Top Rf Amplifier
Audiolab DC Block Audio Grade Mains Filter & Direct Current Blocker Black
- The typical mains supply is subject to various kinds of interference and non-linear loads, which distorts the AC waveform. Asymmetrical loads will....
- This typically manifests in 'noisy operation' and acoustically compromised performance. Removing the DC from your mains supply will not only restore....
- As well as DC removal, the audiolab DC BLOCK provides additional mains conditioning and RF filtering, of both common and differential mode noise,....
- KEY FEATURES: Removes DC from AC mains supply. Reduces transformer hum. Reduces RF interference. Improves the performance of audio components..
- Power Requirement: 100-240V ~ 50-60Hz. Peak Load: 600VA. Audio Power Amplifier compatibility: .
Check StockFive Star LTE Filter Improves TV Antenna Signals - HDTV Antennas Signal Purifier - Filters 4G Signal for a Clear Channels - Reduces Interference from Cell Towers - Pass Frequency 5-599Mhz
- FILTERS ALL 4G LTE SIGNAL NOISE - Our LTE filter removes all noise caused by 4G cellular signals, letting through only TV signal frequencies between 5-599MHz, which allows you to experience quality, crisp TV with no cellular interference..
- 4G LTE Filter - IMPROVES TV ANTENNA SIGNALS:4G lte filter removes noise for better picture.
- Cleaning unwanted RF signal out of HDTV antenna system effectively. HDTV Band-pass filter can remove interference from frequency bands(3G/4G) outside the TV band. It can improve the TV signal..
- Improves over the air signals by filtering out mobile LTE signal interference (3G and 4G) which can cause intermittent TV signal disruption including weak signals..
- Simple installation - lte filter for antenna no external power supply required.Head connected to the antenna, tail connected to antenna amplifier or tv. LTE Filter, made only from premium materials, fits any TV antenna or amplifier and improves your signal, giving you crystal clear HDTV every time..
- WORK FREQUENCY: Pass Frequency:5-599MHz. Cleaning unwanted RF signal out of HDTV antenna system effectively,Signal loss is 3dBi or less. Impendance: 75 Ω.
Check StockHDMI Modulator RF Converter RCA Coaxial Composite VHF UHF SDR Demodulator Adapter w/Antenna in/Out & Channel Switch for Roku Fire Stick Cable Box HD Digital AV Component Video to Analog NTSC Coax TV
- ...igital signals into analog TV ( RF )signals which have ultra long distance transmission to achieve watching movies / playing games / sharing program videos pictures / photos on CRT TV or other old televes in different rooms or farther away from the hdmi video source.
- It's a great long range VHF / UHF signal booster amplifier modulators !.
Check StockYuhoo UHF Modulator, Mini TV Link Modulator,TM70 AV to RF Converter with Channel Display, PAL/NTSC Optional Digital Modulator USB Plug & Play(Black), free size
- COLOR CODED CONNECTORS: YELLOW (VIDEO), RED and WHITE (AUDIO).
- Built-in RF amplifier to maintain signal QUALITY.
- Compatibility with all standard consumer video and security devices and cable TV and satellite TV.
Check StockExtreme Broadband MoCA POE-BB1SP-VF 6kV Surge Protection
- Compact POE filters allow easy installations in the tightest spaces. Clear labeling makes customer tampering less likely while maintaing network....
- The unique DataComm feature set allows MoCA communication between the passive data port and all active output ports on the 2000 series Infinity....
- CrossTalk makes the 2000 series Infinity Premise Amplifier the only amplifier available that allows free MoCA communication between all RF outputs.....
- Reduce components and the risk of customer tampering by integrating the POE filter into standard premises equipment such as splitters, ground blocks,....
- Most Extreme Broadband products can be used alone or in combination with other product brands.
- however, when connected together, they bring added....
Check StockE-outstanding 25dB HDTV TV Antenna Light Amplifie 1PC High Gain Low Noise Amplifier Kit TV HDTV Antenna Signal Booster Gain with USB Power Cable
- Professional-grade cable TV and antenna signal amplifier with high 50dB output level. Supports TV coax cable signal from cable outlet, cable TV box, antenna, DTV, CCTV DVR, MATV or all other RF modulated TV system. Designed for large multi-dwelling units(MDU) that require precise RF amplification with gain and slope adjustments for a professional installation..
- High-power amplification to compensate for the attenuations of the passive TV distribution components like cable, taps, splitters and cable outlets. Advanced CATV hybrid circuitry providing extremely low-noise figure and minimum distortion. Adjustable gain control and tilt control allows for easy system balancing..
- Solution in solving the problems of noise, interference and weakness after distribution. Boost RF coax signal with ease for more than 2100FT or 650m if RF TV source signal has fair 70/75dB strength to start with. Boosts the existing CATV or antenna signal strength for greater distance with minimum loss for more TV distribution..
- Adjustable gain/attenuation to reduce overdriving. Adjustable tilt compensation to allow large CATV systems to be properly balanced and mixed with other CATV or existing RF distribution system. Supports full TV frequency range from 40MHz to 860MHz for analog/di....
Check StockDYNASTY PROAUDIO WSA-5RP Wireless Surround Sound Rear Speakers Kit with 2 x 50W Amplifier Built-in, 5.2G / 5.8GHz Dual Band Selectable, Total 106 RF Channel Auto Switching Black (Black)
- ✅[Lossless Audio & low Interference] latest wireless audio technology that supports 5.2 & 5.8GHz dual-band selectable digital wireless with an advanced total 106 RF channel auto selection, to avoid the WiFi interference with your 5G network, for near lossless audio and provides excellent transmission stability.
- ✅[Easy Connection with A/V Receiver System] comes with Speaker Line Level Input and Stereo RCA Input that can receive full band audio from any audio amplifier, A/V receiver or preamp..
- ✅[High Efficiency Amplifier Built-In] 2 x 50W RMS @ 4 ohms load Class D amplifier, allow you to connects directly to any passive bookshelf or the rear surround sound loudspeakers..
- ✅[An additional subwoofer connection] provides an additional subwoofer mono input and output, for connecting between AV Receiver and Power/Active Subwoofer Speaker or Subwoofer Amplifier..
- ✅[Wide Transmission Range] - Up to 100 ft (30M) operational distance between transmitter and receiver (line of sight) with 24-bit 48KHz full CD quality high resolution/uncompressed audio..
Check StockFrequency Converter AD831 Single Chip High Frequency RF Mixer Radio Frequency Conversion Module for HF and VHF Receiver, 0.1-500MHz
- ...s with DC isolation capacitor, easy to use..
- POWERFUL-- The operating frequency of the RF and LO inputs can be as high as 500MHz. IF output is single ended voltage output. With 250 MHz output bandwidth. A single resistor connected between pins OUT and FB is used to set the gain..
- EASY TO USE-- When the mixer's output amplifier and the optimum source impedance, the SSB noise figure of the mixer is 10.3dB at 70MHz. Different from the passive mixer, there is no insertion loss, no need external duplex device, and no need passive termination for AD831..
- APPLICATION-- The AD831 is a low distortion, wide dynamic range, single chip mixer, suitable for HF and VHF Receiver RF-IF frequency, second mixer in DMR base station, DC-baseband conversion, quadrature modulation and demodulation, and ultrasound imaging, frequency shift detection and other applications..
- FEATURE-- The AD831 has provide +24 dBm third-order intermodulation intercept point, realization of -10 dBm LO power, without the need for a high power LO drive..
Check StockMixer Module, Bandwidth Mixing 0.1‑500MHz High Frequency Transducer -10dBm for Quadrature Modulation for Base Station for HF VHF Receiver
- Single Power Supply: The mixer module is designed to be powered by a single power supply, and the RF, IF and LO ports have DC isolation capacitors for easy use.
- 10.3dB SSB Noise Figure at 70MHz: With the output amplifier and optimal source impedance of this mixer module, the SSB noise figure is 10.3dB at 70MHz. There is no insertion loss, no external duplexer, and no passive termination.
- Low Distortion and Wide Dynamic Range: AD831 is a low distortion, wide dynamic range, single chip mixer, very practical.
- -10dBm LO Power Consumption: Provides +24dBm third order intercept point, can achieve -10dBm LO power consumption, without high power LO drivers, there are no corresponding shielding and isolation problems, can improve system performance and reduce costs.
- Wide Application: Suitable for applications such as RF‑IF down conversion in HF and VHF receivers, second mixer in base stations, DC baseband conversion, quadrature modulation and demodulation, and Doppler shift detection in imaging.
Check StockAD831 High Frequency Transducer RF Mixer Module 500MHz Bandwidth Mixing Down Mixing Dual Balanced Mixer Single Chip Radio Frequency Converter -10dBm
- The AD831 is a low distortion, wide dynamic range, single chip mixer, suitable for HF and VHF Receiver RF-IF frequency, second mixer in DMR base station, DC-baseband conversion, quadrature modulation and demodulation, and ultrasound imaging, frequency move detection and other applications.
- The AD831 has provide +24 dBm third-order intermodulation intercept point, realization of -10 dBm LO power, without the need for a high power LO drive.
- There is no corresponding shielding and isolation problems, therefore, compared with the passive mixer to improve the performance of the system, reduce the system cost.
- The mixer is designed as a single power supply, RF, IF and LO ports with DC isolation capacitor, easy to use.
- The amplifier has low DC offset characteristics, so it can be used in DC-baseband frequency conversion and quadrature amplitude demodulation.
Check StockLANTRO JS RF WideBand Amplifier 433MHz 22dB High Gain Low Noise LNA Amplifier
- 【Product Parameters】- Working Voltage: 3---5V.
- Protect-----This strong heavy duty tool bag can protect your tools from water and dust.
- 【Scope of Application】- The product can be applied to various RF receiving front ends, used for shortwave, FM broadcasting, remote control receivers, cable TV signal amplifiers and other RF signal amplifications that require low noise.
- 【Excellent Performance】-The radio frequency amplifier is made of high-quality electronic components and has the advantages of high gain, low noise figure, etc.
- 【Low Noise】- The noise factor is as low and 0.55dB, which is quite small.
Check Stock25ft KMR400 Coax Extension Cable N Male to N Male Connector 50 Ohm Low Loss Coaxial Cables for 3G/4G/5G/LTE/GPS/WiFi/RF/Ham/Radio to Antenna or Phone Signal Booster Use Not for TV
- ...nect the adapter and the coaxial cable . And the length is up to 2.2 in that is longer than others which would prevent the code coming off..
- Compatibility: This ultra low-loss 400 n cable is designed to work with all devices and appliances with 50-Ohm impedance. Works for any 50 Ohm RF system. Such as an antenna and amplifier,and they can be used inside building or outside buildings. It enables perfectly secure connections between an amplifier to both indoor or outdoor antennae, taps, splitters..
- Professionally Made: XRDS -RF is a professional manufacturer in producing coax cable. This n to n jumper is swept with USA KEYSIGHT E5071C ENA network analyzers to assure the vswr of the cable less than 1.1. XRDS -RF is committed to improving the lives of our customers, and this cable will give you unmatched product quality. All of our items come with a full year of warranty..
Check Stock