm, and convert the RF signal into a DC voltage output.
  • The higher radio frequency signal range or power is, the higher output voltage will be.
  • output voltage is proportional to logarithm of input signal range.
  • Widely used for RF signal detection, signal power measurement, environment field strength detection, can also be used as a part of automatic gain control and automatic level control.
  • It can be made into 1mw ~ 1kw RF power meter after appropriate transformation.
Check Stock

2902832, Frequency transducer, F Input: 0.002Hz-20kHz, Out: V/I, Screw Conn, Mini MCR-SL-F-UI-NC

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

Mixer Module, 0.1‑500MHz Conversion Board High Frequency Transducer -10dBm for HF VHF Receiver for Quadrature Modulation for Base Station

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
Check Stock

Mixer Module, 0.1‑500MHz Low Distortion High Frequency Transducer -10dBm Conversion for Base Station for Quadrature Modulation for HF VHF Receiver

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

High Frequency Transducer, Mixer Module 0.1‑500MHz Bandwidth Mixing for HF VHF Receiver for Quadrature Modulation for Base Station

  • -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
  • 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
  • Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
  • Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
  • Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
Check Stock

FrSky Tandem X20S Transmitter with Built-in 900M/2.5G Dual-Band Internal RF Module

  • Built-in TD 900M/2.4G Dual-Band Internal RF Module Supports Multiple Working Modes 2.4G ACCST D16Mode (Compatible with ACCST Receivers with D16 V2 or later FW) 2.4G ACCESSMode (Compatible with ACCESS Receivers) 900M ACCESSMode (Compatible with ACCESS R9 868/915MHz Receivers) (*Capable of simultaneous working under ACCESS mode) 2.4G & 900M TD Mode (Compatible with TD Receivers).
  • Super-low latency and long-range control with telemetry (*Up to 50 to 100KM range and down to 4ms end-to-end latency) 800*480 Color Touch-Screen Displays 6 Quick-Mode Custom Buttons (Front) and 2 Momentary Buttons (Rear) Lite Type External Module Bay Built-in 6-axis Gyroscope Sensor All CNC Metal Trims, Knobs.
  • Haptic Vibration Alerts and Voice Speech Outputs Supports SWR Indicator Warning Supports Recharge System for 2S Li-ion Battery (USB Type-C Interface) High-speed PARA Wireless Training System (Compatible with FreeLink App3.0) Built-in Audio Wireless Module (Compatible with Bluetooth Audio Device).
  • All CNC High-Precision Hall-Sensor Gimbals with 10 Ball-Bearing, adjustable 45° to 60° stcik travel and 8° rotatable panel. ETHOS: The more pow....
Check Stock