Top Power Frequency

Sunforce AC/DC Power Converter

  • Technical Information-Device Supported-Antenna: Power Description-Input Voltage-110 V AC:Power Description-Frequency-60 Hz: Power Description-Output....
  • Converts 110 Volt AC wall outlet into a 12 Volt DC plug.
  • Ideal for use with coolers, spotlights, fans, cell phones and more.
Check Stock

KOOBOOK 1Set 1Hz-50MHz Frequency Counter Meter Crystal Oscillator Digital Tester Meter DIY Kit 5-Digital LED Display

  • This is a PIC microcontroller based on the frequency meter, with a crystal measurement function and programmable addition and subtraction frequency settings..
  • Five digital display, easy and intuitive, all use of in-line components, the circuit is simple and easy to produce..
  • You need to solder and assemble by yourself, all the components are directly inserted, and the wire is printed correctly according to the PCB. After welding, the signal is input with the standard signal source, and the yellow adjustable capacitor is adjusted to make the display value equal to the signal frequency..
  • The power supply can use a USB to 3.5mm power cable, or you can directly input a 5-9V DC power supply at the - and + pads..
  • It can measure the frequency range from 1 Hz to 50 megahertz (1Hz-50MHz), can measure the oscillation frequency of most common crystal oscillators, and measure equipment such as radio transceivers..
Check Stock

CW QRP Shortwave Radio Kit - CW Transceiver Shortwave Radio Kit

  • The patch device of the main control board has been pre welded and connected to the base plate in the form of stamp hole. The single chip microcomputer adopts pic16f1938, builtin PLL local oscillator, supports crystal oscillator calibration setting, and has its own frequency indication circuit (Seven Segment LED nixie tube is used, the display unit is 1kHz, the photo has color difference, and the actual color is red. The working frequency covers 7.000-7.100mhz, 1kHz or 100Hz steps )..
  • Ta2003 mixer is used for reception, and crystal filter is used for if. After ta2003 multiplication detection, the sound size is adjusted by digital potentiometer and sent to audio active filter circuit. Finally, LM386 drives speaker, and if frequency supports calibration setting..
  • Use 3 bs170 parallel outputs, class E amplification, 12V power supply, output power 5W! Relay switching is used for transceiver, with the function of transmitting delay adjustment to avoid frequent relay switching and improve the isolation of transceiver channel..
  • It has the function of automatically sending call signs, which is very convenient to use. The MCU uses the original code of our store, which can adjust the code speed, sidetone frequency and sidetone size. It can input the call sign by ....
Check Stock

(4) American Bass SQ 5.7 5x7 or 6x8 75w RMS Car Speakers w/Swivel NeoTweeters

  • Package Includes: (1) Pair of American Bass SQ 6.5" 2-Way 80w RMS Car Audio Speakers w/ Swivel NeoTweeter. (1) Pair of American Bass SQ 3.5" 40w RMS Car Audio Speakers with Neo Swivel Tweeters. Woven carbon fiber cone. Butyl Rubber Surround. 25 oz magnet. 80w RMS / 160w MAX.
  • Frequency Response 55hz - 22khz. Ferro Fluid Cooled. 4 ohm impedence. Specifications: RMS Power Per Speaker: 80W. Max Power Per Speaker: 160W. Impedence (Ohms): 4. Sensitivity Db: 89Db. Mounting Depth (In): 2.75. Cutout Size (In): 5.5. Frequency Response: 55Hz - 22Khz. Magnet Size (Oz): 25.
  • Voice Coil Size: 1. Basket Type: S Steel. 3.5" Woven Carbon/Glass Fiber Cone. Butyl Rubber Suspension Surround. 10 Oz Magnet/20 Magnet Structure. 1" High Temperature Aluminum Voice Coil. Swivel 0.75" Titanium Dome Neodymium Tweeter. Ferro Fluid Cooled. Power Handling: 80 Watts Max/40 Watts Rms.
  • Frequency Response: 110Hz-21Kh. Sensitivity:85Db(1W/1M). 4 Ohm Impedance. Rubber Magnet Boot. Specifications: RMS Power Per Speaker: 40W. Max Power Per Speaker: 80W. Impedence (Ohms): 4. Sensitivity Db: 85Db. Mounting Depth (In): 1.75. Cutout Size (In): 3. Frequency Response: 110Hz - 21Khz.
  • Magnet Size (Oz): 10. Voice Coil Size: 1. Basket Type: S Steel.
Check Stock

Rockville RWM132V VHF Wireless Dual Handheld Microphone System/High Sensitivity

  • ...o limit feedback and interference, Ultra-signal stability eliminates unwanted distortion, Transmitter automatically links to receiver for ease of use, Use two handheld mics at once with no interference, Individual microphone volume controls, Low power consumption for longer battery life, System comes in 5 different frequency options. You can request a specific one in the notes-A. 225. 1/227. 1 MHZ, B. 224. 9/256. 9 MHZ, C. 228. 9/253. 4 MHZ, D. 230. 8/225. 8 MHZ..
  • Microphone Length: 9. 69”, Microphone Windscreen Diamater: 3. 15”, Microphone Body Diameter: 2. 22”, Receiver Dimensions: 8. 27” x 5. 4” x 1. 57”.
  • Specifications: System: Operating Range: 150 feet or more, Channel: Two Channel, Frequency Range: 210MHz - 270MHz, Frequency Response: 40Hz-18KHz, S/N. : >103dB (1KHz-A), Operating Temp: 14°F – 122°F, Oscillation Mode: Quartz Crystal, Frequency Stability: 0. 005%, Modulation Mode: VHF, Harmonic Radiation : 2mV, Audio Output Impedance: 600O, Audio Output Level. : 0-0. 5V, Power Supply: AC110V 60Hz, Current Consumption: =50mA, Audio Out Connector: 1/4" unbalanced. Transmitter: Frequency Stability: 0. 005%, RF Output Power: =10mW, Modulation Mode: VHF, Maximum Deviation Range: 48KHz, Microphone Mode: Fixed, Power Supply: AA/1. 5V×2, C....
Check Stock

Radio Hellas

  • 10 and 12 meter bands. 16 programmable/erasable frequencies. Programmable repeater split..
  • Large frequency display with dimmer. New backlit display. Dual panel meters..
  • Improved receiver design for increased sensitivity and image rejections. Receiver clarifier ( plus/minus 0.5kHz)..
  • Variable output power control. Noise blanker/ANL circuitry. Frequency selector lockout..
  • Double FET balanced mixer for improved receiver intermodulation rejection. Active frequency scanner. Continuous duty built-in AC power supply..
Check Stock

Pair Rockville APM5W 5.25' 2-Way 250W Powered USB Studio Monitor Speakers+Pads

  • Studio reference monitors for critical audio production listening in small spaces.
  • Super-near-field design puts the sweet spot right at your ears on a typical desk.
  • DESKTOP/SHELF switch adapts response for superior sound from any speaker placement.
  • Extended frequency response from 45 Hz - 20 kHz delivers surprising bass response *Advanced digital crossover and careful time alignment for precise stereo imaging.
  • 4 class D power amps and 50W RMS for punchy low end and impressive volume.Total output power (both speakers)- 70W (peak) - 50W RMS.Low frequency output power (single speaker)- 18W RMS. High frequency output power (single speaker)- 7W RMS.
Check Stock

JBL Professional JRX215 Portable 2-way Sound Reinforcement Loudspeaker System 15-Inch

  • Progressive Transition high frequency waveguide provides superior coverage control, reduced distortion, and smoother frequency response.
  • The rugged, acoustically superior enclosure uses advanced adhesives and mechanical fastener technology for extreme durability and improved....
  • High-voltage capacitors and inductors with massive cores and heavy gauge wire enable the crossover network to handle high power without saturating.
  • JBL 2414H-C 1" polymer diaphragm compression driver improves high frequency performance as well as system reliability.
  • JBL 15" low frequency driver with a 2.5"-diameter edge wound ribbon voice coil for greater efficiency and power handling.
Check Stock

(2) JBL Pro JRX215 15″ 2000w PA/DJ Speakers+Powered 12-Channel Mixer+Stands

  • ...rofessional Passive PA/DJ Speakers 8 Ohm JRX 215, (1) Rockville RPM109 12 Channel 4800w Powered Mixer, 7 Band EQ, Effects, USB, 48V, (1) Pair of Rockville Tripod Speaker/Lighting Stands+(2) 20 Foot 1/4″-SpeakOn Cables.
  • Features of JRX215:, JRX215 15″ Two-Way Sound Reinforcement Loudspeaker System, JBL 15 in low frequency driver with a 64 mm (2.5 in) diameter edge wound ribbon voice coil, JBL 2414H-C 25 mm (1 in) polymer diaphragm compression driver, Advanced network topology crossover design, High-voltage capacitors and inductors with massive cores and heavy gauge wire, Progressive Transition high frequency waveguide, 19 mm (.75 in) MDF (Medium Density Fiberboard) enclosure.
  • Details:, Power Rating : 250 W / 1000W, Frequency Range (-10 dB) : 41 Hz – 18 kHz, Frequency Response (±3 dB) : 59 Hz – 13 kHz, Sensitivity (1w/1m) : 99 dB SPL, Nominal Impedance : 8 ohms, Recommended Amplifier Power : 250 W to 500 W into 8 ohms, Maximum SPL: 129 dB, Nominal Dispersion : 90º x 50º, Crossover Frequency : 2.2 kHz, Dimensions (H x W x D) : 699 mm x 460 mm x 432 mm (27.5 in x 18.1 in x 17 in), Weight : 27.4 kg (60.5 lb).
  • Rockville RPM109 12 Channel 4800w Powered Mixer, 7 Band EQ, Effects, USB, 48V , RMS Power Output:, …..600w x 2 @ 4 Ohm, …..450w x 2 @ ....
Check Stock

High Frequency Transducer, Bandwidth Mixing Board Mixer Module -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver

  • 【Important Data】: SSB noise figure (NF) of 9.75 dB--Input IP3: 28.5 dBm--Input P1dB: 13.3 dBm--Typical LO drive: 0 dBm--Power conversion gain of 1.8 dB.
  • 【Wild Used】: This 5V double balance up and down frequency mixer module is widely used for cellular base station receivers, Radio link down converters, Broadband block conversion, Instrumentation.
  • 【Low Power】: Our 130mA 50 Ohms Balun coil coupling frequency conversion mixer features adjustable bias for low power operation, so you can trust and use this RF mixer inverter with confidence.
  • 【Wonderful Components】: This 5V ADL5801 double balance up and down frequency mixer module is equipped with exposed paddle, 4mm x 4mm, 24-lead LFCSP package, so it will be an ideal choice for you.
  • 【Size】: Power supply: DC+5V@80mA(anti-reverse connection protection.)--RF_IN/RF_LO input frequency range: 10-6000Mhz--Input and output impedance: 50 ohm--Type:Input Balun coupling, Input/output Balun coupling(Optional)--Weight: Approx.15g/0.5oz.
Check Stock

Another Galaxy (feat. AO, Darb$ & Sir Random)

  • 10 and 12 meter bands. 16 programmable/erasable frequencies. Programmable repeater split..
  • Large frequency display with dimmer. New backlit display. Dual panel meters..
  • Improved receiver design for increased sensitivity and image rejections. Receiver clarifier ( plus/minus 0.5kHz)..
  • Variable output power control. Noise blanker/ANL circuitry. Frequency selector lockout..
  • Double FET balanced mixer for improved receiver intermodulation rejection. Active frequency scanner. Continuous duty built-in AC power supply..
Check Stock

MC14046BCP Phase Lock Loop (PLL) IC 1.9MHz 1 16-DIP (0.300\

  • ...gnal-input amplifier and a common comparator input..
  • Very low power consumption: 70 µW (typ.) at VCO, VCO inhibit control for ON-OFF keying and ultra-low standby power consumption fo = 10 kHz, VDD = 5 V, Source-follower output of VCO control input (Demod. output), 100% tested for quiescent current at 20 V.
  • Operating frequency range up to 1.4 MHz (typ.) at VDD = 10 V, RI = 5 k, High VCO linearity: 003c1% (typ.) at VDD = 10 V, 5-V, 10-V, and 15-V parametric ratings.
  • Low frequency drift: 0.04%/°C (typ.) at VDD = 10 V, Choice of two phase comparators: Exclusive-OR network (I) Edge-controlled memory network with phase-pulse output for lock indication (II), Zener diode to assist supply regulation, Standardized, symmetrical output characteristics, Meets all requirements of JEDEC Tentative Standard No. 13B, "Standard Specifications for Description of 'B' Series CMOS Devices".
  • A Versatile Building Block for Micropower Digital and Analog Applications, Example Applications: FM demodulator and modulator, Frequency synthesis and multiplication, Frequency discriminator, Data synchronization, Voltage-to-frequency conversion, Tone decoding, FSK - Modems, Signal conditioning,.
Check Stock