Top Pcm Multiplexer

10 PCS Analog Multiplexer,Breakout Board Module,CD74HC4067 High Speed CMOS 16-Channel Analog Digital Multiplexer Demultiplexer,Suitable for Digital and Analog Signals

  • Because the multiplexer can also process digital signals, you can use it to transfer TTL-level serial data to multiple devices through pipe or transfer from multiple devices..
  • It is suitable for digital and analog signals (voltage cannot be higher than VCC) and can be connected in either direction. To control this, please connect the four digital outputs to the address selection pin of the chip (SO-S3) and send it the binary address of the desired channel..
  • This is a very convenient 16 channel CD74HC4067 analog/digital multiplexer/demultiplexer..
  • The internal switch is bidirectional, with a low on resistance and off leakage, and to prevent talk, please turn off the switch first and then on..
  • Drive it to a high level, and it will completely disconnect the common pins (all switches are disconnected)..
Check Stock

AITRIP 12PCS TCA9548A I2C IIC Multiplexer Breakout Board Module 8 Channel Expansion Development Board for Arduino

  • The TCA9548A adapter is connected to an I2C device with multiple identical addresses on the same I2C port on the main control board for normal communication and use.There are 8 I2C interfaces on one expander, and there are eight bidirectional transfer switches that can be controlled by I2C bus. This means that after 1 expander is transferred, 8 identical addresses can be connected to the same I2C port..
  • Expansion board TCA9548A compatible with IIC bus and system management bus (SMBus), active low reset input, support for hot insertion, low standby current, no glitch during power-up, support for voltages between 1.8V, 2.5V, 3.3V and 5V buses Level shifting, TCA9548A I2C IIC multiplexer breakout board depending on the contents of the programmable control registers, any single SCn/SDn channel or combination of channels can be selected..
  • 12pcs TCA9548A I2C IIC Multiplexer Breakout Board 8 Channel Expansion Board for Arduino.
Check Stock

Michigan Motorsports Knock Sensor Adapter for 1997-2004 LS1 LS6 Car to LS2 LS3 Knock Sensor

  • Knock Sensor Adapter for 1997-2004 LS1 Car to LS2 Knock Sensor.
  • This harness allows the dual-wire LS2 knock sensors located on side of the LS2 engine block to be plugged into the factory LS1 PCM harness. It has the perfect added length and thermal protection required to be routed near hot exhaust manifolds. Compatible with the PCM harness in LS1 Corvette and F-Body cars..
  • PLEASE NOTE THAT IN ORDER TO USE LS2 KNOCK SENSORS IN A LS1 CAR YOU REQUIRE SPECIAL LS1 PCM SOFTWARE CHANGES OR A LS2 PCM..
  • KEY FEATURES: Fully Plug and Play with the factory harness & sensors Military spec. high-temperature Teflon wire (same type used on oxygen sensors) 24" Length High-temperature (1200F) heat treated protective loom All connections crimped using our computerized crimp-quality monitoring system and then circuit checked for the utmost in reliability..
Check Stock

OREI Digital to Analog Audio Converter - Optical SPDIF/Coaxial to RCA L/R with 3.5mm Jack Support Headphone/Speaker Output DA21

  • Converts coaxial or optical digital audio input to analog stereo output over RCA and 3.5mm mini jack. Will not convert Dolby Digital Signal. Make sure to change to TV Output To PCM.
  • Supports all popular sample rates including 32kHz, 44.1kHz, 48kHz, 96kHz and 192kHz, at up to 24-bit resolution.
  • This Device will not convert Dolby Sound. It is only a converter not a Decoder. So make sure your device does not require Dolby conversion..
  • TROUBLE SHOOT - If your getting a Clicking Sound - Most likely your TV output is not set to PCM. Please change it PCM. Or if your getting Screeching or No Sound - Most likely you are trying to decode Dolby Sound to Analog. You will need a DA34 or DA34X.
  • INCLUDES DA21 Converter, Power supply, User Manual.
  • KINDLY NOTE : The DA21 will only support PCM audio output mode.It doesn't support Dolby, DTS, 5.1ch or 7.1 ch audio signals..
Check Stock

HiFi DAC+Sound Card Pifi DAC + PCM5122 DAC I2S Interface Analogue Output Signal Digital Audio Card Compatible with Raspberry Pi B + a + 2B Raspberry Pi 3B (64-bit)

  • Good performance: PCM5122 integrates a negative charge pump, and the output does not require a DC blocking capacitor.
  • very good ability to suppress noise in the frequency band. Since the load support is as low as 1K, PCM510xA can drive a variety of parallel products..
  • Ensure the continuity of signal impedance: Sound card Pifi DAC’s gold-plated RCV double clip and gold-plated 3.5 mm jack socket (recommended by amplifier). It is perfectly compatible with the official PI HAT size of the Raspberry Pi, based on the high gold plating process of the circuit board, and the arc line (high-end HIFI DAC adopts the arc line), which better guarantees the continuity of signal impedance and reduces signal reflection and refraction..
  • Pifi DAC + PCM5122 DAC: Pifi DAC + PCM5122 DAC, I2S interface, analog output signal, compatible with Raspberry Pi B + a + 2B Raspberry Pi 3B (64 bit). Provide infrared receiving interface..
  • Get rid of the current sound: The RPI+DAC HiFi kit uses an insulated power supply design to isolate the Raspberry Pi nutrition from the DAC part of the independent power supply, and the beads do not interfere with each other, and get rid of the sound of electric current. With this RPI+DAC HiFi kit, you can easily get m....
Check Stock

4K@60HZ HDMI Audio Extractor, HDMI 2.0b Audio Splitter Converter, HDMI to HDMI + Optical Toslink SPDIF + 3.5mm Stereo Audio with Control Output Analog Volume Knob Compatible for PS5/4/3/Blu-ray player

  • ... product is an HDMI extractor and HDMI splitter with control output analog volume knob, you can control HDMI extractor volume. Note: This unit does not support the ARC function..
  • 3 AUDIO MODE SETINGS- HDMI audio extractor splitter have Pass, 2.0CH, 5.1CH 3 kinds of audio mode options. 3.5mm audio output supports 2CH PCM LPCM stereo audio.
  • Optical SPDIF output supports 2CH PCM, 5.1CH Dobly Digital, Dobly TrueHD, DTS-HD, DTS.(Please set audio format on HDMI Source to PCM/ LPCM format to use If your device can't support these formats)PCM Setting Path: Device homepage -- system setting -- image and sound -- voice setting -- digital audio output -- PCM..
  • WIDE COMPATIBILITY- HDMI to Optical Audio Adapter suitable for various HDMI source devices to meet different needs. HDMI input: Blu-ray/ DVD/ HD player, cable/satellite box, Fire TV, Apple TV, PS3/PS4/PS5, Xbox, PC/laptop, HD camera, HD DVR etc. HDMI Output: Full HD TV, Monitor, Projector. Audio format: Speaker, Amplifier, Soundbar, D-o-l-b-y Digital, Dobly TrueHD, PCM 5.1/2.0.(Not suitable for passive speakers，An amplifier is required for use with this speaker).
Check Stock

Insignia Optical/Coaxial Digital-to-Analog Converter – Black

  • PROZOR 192KHz Digital to Analog Audio Converter: Converts coaxial or toslink digital PCM audio signals to analog L/R RCA and 3.5mm Jack audio simultaneously ( not capable of being reversed).
  • Input Audio Connector: 1 x Toslink, 1 x RCA (Coaxial).
  • Output Audio Connector: 2 x RCA(R/L), 1 x 3.5mm Jack.
  • Powered by 5.5mm USB Power Cable (Power Adapter is NOT Included).
  • Do Not Use Other Plugs, It Can Only Use 5V 1A Plug.
  • Up to 192KHz/24bit: Supports Sampling Rate at 32KHz, 44.1KHz, 48KHz, 96KHz, 192KHz.
  • 24bit S/ PDIF Incoming Bit Stream on Left and Right Channels.
  • Supports Uncompressed 2 channel LPCM or PCM Digital Audio Signal Output.
  • Provides Electromagnetic-noise-free Transmission(5.1 channel is incompatible, please set the audio output to PCM or LPCM）.
  • Can be Used for PS3, PS4, Blu-ray Player, HD DVD, Home Cinema Systems, AV Amps, Etc.
Check Stock

Analog/Digital MUX Breakout for Arduino

  • 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067.
  • ON Resistance 70Ohms @ 4.5Vcc and 60Ohms @ 6VCC.
Check Stock

20Pcs 74HC4051D SOP-16 74HC4051 SOP16 4051D 8-Channel Analog multiplexer/demultiplexer

  • 20Pcs HEF4051BT SOP-16 HEF4051B SOP16 F4051B 8-channel analog multiplexer / demultiplexer.
Check Stock

2Pcs AD ADG508AKNZ Analog Multiplexer Switch IC DIP-16 AD

  • 74HC4051 8-Channel-Mux CJMCU-4051 8 channel analog multiplexer module.
Check Stock

Analog Multiplexer, High Speed 16 Channel Bidirectional 10PCS Analog Demultiplexer for Radio Communication

  • 5Pcs/lot 74Hc4051 Analog Multiplexer Single 8 1 16-Pin So Bulk 74Hc4051d.
Check Stock

(5PCS) SN7447AN IC BCD-TO-7SEG DECODR/DVR 16-DIP 7447 SN7447

  • 74HC4051 8-Channel-Mux Multiplexer Selector Module Distributor Resolver CJMCU-4051 Development Board.
Check Stock