Top Seamless Low Temperature Pipe
Oatey 30863 Heavy Duty Solvent Cement, 8 Oz, Can, Liquid, Clear
- Heavy duty Clear cement for use on all schedules and classes PVC pipe and fitting up to 12” diameter with interference fit, up to 18” for non-pressure.
- Low-VOC solvent cement meets California South coast air quality management district (SCAQMD) 1168/316a or baaqmd method 40 and various environmental requirements.
- Heavy Duty Clear cement for use on all schedules and classes PVC pipe and fitting up to 12î diameter with interference fit, up to 18î for non-pressure.
- Lo-V.O.C. Solvent Cement meets California South Coast Air Quality Management District (SCAQMD).
- Thick formula fills gaps in large diameter pipe and loose fitting joints.
- Recommended for potable water, pressure pipe, conduit and DWV.
- Recommended application temperature 40°F to 110°F / 4°C to 43°C.
Check StockTOPINCN 50PCS Greenhouse Frame Pipe Tube 3.1in/3.3in Garden Buildings Tube Clip Plastic Film Clip Clamp Connector Kit, Black (8.5cm)
- The greenhouse film clip can be used for plastic film, -proof net, shade net greenhouse fixed, convenient to use..
- Allow quick and easy attachment of tarps, shade cloth or netting to any type of pipe..
- Anti rust and hard to crack. Works well under both high temperature and low temperature..
- The surface is more bright, smooth,very tenacious,no rust fracture phenomenon, resistant to high temperature, cold, longer service life..
- Film clip clamp is used to attach greenhouse film to greenhouse frame pipe..
Check StockHEATIT JHSF 60-feet 120V Self Regulating Pre-assembled Pipe Heating Cable
- JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment..
- Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable..
- Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap..
- ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes..
Check StockHEATIT JHSF 120-feet 120V Self Regulating Pre-assembled Pipe Heating Cable
- JHSF doesn't work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment..
- Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable..
- Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off) and instructions. 120 volt, 3 watts/ft at 50 degrees F. Protect pipes up to 2" in diameter. Can be used by straight, spiral and overlap..
- ETL approved. 2 ft 18/3 cold lead with plug. The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65..
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable. Normally you can feel the slight warm on the heating cable in few minutes..
Check StockUniversal Stainless Steel Motorcycle Exhaust Muffler Noise Sound Eliminator 51mm Exhaust Pipe Baffle Removable Silencer
- [Effective Noise Reduction]:The universal removable exhaust pipe muffler effectively reduce the deep sound while reducing motorcycle noise pollution..
- [Removable] 51mm motorcycle exhaust pipe DB silencer, suitable for most motorcycles, installed at the rear of the exhaust pipe, is a detachable adjustable muffler for easy installation..
- [Low-noise tailpipe]: The exhaust pipe can increase the exhaust pressure, reduce the tail-end noise, make the exhaust smoother, improve the power, and provide you with a good driving experience..
- [Stainless Steel] The exhaust muffler is made of high quality stainless steel, whichis resistant to high temperature and rust and can be used for a long time..
- [Safety And Environmental Protection] During the riding process, the muffler at the end of the exhaust pipe can clearly hear the whistle of the vehicles around the road, which is conducive to safe driving and reduce noise pollution..
Check StockWSDMAVIS 1 Pcs Electric Welding Solder HB-019 Desoldering Rework Tool for Suction Pump
- 30 Watts Electric Welding Solder 110volts.The electric tin sucker sucks while melting, easy to operate..
- The handle is made of high temperature resistant material, with insulating polymer energy efficiency to prevent burns..
- Desoldering Pump,equipped with suction tin button for easy operation..
- Seamless stainless steel pipe, all metal suction nozzle.Power Ac Cord around 47"..
- Ideal for general home, shop, hobby work, fine soldering, and computer work..
Check StockMECCANIXITY Petrol Fuel Line Hose 3/16\ x 5/16\ 3.3ft Blue for Chainsaws Lawn Mower String Trimmer Blowers Small Engines
- Petrol fuel line hose is a very common and useful accessory used in various engines at home and in the garden. Fuel line is used for small engines for chainsaws, string trimmers, blowers, lawnmowers, etc..
- Fuel line hose, is in size of : 3.3ft long, 3/16-inch x 5/16-inch(5mm x 8mm)(ID. x OD.), 1/16-inch(1.5mm) wall thickness.
- The fuel pipe has strong oil resistance and wear resistance, smooth surface, easy installation, and can work normally in low temperature environment. It is a good replacement for the fuel pipe on the engine.
- Steps of installation: 1.Prepare a fuel line hose.
- Please select the fuel pipe of appropriate size, especially the inner diameter and outer diameter of the pipe.
Check StockMECCANIXITY Petrol Fuel Line Hose 3/16\ x 3/8\ 3.3ft Yellow for Chainsaws Lawn Mower String Trimmer Blowers Small Engines
- Petrol fuel line hose is a very common and useful accessory used in various engines at home and in the garden. Fuel line is used for small engines for chainsaws, string trimmers, blowers, lawnmowers, etc..
- Fuel line hose, is in size of : 3.3ft long, 3/16-inch x 3/8-inch(4.5mm x 9.3mm)(ID. x OD.), 3/32-inch(2.4mm) wall thickness.
- The fuel pipe has strong oil resistance and wear resistance, smooth surface, easy installation, and can work normally in low temperature environment. It is a good replacement for the fuel pipe on the engine.
- Steps of installation: 1.Prepare a fuel line hose.
- Please select the fuel pipe of appropriate size, especially the inner diameter and outer diameter of the pipe.
Check StockTOPINCN 100PCS Greenhouse Clamps Clips Garden Buildings Tube Clip Greenhouse Frame Pipe Tube Film Clip Shading Net Rod Clip(20-White)
- CLAMP CONNECTOR TYPE: 2-Black/ 2-White suitable pipe outer diameter:19-2MM, 22-Black/ 22-White suitable pipe outer diameter:21-23MM..
- FUNCTION: The greenhouse clamps clip is mainly used to fix the greenhouse film, sunshade net to connect with the greenhouse steel pipe..
- WIDE APPLICATION: Applications may include greenhouses, garden, cold frames and row covers, etc..
- PLASTIC MATERIAL: New ABS and PC injection molding, with high strength, good toughness, good flexibility..
- EASY TO USE: Allow quick and easy attachment of tarps, shade cloth or netting to any type of pipe. Anti rust and hard to crack, works well under both high temperature and low temperauture..
Check StockMECCANIXITY PVC Petrol Fuel Line Hose 3/16 x 5/16 16ft Pink for Chainsaws Lawn Mower String Trimmer Blowers Small Engines
- Petrol fuel line hose is a very common and useful accessory used in various engines at home and in the garden. Fuel line is used for small engines for....
- Fuel line hose, is in size of : 5mm/0.2-inch inner dia, 8mm/0.31-inch outer dia, 1.5mm/0.06-inch wall thickness, 5m/16ft total length.
- The fuel pipe has strong oil resistance and wear resistance, smooth surface, easy installation, and can work normally in low temperature environment.....
- Steps of installation: 1.Prepare a fuel line hose.
- Please select the fuel pipe of appropriate size, especially the inner diameter and outer diameter of the pipe.
Check StockPATIKIL Thermowell Pipe Immersion Well 1/4 ID 9/32 OD 20 Stainless Steel 304 for Weldless Thermowell Brewing Thermometer 2pcs
- Thermowell pipe is mainly used for sensor protection pipe. Temperature sensors are placed in thermowell pipes, which can be used to measure temperatures, such as water tank temperature measurement and temperature measurement during the brewing.
- Thermowell pipe, is in size of : 6mm/0.24-inch inner dia, 7mm/0.28-inch outer dia, 500mm/20-inch length.
- 304 stainless steel material, sturdy and durable, not easy to rust.
- Easy to use, easy to install and operate.
- Steps of installation: 1. Choose the right size thermowell pipe.
- 2. Remove the thermowell pipe to be replaced.
- Please pay attention to choose the appropriate size of thermowell pipe, especially the diameter and length of the thermowell pipe.
Check StockTOPDURE JHSD 3-feet Pipe Heating Cable Built-in Thermostat
- ROOF HEAT CABLE - keeping your pipe/water lines/roofs/gutters from freezing during the winter,functioning perfectly for plastic and metal pipes, all kinds of roofs, keep the water flowing in gutters.
- SELF-REGULATING TECHNOLOGY - the cable output will change automatically depend on the ambient temperature, the output goes up when the temp is low and goes down when it's high, saving energy and electricity for you, illuminated plug lets you see if the heat cable is working from a distance.
- HEAVY DUTY CABLE - 6FT cold lead and 6FT/18FT heat cable is commercial grade for long-time and heavy-duty usages, PVA out jacket, 5W/ft under 50°F for heating pipes.
- EASY TO INSTALL - pre-assembled for quick installation, the heat cable can be straight-traced or spiral on the pipe, be aware that the lowest installation temperature is 14°F and the maximum exposure temperature is 221°F.
- RELIABLE FOR HEATING PIPES - UL and ETL cerfied, illuminated plug lets you see if the heat cable is working from a distance, please test the cable before the installation, 1 Year warranty provided.
Check Stock