Top Raspberry Pi Audio Input Gpio

HiLetgo GPIO Expansion Board Raspberry Pi Shield for Raspberry PI 4B/3B+ With Screws

  • Raspberry Pi 4B/3B+ GPIO Shield Expansion Board.
  • Multifunction GPIO Extension Board 1 to 3 Port DIY.
Check Stock

waveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard

  • Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
  • Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
  • 1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
  • 10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
  • Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.
Check Stock

SamIdea 2-Pack 40pin Male to Female IDC GPIO Rainbow Ribbon Cable Jumper Wire for Raspberry Pi A+/B+/3 B, 20cm/8'

  • 8" 40 Pin Ribbon Cable for Raspberry pi 3B ,Raspberry pi 2 model B,Raspberry pi 1B+, Raspberry pi 1A+,Raspberry pi zero W, Raspberry pi zero.
  • Pin Pitch: 2.54 mm,Their Diagram as Product image show.
  • 2x40 Pin Male to female IDC 2.54mm pitch ribbon cable flat GPIO Cable.
  • GPIO 40P 40-pin Rainbow Ribbon Cable.Raspberry Pi 3 2 Model B B+ and 3.5¡± 5 inch TFT touchscreen LCD display are not including..
  • SamIdea is a Registered Trademark, can not sold without authorization..
Check Stock

MakerFocus Raspberry Pi 3 Case Protective Case, Raspberry Pi 3.5 inch Display Case, with Mini Cooling Fan for Raspberry Pi 3B, 3B+,2B,2B+ Compatible with Raspberry Pi GPIO 3.5 inch Display

  • Installation instructions video: Please get the link from the product description below. PLZ NOTE: ★This case is not compatible with 3.5 Inch HDMI TFT LCD Display, It is designed to RPI 3.5 Inch GPIO Display, ★The 3.5 inch screen is not included!!!.
  • Dual-use: You can use it only on the Raspberry Pi motherboard, or use it on the Raspberry Pi motherboard and Raspberry Pi 3.5inch display,Then decide whether to cover the its cover. (Note: The Raspberry Pi motherboard and Raspberry Pi 3.5inch display are not included!!!).
  • Can install mini cooling fan: The case when used without the display screen, you can install mini cooling fan, Snap-in installation, the cooling fan was included in packaging..
  • With GPIO open position: There is a GPIO open position on this case cover,when you use it only with Raspberry Pi motherboard, it can easy to pull up and insert the GPIO pins, don't need to open the cover. This case is easy to install and has good ventilation..
  • With cable guide hole: It reserved cable guide hole for the camera, more convenient to use with camera.
Check Stock

BITMAIN Antminer T9 S1 S3 S5 S7 S9 A3 D3 L3 V9 120mm High Temp Fan Duct 4 INCH USA Made 1 PCS

  • Raspberry Pi 4 Touchscreen - Raspberry Pi 4 Inch IPS full-angle display monitor, 800 x 480 physical resolution support HDMI input, refresh rate up to....
  • Orange Pi Touchscreen - Miuzei raspberry pi 4 monitor support HDMI audio output, data entry (computer, DVD), HDMI audio input, stereo 3.5mm audio....
  • Raspberry Pi 4 Screen Case - Pi 4 inch touch screen compatible with raspberry pi 4 b/4b/4 model b. Display ONLY Support System - Raspbian, Kali-linux,....
  • Touchfunction Support System - only support Kali, Raspbian, Ubuntu, Octopie. The 4 inch display monitor with touch control function (need to install....
  • Packaging Content & After Sales - you will receive raspberry pi screen, raspberry pi heatsink, 30mm cooling fan, screwdrive, awesome looking, it can....
Check Stock

KEYESTUDIO L298P Motor Driver HAT Shield GPIO for Raspberry Pi Model B/B+/A+/2/3/4 Zero and Zero W, High-Power Motor Speed Control Board Dual H Bridge with IR Receiver

  • This Motor Driver HAT gives your Raspberry Pi the ability to drive two DC motors, with drive current up to 2A..
  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards like Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B and later versions.
  • Reserved I2C SPI control pins, allows to work with other control boards and sensors. Comes with an IR receiver for communication with an infrared remote controller..
  • Included 4x M2.5*20MM screws, 4 xM2.5*10MM copper pillars, 4x M2.5 Nuts. Easy to install on your RPi board. Please note Raspberry Pi board, remote control and motors in the photos are Not Included!.
Check Stock

Miuzei Raspberry Pi 4 Case with Fan Cooling Pi 4 Case with 4 Pcs Aluminum Heat Sinks Pi 4B Case for Raspberry Pi 4 Model B -Black/Blue (Pi 4 Board Not Included)

  • Raspberry Pi 4 Case for Raspberry Pi 4 - Miuzei clear blue acrylic raspberry pi 4b case is specially designed for raspberry pi 4 modle b / 4 b, and perfect compatible with raspberry pi 4 /4b. assembly easy for beginners and amateur..
  • Raspberry Pi 4 Case With Fan - New Raspberry pi 4b case with a Silence DC 5V cooling fan and 4 pcs Aluminum heatsinks, cooling system keep your Raspberry pi 4 B cool quickly even the CPU under high load..
  • Raspberry Pi 4 Model B Case - acrylic pi 4 case won’t block the signal.the rubber feet on the bottom lid can provide a stable platform for raspberry pi 4 case so that it allows air to circulate on the bottom side of the board and avoid the screws scratching the desk surface..
  • Easy To Access All Ports - Miuzei raspberry pi 4 case fan can perfect Access to the USB-C Power Connector, Dual Micro HDMI, Audio/Video, USB and Ethernet Ports, GPIO Port, Camera Cable, and Access to the Micro SD Card..
  • Packaging Content & After -Sales - you will receive pi 4 clear blue case, 4 piecess raspberry pi heatsink, 35mm cool fan, 4 piecess rubber feet, screwdrive, awesome looking, it can make your pi looks cooler than others. if you encounter any problems, you can contact us at any time, and we will answer you..
Check Stock

RasTech Raspberry Pi 3 Model B Starter Kit with 32GB Micro SD Card, Power Supply with ON/Off, Case, Micro SDHC Card, Cooling Fan, HDMI Cable, Network Cable, Heatsinks, Card Reader, Screwdriver

  • Geekworm Raspberry Pi 3B+/3B passive cooling aluminum case is designed for Raspberry Pi 3 Model B Plus and Raspberry Pi 3 Model B..
  • Design with good heat dissipation, passive cooling design, net weight up to 207 grams, don't need to install the cooling fan or heatsink.
  • Access to all ports of Raspberry Pi 3 Model B+ or Raspberry Pi 3 Model B , GPIO cable interface and TF card slot is reservered, support to install the gpio cable and TF card..
  • Made of high quality aluminum material. with 4pcs thermal tapes to attach on your Raspberry Pi 3B+/3B. For Raspberry Pi 3B+, attach the big thin thermal tape on CPU.
  • For Raspberry Pi 3B, attach the big thickness thermal tape on CPU..
  • Note: The Raspberry Pi 3 board is not included in the packing list. Packing List: √1 x Aluminum Case for Pi3.
Check Stock

Geekworm Raspberry Pi 3 B+ Case, Raspberry Pi 3B+/3B Aluminum Alloy Heavy Duty Passive Cooling Metal Case with Heatsink Pillar for Raspberry Pi 3 Model B+/Raspberry Pi 3 Model B-Black (P252)

  • Geekworm Raspberry Pi 3B+/3B passive cooling aluminum case is designed for Raspberry Pi 3 Model B Plus and Raspberry Pi 3 Model B..
  • Design with good heat dissipation, passive cooling design, net weight up to 207 grams, don't need to install the cooling fan or heatsink.
  • Access to all ports of Raspberry Pi 3 Model B+ or Raspberry Pi 3 Model B , GPIO cable interface and TF card slot is reservered, support to install the gpio cable and TF card..
  • Made of high quality aluminum material. with 4pcs thermal tapes to attach on your Raspberry Pi 3B+/3B. For Raspberry Pi 3B+, attach the big thin thermal tape on CPU.
  • For Raspberry Pi 3B, attach the big thickness thermal tape on CPU..
  • Note: The Raspberry Pi 3 board is not included in the packing list. Packing List: √1 x Aluminum Case for Pi3.
Check Stock

Treedix Compatible with Raspberry Pi 3B/3B+/4B GPIO Breakout Expansion T-Type Board with 20cm FC40 40pin Cable Development Board

  • The small board is connected to the 40-pin GPIO connector on the Raspberry Pi, and these pins are assigned to a breadboard-friendly layout and spacing.
  • T-shaped expansion board and breadboard make the experiment more convenient.
  • Using the GPIO expansion board, you can connect all versions of the Raspberry Pi to various sensors and electronic components.
  • Purpose: It can be used for the pin experiment of the experiment board, adding experimental items, etc., and it can be connected to the pin very reliably by simple soldering by yourself. 5. Strong compatibility: suitable for Raspberry Pi 3B/3B+/4B, 100% compatible with Raspberry Pi.
  • Strong compatibility: suitable for Raspberry Pi 3B/3B+/4B, 100% compatible with Raspberry Pi.
Check Stock

sb components Raspberry Pi Pico GPIO Expansion Board, Multi-Purpose GPIO Expansion for Raspberry Pi Pico

  • Raspberry Pi Pico GPIO Expansion Board is used to break out all the pins and power of the Raspberry Pi Pico development board via male or female headers.
  • Pico GPIO Expansion Board allows the user to connect it to other components with the help of a jumper wire.
  • It has been designed to enhance the learning experience for the user.
  • GPIO Expansion Board is specifically made to work with the Raspberry Pi Pico Board.
  • Compatible with all the variants of Sensors/Modules.
Check Stock

Smraza Case for Raspberry Pi 4 Model B, Pi 4B Case with Fan, 4PCS Heatsinks, 5V 3A USB-C Power Supply, USB Card Reader, 6 Feet Micro HDMI Cable, 7.8 Inch Micro HDMI to HDMI Adapter Cable (4K Ultra HD)

  • Upgrade Raspberry Pi 4 Case - Acrylic 9 Layers Case for Raspberry Pi 4 Model B (Raspberry Pi 4 Board Not Included) with Good Appearance. It can be access to all ports of Raspberry Pi board, such as GPIO port, HDMI port, USB port, SD Card slot..
  • Pi 4 Case with Better Cooling System - Raspberry pi 4 quite cooling fan and 4 pcs aluminum heat sinks are good for heat dissipation of Raspberry Pi board..
  • Raspberry Pi 4 Power Supply with ETL Certification - ETL LISTED 3A USB-C power supply for Raspberry Pi 4. With on/off switch, it's convenience to power on and power off your RPI 4. Input: 100-240V AC, 50-60Hz, 0.8A. Output: 5V 3A. Cable length: 59 inch..
  • 6 feet/ 1.8 m Micro HDMI to HDMI Cable for Raspberry Pi 4 - Up to 4K Resolution. Up to 60P (Frames/Second). CEC Support. Also come with a 7.8 inch Micro HDMI to HDMI Adapter Cable..
  • 100% Customer Satisfaction Guaranteed. If for ANY reason you aren't completely satisfied with the case, please let us know and we will give you a satisfy solution..
Check Stock