Top Receiver Module

ES100 Present DJ Mix [Explicit]

  • ADK (DIY Soldering Kit) for EverSet ES100 WWVB-BPSK Atomic Clock Receiver IC.
  • Hardware is compatible with Arduino - Atmega328P with Arduino Bootloader.
  • Includes all Parts to build the kit as shown in the Pictures - including 1x ES100-MOD Receiver Module and 1x ES100-MOD Carrier Board.
  • For Demo Program, Libraries, Documentation etc. see Manufacturer's Website.
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...otor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

HC-05 Wireless Bluetooth Receiver RF Transceiver Module Serial Port Transmitter Module

  • RXD: the receiver, Bluetooth module receives from another device sent data.
  • normally connected to other devices transmitting end TXD?.
  • TXD: sending end, the Bluetooth module to send data to other devices.
  • receiving terminal is normally connected to other devices RXD.
Check Stock

HiLetgo 3pcs RXB6 433MHz Superheterodyne Wireless Receiver Module for Arduino/ARM/AVR

  • RXB6 433MHz Superheterodyne Wireless Receiver Module.
  • Power supply voltage input range: 3V-5.5V.
  • Low power consumption, 3.3V @ 433.92MHz, 6.0mA.
Check Stock

Bose Lifestyle 650 Home Entertainment System works with Alexa - Black

  • As main components, your purchase include: One Console, 4 OnmiJewel side speakers, One Omni Jewel center speaker, One Acoustimass wireless bass module, universal remote control, 2 wireless receivers, One ADAPTiQ headset and Owner’s guide.
  • Dimensions (”): Console – 15.98 W x 2.56 H x 10.16 D | Omni Jewel Side speakers (each) – 1.84 W x 5.77 H x 1.84 D | Omni Jewel Center speaker – 21.34 W x 1.9 H x 1.84 D | Bass module – 11.61 W x 12.8 H x 11.61 D | Wireless receivers – 6.54 W x 1.6 H x 3 D.
  • Wires length: 6-foot IR emitter, 5-foot optical cable, 6-foot HDMI cable, 5-foot power cord, 20-foot center speaker cable, 20-foot wireless surround speaker cable, and 20-foot front speaker cables.
  • Front and center speakers have a wired connection, while the 2-rear speakers connect to a wireless receiver and AC power mains. The rear speakers and bass module connect to the front module wirelessly.
  • Supported Audio formats - Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS, Multichannel PCM. Video Source compatibility - Support for six 4K/60 video sources (HDMI 2.0/HDCP 2.2).
Check Stock

DISH Solo HD Receiver (ViP 211z)

  • 【Built-in 2.4G WIFI & Ethernet】The V9 Prime satellite receiver allows multiple ways to connect to the network. Built-in 2.4G WIFI module, support IEEE 802.1.1b/g/n and 3G/4G USB dongle, can also connect to wired network through Ethernet port, support network sharing..
  • 【DVB-S/S2/S2X】1080P satellite receiver Compatible with DVB-S/S2/S2X signals, it is a satellite TV receiver. Compared with DVB-S/S2, DVB-S2X has higher spectral efficiency and higher access speed..
  • 【No CA card required to decrypt】The firmware in the Satellite receiver will be updated from time to time. After you can upgrade via USB port or FTP, the decoder can decrypt satellite channels directly without inserting a CA card..
  • 【Sat to IP】This receiver supports to transmit your satellite TV program to your mobile phone, tablet and other device via GTShare APP. This TV SAT decoder also supports DLNA function..
  • 【USB 2.0 Port】USB port is compatible with FAT/FAT32/NTFS big capacity hard disk. And USB port can also be used for personal video recorder (PVR), TIMESHIFT and media files playback. This USB port supports multiple media, audio, photo formats..
Check Stock

Traxxas 6528 TQi Traxxas-Link Enabled 2.4GHz High-Output 2-Channel Transmitter

  • FEATURES: Can be equipped with the Traxxas Link Wireless Module (TRAC6511) and used with the iPhone, iPad or iPod touch* to create a graphical user in.
  • INCLUDES: Traxxas TQI 2-Channel 2.4GHz Transmitter.
  • REQUIRES: AA Batteries: Four for transmitter Servos and receiver of modeler's choice COMMENTS: * Traxxas Link Wireless Module is not included and must.
Check Stock

Receiver or Amplifier Megabase 12 Volt Trigger-Controlled Cooling Fans (12v), with multispeed Control, for Home Theater

  • This super low-noise dual-120mm fan unit is designed to sit on your receiver’s top air vents. It has a special raised air-chamber base, which covers 145 square inches, and air is drawn out over the entire area of this raised base..
  • The system includes a 12 volt trigger control module, which turns the fan on and off, under the control of your component’s 12v trigger socket. The 12v module controls the power from the cooling system’s multi-speed transformer, directing it to the fans when it detects a 12v signal. In addition, you control the speed of the fans, with the multi-speed power controller..
  • IMPORTANT: Some receivers have a non-standard setup, where the receiver doesn’t directly control the trigger (for example, the trigger might be under the control of Zones 2 or 3, etc.). Please consult your receiver’s manual for details about how its 12v trigger operates, or contact me if you have questions..
  • Recommended fan speeds for this system: The fans (running together) are rated at 13db while moving 50 cubic feet of air per minute at 1/3 speed, or 16db & 72CFM at 1/2 speed. With component cooling, slow (and quiet) are the way to go! Other available speeds: 2/3 speed = 19db/98CFM, 3/4 speed = 22db/110CFM, full spe....
Check Stock

REC S550 DIY Hexacopter Drone Development kit (Value Pack)

  • - Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   Expansion feedback module,users can get plane details in real time.   Make very setting clear and exactly output result..
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Great control distance: 1.1km on the ground, 2km in the sky.   Fast response time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.  High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.   Strong anti-jumping,DSSS(Direct sequence spread spectrum) technology..
  • Pls note: Support Max 3-4S battery (Optional, only included in ARF Version).
Check Stock

KEYESTUDIO Basic Starter Kit for Microbit V2 V1.5 (Not Included), with 35 Lessons Tutorial, i2c LCD, 5V Relay, LED Matrix, Breadboard Components Great for Teens Kids STEM Programming

  • The easy plug starter kit v2.0 are designed for STEM education and it allows children to learn programming easily or teachers to bring the detailed lesson plans into their classroom and embed them in their learning system..
  • It contains a control board, 8 piece RJ11 cables, a USB cable, and 25 piece popular and creative sensors and modules like Fan Motor, DS3231 Clock Module, IR Receiver Module, 2812 RGB Module, OLED Module, Ultrasonic Module, PIR Motion Sensor, etc..
  • A big surprise is that there are no complicated jumpers and soldering, they are convenient to connect using the RJ11 interface, and we also provide Mixly graphical programming tutorial..
  • Mixly is a free open-source graphical for Arduino programming software, based on Google’s Blockly graphical programming framework..
  • This programming learning kit includes 22 interesting and instructive tutorials, step by step to familiarize you with electronic modules, exercise your logical thinking and develop your ideas..
Check Stock

PetSafe UL-275-67D, Dogs, In-Ground Deluxe Ultralight Collar

  • Extra collar with receiver for use with PetSafe In-Ground Fence (NOT compatible with PIG00-13619 and PIG00-11115).
  • Collar is only compatible with PetSafe brand Systems.
  • Adjustable, ultra-light collar for optimal comfort.
  • 4 levels of electric correction and a beep-only warning mode.
  • Includes collar, short probes, receiver, PetSafe RFA-67 battery module and 2 batteries.
Check Stock

Nillkin Wireless ipad Charger Tablet Stand - 2 in 1 ipad Holder Charging Dock, Wireless Charging Stand for iPad Pro 12.9/iPad Pro 11, ipad 8/7/6/5 Gen, Air 4/3, Mini 4 3 2, Samsung Tab S7/S6/S5e

  • 【ATTENTION:Need to buy extra Qi receiver】- Note: The Tablet don’t support wirelress charging function, such us ipad,Samsung Tablet. Please use with wireless charging receiver(NOT include). So you need to buy extra Qi wilreless charger receiver for charging..
  • 【2 in 1 Tablet Stand Wilreless Charger】- 2 in 1 Tablet ipad Holder Dock Wireless Charging Stand. Easy to adjust,Supporting wireless charging when working,playing game,reading and watching videos.Supporting both vertical and Horizontal charging and viewing. Experience your ipad in a whole new way..
  • 【Fast charger】-The wireless charging stand supports fast charging, But it need to be used with QC3.0 adapter or PD adapter(NOT include)..
  • 【Adjustable tablet stand】- You can adjustable the angles depending on your needs. And the position of the wireless charging module can be adjusted, Compatible with tablets of different sizes, Such as iPad Pro 12.9 2020/2018,iPad Pro 11 2020/2018, ipad pro 10.5,ipad 8th/7th/6th/5th/4/3/ generation,ipad Air 4 3 2,ipad Mini 5th/4/3/2, Samsung Tab S7 Plus/S7S6/S5e/S4..
  • 【Detachable design】- Stand and wireless charger can be used separately.The wireless charger module can charging for your phone alone(like Samsung S21 Ultra/S21/S20 Ultra/S20+/S10/S9, Note ....
Check Stock