Top Servo To Ttl Board

EVISWIY PL2303TA USB to TTL Serial Cable Debug Console Cable for Raspberry Pi 3 Pack

  • 【Built-in PL2303TA Chipset】- this usb to ttl serial cable with built-in PL2303TA chip is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port..
  • 【Wide OS Support】- this usb ttl serial cable is supported by most common OSes such as win XP/VISTA/7/8/8.1/10/ Mac OS X/Linux. (please refer to http://www.prolific.com.tw/US/ShowProduct.aspx?p_id=225&pcid=41, and then download the Prolific 2303 driver). If you are running Linux, drivers are already included in the kernel, no need to install anything..
  • 【Power Output】- this usb debug cable can be configured for either v5 or v3.3 power output. Built-in PL2303 chipset has an on-board DC-DC converter..
  • 【Wide Application】- this pl2303 usb ttl cable widely used for laboratories, product testing and low cost MCU communications etc..
Check Stock

ELEGOO 8 Channel DC 5V Relay Module with Optocoupler Compatible with Arduino UNO R3 MEGA 1280 DSP ARM PIC AVR STM32 Raspberry Pi

  • 5V 8-Channel Relay interface board, each one needs 70mA Driver Current.
  • Equiped with high-current relay, AC250V 10A.
  • Each relay has normally open and normally closed contact. Can be selected by jumper relay and TTL or ground..
  • With power indicator,8-way road has a status indicator. With a relay coil to absorb the diode protection..
  • Standard interface that can be controlled directly by microcontroller (Arduino , 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
  • The 8 channels are optically isolated, safe, reliable, anti-interference. Widely used for all MCU control, industrial sector, PLC control, smart home control。For a complete data sheet for this relay board, please download it from: http://dwz.win/UhW.
Check Stock

DTECH FTDI USB to TTL Serial 5V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 10 8 7 Linux MAC OS 6ft Black

  • 6 ft FT232 USB to TTL serial adapter (with 6 pin 0.1” pitch female socket header) connects devices with 5V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (6 way outputs, Single-In-Line ) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header 5V TTL to USB converter cord is compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 11 10 8 7 Linux 6ft Black

  • 6 ft FT232 USB to TTL serial adapter 3.3V (with 6 pin 0.1” pitch female socket header) connects devices with 3.3 V logic level UART signals....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable 3V3 (6 way outputs) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND (power line provides 5V and data....
  • FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 6 pin header USB TTL UART converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, MacOS, Linux 2.4 and greater.
Check Stock

DTECH FTDI USB to TTL Serial 3.3V Adapter Cable TX RX Signal 3 Pin 0.1 inch Pitch Female Socket FT232RL Chip Windows 11 10 8 7 Linux MAC OS 6ft Black

  • 6 ft USB to TTL serial adapter (with 3 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a....
  • A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet FTDI USB to TTL serial cable (3 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx and GND.
  • FTDI chipset on the PCB board has configurable internal EEPROM and 3.3V UART signals can be individually inverted by configuring the EEPROM.
  • 3V3 TTL to USB converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater.
Check Stock

6Pcs ShareGoo JR Style Servo Splitter Cable, 2.75' Servo 1 Male to 2 Female JR Y Harness Y Cable Extension Wire for RC Models Car Airplane Helicopter Drone Boat

  • Used for RC cars trucks airplanes helicopters rc boat servo connection, receiver connection and flight control board..
  • This servo Y-cable allows you to control two servos with one radio channel..
  • Material: 22AWG silicone wire.Wire Length: 7CM/2.75".
  • 3Pin wire cable.Male JR plug to 2 Female JR plug Y Harness cable..
  • Pack of 6 JR style servo splitter cable,unique design, professional quality JR style connectors..
Check Stock

1pcs 1-Bit AC 220V Optocoupler Isolation Module

  • Output TTL level can be detected with the microcontroller. The power supply can be 3-5V.
  • the PLC input terminal of the PLC COM power supply 24V input termination of the board signal output OUT, optocoupler board GND power negative.
  • When the power module in the power of the board after the white wire frame can not touch any device .. because it is high voltage. Note the safety of electricity.
Check Stock

DTECH USB to TTL Serial 3.3V Adapter Cable TX RX Signal 4 Pin 0.1 inch Pitch Female Socket PL2303 Prolific Chip Windows 10 8 7 XP Vista (6ft, Black)

  • 6 ft USB to TTL serial adapter (with 4 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a laptop via USB port.
  • A genuine PL2303TA chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates.
  • 6 feet USB to TTL serial cable 3V3 (4 way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx, VCC (5V) and GND.
  • PL2303 Prolific chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM.
  • 4 pin 3.3V USB to TTL converter cord Compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE.
  • ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc..
Check Stock

Doesbot GRBL 1.1 A4988 Control Board CNC Controller Router CNC Engraving Machine Control Board 3018 3 Axis USB Control Laser Board Corexy Open Source with External Driver Interface

  • Input voltage (board power supply): 12V to 24V.
  • Support 12V, 5V with TTL and without TTL laser.
  • Support external Offline Controller(Optional).
Check Stock

DSD TECH USB to TTL Serial Adapter with FTDI FT232RL Chip Compatible with Windows 10, 8, 7 and Mac OS X

  • With this USB to TTL adapter, you can establish communication with your board/MCU through your computer. Maximum transmission speed up to 3Mbps.
  • The main chip is FT232RL from FTDI ,High stability. LED indicator for TX,RX,Power,It is very useful when you are debugging or downloading..
  • Support VCC output 3.3V and 5V, switch by jumper..
  • Works with Windows 10, 7(32/64bit) Vista 2008, XP, 2003,Mac Etc..
  • WARRANTY:We back this FDTD USB to TTL Converter with 12 months warranty.If you meet any question, Please contact us, We will fix your issue within 24 hours..
Check Stock

KEYESTUDIO 16-Channel 12-bit Servo Motor Driver Board I2C Interface for Arduino

  • This expansion board can directly stack on the controller R3 board and can drive up to 16 servos.
  • Uses I2C input, just occupy A4 and A5 interface on the control board.
  • Contains PCB double sided holes, can direct to solder with components to build up prototyping circuits.
  • Servo power supply independent V + input up to 6V.
  • How to use: Search for "keyestudio wiki KS0258" in Google Chrome to get the wiki online tutorial for this product..
Check Stock

Arduino Uno 3 Ultimate Starter Kit Includes 12 Circuit Learning Guide

  • This is the ultimate Arduino Uno kit enough to get you started with hundreds of arduino projects.
  • Bread Board — Holder — Jumper Wires — USB Cable — LEDs — DC Motor — Small Servo — Relay.
  • Includes a total of over 190 electronic parts and components.
Check Stock