Top Ir Emitter Cable Extension

DEMAO ir Repeater Kit ，ir Extender ，Infrared Repeater System Kit Remote Controls Home Theater Out of Sight .Control 1 DMIR0106TA Ir Repearter Kit

  • ...es it possible to control multiple IR devices while these are in a closed cupboard or in a remote location out of sight. This IR Block also features an Ethernet (CAT5 or higher) input on a terminal block connector for applications where the IR receiver needs to be further up to 100 meters away. To use Ethernet extension, an extra terminal block , sold separately, will also be required that the IR receiver will then plug into..
  • 3） Connection without having to install the software, simple and convenient for you to achieve Remote Control. This product allows you to control A/V equipment with your existing IR remote controller..
  • 4）Use Double IR Emitter x 6pcs，expandable up to 12.Use Triple IR Emitter x 6pcs，expandable up to 18. .Home theater devices kept in a closed cabinet or in another room with this IR Infrared Remote Control Extender Repeater System. Additional IR Emitters sold separately . It is compatible with almost all the IR electronic appliances in the market with its wide frequency range 20 KHz to 60KHz , especially works with SKY set-top box and Cisco DVD player ( support RCMM code ) ..
  • 5) PACKAGE INCLUDE: 1x IR Connecting Block, 4x IR Emitters , 1x Dual Band Mini IR Receiver, 1x Power Supply, 2x Mounting Screws and 1x Manual..
Check Stock

TNP IR Infrared Remote Control Extender Repeater Cable (8.2 Feet) - IR Signal Receiver & IR Emitter Blaster Extension Cable Wire Cord USB Powered System Kit

  • IR remote control cable extends the signal to a video source like a Blu-ray player, DVD player, STB box, AV receiver or other A/V source with an infrared sensor so it can be controlled from your HDTV.
  • Simple installation IR Repeater cable allows you to control home theater components located behind closet cabinet doors.
  • Place the IR emitter blaster near the source sensor to repeat the signal to the source.
  • Place the IR Receiver in a convenient location with line of sight of your hand-held remote.
  • IR Tx and Rx cables have adhesive circles on the back for mounting.
  • USB powered IR extension cable has an integrated 6 foot Y-cable to receive 5V USB power.
  • Connect to an HDTV USB port or to a USB wall charger power supply (sold separately).
  • Compatible with most A/V equipment with infrared sensors (not RF).
Check Stock

CMPLE - IR Emitter Extender Mini Stick-On Infrared Emitters Blink Eye, Remote Control Extension Cable 3.5mm 10 Feet

  • Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal.
  • Passes IR communication: Used with an IR Repeater kit to control a device.
  • Extend remote control ability to any room in the house.
  • Two emitters on a single plug,Adhesive backing allows the emitter to be attached to the IR eye of a device.
  • Dual Heads allow you to control multiple pieces of equipment with only one IR output, For use with Connecting Blocks and Home Automation controllers..
  • The mini stick-on emitter includes a 10 ft cable between the emitter heads and the mini-plug.
Check Stock

ENSIGEAR IR Repeater Kit, ir repeater system，IR Remote Control Extender Remote ，Control 1 to 18Devices.IR Extender 100 Feet，20KHz-60KHz Dual Sensors Mini Receiver,Super compatibility

  • ...es it possible to control multiple IR devices while these are in a closed cupboard or in a remote location out of sight. This IR Block also features an Ethernet (CAT5 or higher) input on a terminal block connector for applications where the IR receiver needs to be further up to 120 meters away. To use Ethernet extension, an extra terminal block , sold separately, will also be required that the IR receiver will then plug into..
  • 3） Connection without having to install the software, simple and convenient for you to achieve Remote Control. This product allows you to control A/V equipment with your existing IR remote controller..
  • 4）Use Double IR Emitter x 6pcs，expandable up to 12.Use Triple IR Emitter x 6pcs，expandable up to 18. .Home theater devices kept in a closed cabinet or in another room with this IR Infrared Remote Control Extender Repeater System. Additional IR Emitters sold separately . It is compatible with almost all the IR electronic appliances in the market with its wide frequency range 20 KHz to 60KHz , especially works with SKY set-top box and Cisco DVD player ( support RCMM code ) ..
  • 5) PACKAGE INCLUDE: 1x IR Connecting Block, 4x IR Emitters , 1x Dual Band Mini IR Receiver, 1x Power Supply, 2x Mounting Screws and 1x Manual..
Check Stock

IR Extender Infrared Remote Control Repeater Emitter Stick-On Mini Receiver Transmitter IR Blaster Extension Cable for TV/DVD/DVR/CD Player/Bluray Player (Single Heads, 10FT Long)

  • Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal. NOTE: Your device must have 'IR' port so the product could work!.
  • Passes IR communication: Used with an IR Repeater kit to remote control a device, extending remote control ability to any room in the house. NOTE: Your device must have 'IR' port so the product could work!.
  • Two emitters on a single plug, adhesive backing allows the emitter to be easily attached to the IR eye of your device..
  • Multiple heads optional allows you to control multiple pieces of equipment with only one IR output, For use with Connecting Blocks and Home Automation controllers..
  • The mini stick-on infrared emitter includes a 10 ft cable between the emitter heads and the mini-plug, easily meet your expectation of extending..
Check Stock

IR Emitter Extender Remote Control Transmitter 3.5mm to IR Extension Cable Triple Head Infrared Red Blaster Blink Eye Wire Cord Compatible with IR Repeater Extender System Kit, Xbox One (3 Head, 10FT)

  • Allows you to control A/V component by the existing IR controller, such as amplifier, cable box, HD DVR, stereo receiver, Satellite TV receiver, CD player, DVD player, Bluray player or other components which are controlled by IR signal.
  • Passes IR communication: Used with an IR Repeater kit to control a device.
  • Extend remote control ability to any room in the house.
  • Two emitters on a single plug,Adhesive backing allows the emitter to be attached to the IR eye of a device.
  • Dual Heads allow you to control multiple pieces of equipment with only one IR output, For use with Connecting Blocks and Home Automation controllers..
  • The mini stick-on emitter includes a 10 ft cable between the emitter heads and the mini-plug.
Check Stock

Gone in 60 Seconds

  • ➤Works with all 38-56kHz IR remote control and devices with an IR input port..
  • ➤Low current drive, low power consumption, long launch distance, small size installed..
  • ➤Applied to infrared forwarding equipment, audio and video transmission equipment, IR remote wireless transceiver, centralized control equipment, etc..
  • ➤Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control ..
Check Stock

St !GIANTMAN IR Infrared Emitter Extender Cable Extension Single HeadEye 3.5mm Jack Infrared Red Transmitter Blaster Eye Wire Cord Compatible with IR Repeater Extender System (IR-1.5m)

  • Single IR Emitter Extension Cable compatible with devices in 38khz.
  • 20-25 ft range from remote control to IR receiver. High Immunity to ambient light and noise.
  • Highly Reliable with high sensitivity for wide range..
  • 5 ft shielded cable, 3.5 mini plated stereo plug. Tip-VCC 5V, Center-Data,Lower-Ground, Lower-Ground.
Check Stock

OBVIS IR Infrared Remote Control Extender Repeater Cable (10 Feet) - IR Signal Receiver & IR Emitter Blaster Extension Cable Wire Cord USB Powered System Kit - Black

  • This Infrared Repeater Cable applies to all remote control devices from 38 to 56 khz.
  • IR Repeater Extension controls Audio Video Components in Entertainment Cabinets or Equipment Closets using Existing IR Remote Controls.
  • Come with adhesive backing sticks directly onto different devices.
  • 1 Receiver, 1 Emitter, Connects to USB port on TV or home theater device for power.
Check Stock

Sewell SW-32988 Direct BlastIR Wireless Pro IR Repeater, Remote Control Extender Kit (IR Emitter and Receiver),Black

  • Note Some devices use RF instead of IR for remote control. The Blast IR Wireless Pro only works with IR devices. Please check the signal type of your remote to ensure it is IR before ordering. .Wireless Distance: 200m (650 ft.), distance may vary due to obstacles, IR Receiver Distance: 7m (30 ft.)Incompatibility : Yamaha HTR 6140, Arris DCX 3520E-M, OSD ATM-7 Speaker Selector.
  • BlastIR Pro receivers are directional and require facing the receiver towards where you will be using the remote. To improve reception and widen the angle of control, we recommend using the included IR receiver cable connected to the main receiver unit..
  • BlastIR Pro Emitters work best when placed within a few inches of the devices you want to control. For best results we recommend attaching the included optional IR emitter cables so that the emitter is directly over the IR receiver of up to two devices. These are designed to stick directly to the devices that you are trying to control rather than sitting in front of them..
  • Included USB and AC power cables, extra IR cables, mounting adhesive, and rubber feet..
  • Wireless Distance: 200m (650 ft.), distance may vary due to obstacles, IR Receiver Distance: 7m (30 ft.).
Check Stock

uxcell IR Infrared Emitter Extension Cable 4.9ft Long 45 Degree Emission Angle 3.5mm Jack Single Red Head 2pcs

  • Works with all 38-56kHz IR remote control and devices with an IR input port..
  • Low current drive, low power consumption, long launch distance, small size installed..
  • Applied to infrared forwarding equipment, audio and video transmission equipment, IR remote wireless transceiver, centralized control equipment, etc..
  • Please note that the infrared emitter head is glued to the side of the infrared receiver tube, do not cover it, otherwise the device will not be used, and it will be insensitive to remote control by remote control..
Check Stock

WenkeDigi IR Infrared Repeater System kit, IR Repeater Extender, Max 100 Feet Efficient Receiver Range - IR Remote Control Hidden Devices -10 Feet IR Receiver Cable (Can Run 400 Feet by Your Cat5e)

  • This IR kit is a device that only passes on the infrared signal . It is used to control Four (4) IR devices out of sight that are kept in a closed cabinet or in anther room ( expandable up to 18, and 4 x single emitter provided in the package , Additional IR Emitters sold separately, One emitter one device ) . Strong Compatibly , It is compatible with almost all the IR electronic appliances like SKY STB and CISCO DVD player , SONY receivers ,Amplifier, Xbox, TV , Blu-ray player,etc with its wide frequency range 20 KHz to 60KHz ..
  • Mini Block Size , Dual Sensors Mini Bar IR receiver , One Sensor 38KHz , the Other 56KHz, with long effective remote control distance up to 100 FEET @38KHz and 23 FEET at 56KHz , High sensitivity, Real time transmission without any delay . It allows you to control your home theater with your existing IR remote controller. NOTE : NOT support RF and Bluetooth Remote Control ..
  • This IR Repeater system kit supplies with an ideal solution for those who want to conceal their A/V components equipment inside a entertainment system cabinet or closet door for a clean, stylish look. It makes it possible to control multiple IR devices while these are in a closed cupboard or in a remote location out of sight ..
Check Stock