Top Signal Surge Arrester

Baomain SSR-60DA 60A Solid State Relay Module 4-32VDC / 24-480VAC + Heat Sink

  • Photocoupler isolation between input control signal and controlled power, isolation surge voltage up to 7500V..
  • Input signal turn-on voltage DC 3 to 32V, turn-off voltage DC 0 to 0.8V. LED indication for relay turn-on..
  • Output voltage range: AC 90 to 250V(50/60Hz). Maximum on-state average current 3 Amp. Maximum on-state current 10 Amp (003c 10 seconds). Non repetitive surge peak on-state current: 120 Amp (003c20mS). Load type: General purpose..
  • This is a simple and practical solid state relay module, which is very convenient to use, for Arduino, Raspberry Pi, ESP32, PLC or other projects. The GPIO of these controllers are directly connected to this relay input to control the mains power, and it is suitable for most loads less than 350 Watts (for 115VAC)/700 Watts (for 230VAC)..
  • Compact ABS plastic case and wires connect for easy mount. Two screw mounting holes are convenient for you to fix it on the wall or wooden board. Of course, you can also choose not to lock the screw..
Check Stock

SEDNA - SE-ADSL-SPL-01 Telephone RJ11 Line ADSL Modem Filter/Splitter with surge protector

  • Separates voice signal and ADSL digital signal from telephone line.
Check Stock

Justrite 7250330 AccuFlow 5 Gallon, 11.75\ OD x 17.50\ H Galvanized Steel Type II Blue Safety Can With 1\ Flexible Spout

  • Large ID zone permits user labeling of contents to avoid misuse.
  • Stainless steel flame arrester for exceptional corrosion protection – reliably dissipates heat to prevent flashback ignition.
  • Long 3-1/2" (88mm) length arrester allows safe, secure placement of gas nozzle.
  • Gasoline, Gas-Oily Mixture, Kerosine, Diesel.
  • Ergonomic offset fill port with comfort lift lever makes filling easier than ever Easy-to-use Safe-Squeeze trigger for accurate control of liquid flow.
  • Self-closing lid controls vapors and spills.
Check Stock

B/M Stainless Steel Chimney Spark Arrestor Rain Cap for 2.36inch/6cm Stove Pipe

  • Fire resistance: The top of the fire resistance tube is closed and there are mesh holes around it to prevent some sparks from flying out. The enclosed top also ensures that rainwater does not flow into the fireplace from the furnace pipe when it rains or snows..
  • With 3 Fixed Rings: There are 3 rings at the bottom of the flame arrester, and you need to prepare 3 resistant hot wire fixed. Installed after the flame arrester will not worry about the wind weather..
  • Thickened Stainless Steel: Straight tube thickness of 0.5mm. Stainless steel material can be very good rust resistance..
  • Tight Connection: Elbow and straight pipe (not included) are tightly connected and can be used together..
  • Suitable Size: Straight tube length is about 10.31in/26.2cm, and the diameter 2.36in/6cm..
Check Stock

5 PACK Filter, MoCA

  • The products include the following items: 2-Way Coax Cable Splitter 5-2300MHz Coax POE Filter.
  • 2 Way Coax Cable Splitter5-23 00 MHz (2.4GHz) RF bi-directional digital coax/coaxial cable splitter for CATV, satellite and MoCA configurations ..
  • 2 Way Coax Cable SplitterInternal circuit board for better reliability/durability.Low signal loss of 3.5db on each output port improving performance and speeds..
  • POE Filter Bandstop provides a typical 35-45dB of rejection in the MoCA 1125-1525Mhz band. IEEE 6KV A3 surge survivablity is provide for additional network protection..
  • POE FilterDevice's technology is recommend for TiVO Whole House DVR applications.Signal loss in the Cable TV ops band of 5-1002MHz is 1.5dB or less.
Check Stock

Lightning arrestor N Female to N Female Bulkhead Coaxial WiFi Lightning Surge Protector IP67 with 90 V Gas Tube 50 Ohm DC-3GHz

  • 1.Lightning arrestor,Protects 3G,LTE Cellular Boosters and 2.4 GHz WiFi Access Points and GPS Receivers from lightning strikes, Requires additional ground cable.
  • 2.N female to n female Bulkhead lightning with a rubber O-ring seal for mounting through an enclosure wall, Body brass nickel plated, Contact brass gold plated ,Teflon(PTFE) Insulator for a reliable signal every time,Salt spray test for 48 hours.
  • 3.50 ohm lightning surge protector,Frequency Range up to 3 GHz / Attenuation is less than 0.2 dB / VSWR ≤1.2( DC-3Ghz),waterproof level is IP67.
  • 4.N arrestor,It has a replaceable gas discharge element with High Surge Power Capability ( 90V Gas tube).
  • 5.N Surge protector should be installed as close a possible to the equipment to be protected, often at the point where the coax cable enters the building.They can also be installed near the antenna for additional protection.
Check Stock

WAVLINK WiFi Range Extender AC600 Dual Band 2.4GHz & 5GHz High Power Wireless Access Point Weatherproof Signal Booster Amplifier with PoE & 2 Antennas Used for Outdoor Wi-Fi Coverage

  • ...ss point (AP), repeater or as a router. Weatherproof RJ45 Connector and integrated Power over Ethernet support, allowing this device to be installed in areas where power outlets are not readily available and support 3 LEDs wireless signal strength..
  • ✔Design for Harsh Outdoor Environment ☞ Build in lightning arrester (15kV ESD) and Weather-resistant, IP66 rating keeps you connected outdoor and withstands harsh outdoor conditions. Industry-leading hardware ensures that it can be deployed in a wide variety of environments, withstanding broad ranges of humidity and temperature (-30°C~70°C) (-22°F~158°F). ♥♥♥WAVLINK offer one year warranty and 30 day money back or replacement. If you have any questions, please feel free to contact us.✉✉✉.
Check Stock

GIMILINK Coaxial Lightning Arrestor Surge Protector Protection 75 Ohm F Type Male to F Female for Satellite Cable TV 2G 3G 4G Cell Phone Signal Booster LTE Antennas

  • Protect your signal boosters amplifier system from dangerous lightning strikes or electrical surges by installing the lightning arrestor between the....
  • Easy install designed and manufactured the lightning surge protector with high quality nickel plated brass to provide superior performance and....
  • 75 Ohm F Type Male to F Female compatible with 75 Ohm Cell Phone Signal Boosters, CATV, Satellite Cable TV antennas.
  • Standard 90 V DC breakdown voltage gas discharge tube (GDT) element which can be easily replaced to provide multistrike capacity.
  • Broad bandwidth 0-3 GHz covers 2G 3G 4G LTE cellular signal boosters and SATV.
Check Stock

Electroline EDA2100 Bi-Directional Signal Booster 1-Port Cable Modem TV HDTV Amplifier with Passive Return (Retail Package with 5-Year Warranty)

  • Signal booster drop amp: 1 ports with a +15dB boost per port, boosts your signal strength 32X.
  • Protection: 6 KV surge protection on all outputs.
  • Expected results: will improve HDTV reception.
  • Ultra small form factor for ease of installation in confined spaces.
  • Reduces snow and prevents image pixelation with digital cable.
Check Stock

Professional RF Cable TV Signal Amplifier with High 40dB Gain

  • Professional-grade cable TV and antenna signal amplifier with high 40dB output level. Supports TV coax cable signal from cable outlet, cable TV box, antenna, DTV, CCTV DVR, MATV or all other RF modulated TV system. Designed for large multi-dwelling units(MDU) that require precise RF amplification with gain and slope adjustments for a professional installation..
  • High-power amplification to compensate for the attenuations of the passive TV distribution components like cable, taps, splitters and cable outlets. Advanced CATV hybrid circuitry providing extremely low-noise figure and minimum distortion. Adjustable gain control and tilt control allows for easy system balancing..
  • Solution in solving the problems of noise, interference and weakness after distribution. Boost RF coax signal with ease for more than 1700FT or 500m if RF TV source signal has fair 70/75dB strength to start with. Boosts the existing CATV or antenna signal strength for greater distance with minimum loss for more TV distribution..
  • Adjustable gain/attenuation to reduce overdriving. Adjustable tilt compensation to allow large CATV systems to be properly balanced and mixed with other CATV or existing RF distribution system. Supports full TV frequency range from 40MHz to 860MHz for analog/di....
Check Stock

Arris 4-Port Cable, Modem, TV, OTA, Satellite HDTV Amplifier Splitter Signal Booster with Active Return and Coax Cable Kit

  • The BDA-42-4-AR-R is a bi-directional active return cable TV amplifier designed for use in homes. Boosts signal by 5x forward, 2x reverse. It is Manufactured by Arris..
  • An active return path boosts upstream signal for broadband devices such as set-top boxes and cable modems. Active return is recommended when Upstream Modem power level is greater than 48 dBmV..
  • Meets all applicable IEEE surge standards for all output ports, which enhances system reliability. Weather seal and protective coating allow use of the amplifier for indoor or outdoor applications. 36" White connection cable and PCT-TT installation tool included..
  • NOT FOR USE WITH SATELLITE DISH SYSTEMS. It will block the signal between the dish and receiver. NOT FOR USE WITH ANTENNAS. Active return amplifiers should not be used with antennas, and may cause total loss of OTA signals..
Check Stock

Arris 2-Port Cable Modem TV OTA HDTV Amplifier Splitter Signal Booster with Passive Return and Coax Cable Kit

  • The BDA-42-2-PR-R is a Bi-Directional Cable TV Amplifier and over-the-air (OTA) HDTV amplifier designed for use in homes. Boosts signal by 12x in the....
  • Compatible with all standard and digital Cable TV services. The amplifier should be installed BEFORE splitters and long cable runs for best results.....
  • Meets all applicable IEEE surge standards for all output ports, which enhances system reliability. Weather seal and protective coating allow use of....
  • NOT FOR USE WITH SATELLITE DISH SYSTEMS. It will block the signal between the dish and receiver. NOT FOR USE WITH AMPLIFIED ANTENNAS. Using with an....
Check Stock