Top Stb Power Supply Board

ACTIMED PCIE Riser 1X to 16X GPU Riser (6PIN/MOLEX/SATA Powered) 10 Capacitors, PCI Express Risers Adapter Card for BTC/ETH/GPU Mining Rigs, with 60cm USB 3.0 Cable and LGB-7 Color Lights, 6 Pack

  • ...16 slot. Will provide a safe and reliable connectivity with more PCIE X16 graphic cards. Will be mainly used on BTC Ethereum Mining rigs or GPU Mining rigs..
  • 【10 High-quality solid capacitors】10 FP independent solid capacitors are customized for the graphics card power supply. Compared with the general 4-8 capacitors, the graphics card power supply can be more stable and safe. effectively solving the problem of insufficient power supply capacity.Build in electric circuit protector keep device away from over current, over heat and over voltage..
  • 【3 power supply methods】3 power supply methods are used: SATA power interface, 6Pin power interface, and 4-pin interface power supply.Multiple power supply methods solve the problem of power mismatch. Reduces the power supply burden on the motherboard and can be freely selected according to the actual usage environment.(Please reserve 10W power supply for riser when configuring power supply).
  • 【Steel graphics card slot】The middle graphics card slot is a reinforced metal structure. Compared with the plastic bayonet, the metal bayonet has a tighter structure. Specially ....
Check Stock

HiLetgo BTS7960 43A High Power Motor Driver Module/Smart Car Driver Module for Arduino Current Limit

  • 5V isolate with MCU, and effectively protect MCU.
  • Voltage indication of motor driver output end.
  • Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2).
  • isolation chip 5 V power supply (can share with MCU 5 V)..
  • Able to reverse the motor forward, two PWM input frequency up to 25kHZ.
  • two heat flow passing through an error signal output..
  • Isolated chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply.
Check Stock

ARCELI ESP-12E ESP8266 UART WiFi Wireless Shield Compatible with Arduino UNO R3

  • Standard pin interface to achieve full compatibility with the pitch Arduino Uno, Mega and so on. (Unless the standard size arduino, such as Nano, Mini).
  • 3.3V power supply using advanced chip (with the official expansion board power chip CC3000 same), so 3.3V Arduino board provided more accurate, so ESP8266 as official cc3000 chip work as normal, there is no gap..
  • It leads to a WiFi module power supply / service interface to facilitate developers to extend the power supply and maintenance..
  • Onboard ESP8266-12 stable industrial grade serial WiFi module, using an enhanced PCB antenna, signal better..
Check Stock

Pedal Board,With Completely Isolated Power Supply ,19*5 Inch 1.8 LB Aluminium Alloy Guitar Pedalboard, Included Carrying Bag , Pedal Cable,Charger,40*1.2 Inch Self Adhesive Hook Loop Tape,Cable Ties

  • ISOLATED POWER SUPPLY:The pedal board is equipped with a completely isolated power supply, which is more convenient to use, eliminating the trouble of carrying an additional power supply,Just need to connect the pedalboard and pedals..
  • INDEPENDENT SHORT CIRCUIT PROTECTION:includes 7 ways 9V 200mA, 1 way 12V 200mA, 1 way 18V 200mA, 1 way USB 5V 500mA.One output is short-circuited, other outputs can still work.The guitar pedals board power supply has a noise reduction function and direct current increases the stability during use..
  • ALUMINIUM ALLOY MATERIAL:High-strength aluminum alloy integrated die-casting guitar effects pedal board,which is solid to hold and protect the pedals nicely and durable to use..
  • PERFECT DETAILS DESIGN:Slight incline design more comfortable for you to step pedals on the board and the frosted surface offers no worries for scratches.Rubber feet make the pedal is quite stable..
  • ALL IN SUITE ACCESSORIES:The whole piece of customized hook surface velcro and professional grade adhesive backed hook-and-loop for securing pedals. Coming with pedalboard carrying bag , guitar pedal cable,Charger,40*1.2 Inch self adhesive hook loop tape,cable ties.
Check Stock

Sovvid Guitar Pedal Power Supply - Pedal Board Power Supply 10 Isolated DC Output for 9V/12V/18V Effect Pedal Guitar Power Supply Pedal Power Adapter with Short Circuit and Ovrcurrent Protection

  • 【10 Isolated Output, Stable Current】: Sovvid pedal power supply is very safe and secure. 10 isolated output has separate short circuit protection. Short circuit in one channel won't affect other channels' function. This pedal board power supply can produce perfect tone and supply stable current. It includes 9V 100mA port x 6, 9V 500mA port x 2, 12V 100mA port x 1, 18V 100mA port x 1..
  • 【Noise Free, Heat Dissipation】: Sovvid pedalboard power supply has built-in powerful noise filter and good shielding effect. Which makes the radiation and current noise in a very limited range. And the premium quality chips has perfect heat-dissipating performance than other pedal adapter. There is enough space inside the equipment for rapid cooling. You will get a clear and firm sound when playing..
  • 【Short Circuit and Over Current Protection】: Each port has separate short circuit and over current protection. When one port is short-circuited or get current overload due to misuse or accident, this guitar power supply will protect your pedal board main body and protect it from damage..
  • 【LED Indicator, Robust Steel Casing】: The Blue LED lights will indicate the short short-circuit or overload problem. When Turn on LED indicator switch, short-circuited channel ....
Check Stock

C25S - Smooth Stepper Terminal Board

  • Full access to all the pins of the Smooth Stepper Board. Connects directly to the Smooth Stepper (from Warp9). The board is provided with sockets that allow the Smooth Stepper Board to be plugged directly into this board. No ribbon cables required. When using the Smooth Stepper board there is no need to use an additional power supply to power the board. It will draw power from the Smooth Stepper board. Built-in Passive Low Pass Filters for the all inputs..
  • C25 Smooth Stepper Breakout Board with push lock terminals.
Check Stock

GeeekPi Raspberry Pi 4 SATA Storage, Raspberry Pi 4 Model B 2.5 inch SATA HDD/SSD Expansion Board X825 V2.0 USB3.0 Shield (Only for Raspberry Pi 4B)

  • Only For Raspberry Pi 4 Model B, supports up to 4TB 2.5 inch SATA hard disk drives (HDD) / solid-state drive (SSD), Only 2.5 inch SATA interface HDD/SDD hard disk is suitable for X825 board.
  • X825 Case,please refer to ASIN: B093WYWVRX.
  • Power supply request: AC 100 - 240V input 50 / 60Hz, 5V DC 4A output , Please use high quality DC 5V 4A power supply, highly recommend to use ASIN: B07YJDS71K(With TUV,FCC,RoHS,CE Certifications). If you get low quality power supply to use, it may probably will damage your 2.5 inch HDD/SSD or not recognize the HDD/SSD ..
  • OS compatiable: All Raspberry Pi operating systems.
  • USB 3.1 Gen1 to SATA 6Gb/s Bridge Controller.
  • Package Includes:1 x X825 V2.0 Expansion Board, 1 x USB 3.1 connector ,1 x Mounting Screws Pack.
  • Note: The Raspberry Pi 4B board and the 2.5" SATA HDD/SSD are Not Included.
Check Stock

Orange Pi Zero 512MB SDRAM AllWinner H3 Quad Core, Open-Source, Android 4.4, Ubuntu, Debian, Single Board Computer (Zero 512+White case+OTG Power Supply)

  • Orange Pi Zero uses Allwinner quad-core A7 high-performance processor Allwinner H3, integrated Ethernet, 100M onboard network port, onboard storage, USB OTG power supply, USB2.0 port, etc. Note: Our shipping time generally takes 15 days, Not as long as Amazon suggests..
  • Orange Pi Zero open source development board integrates on-board network, on-board storage, LED indicators, low-level peripherals, and is compatible with Raspberry Pi GPIO ports, and has a unique debugging serial port, etc..
  • 512MB DDR3, Onboard Network. One USB 2.0 HOST, one USB 2.0 OTG USB OTG can supply power.
  • Include: Orange Pi Zero 512 Single Board Computer+White Case+OTG Power Supply.
  • Orange Pi Single Board Computers can builed a computer, a wireless server, Games, music and sounds, HD video, a speaker, Android, Scratch.Pretty much anything else, because Orange Pi is open source..
  • Notice before order: By default, we won't responsible for customs clearance fee charged by your local. If you have any questions, pls contact with Amazon servic.
Check Stock

VU Meter 2x Panel VU Meter Warm Back Light Recording & Audio Level Amp with Driver Board

  • L/GND/R: This driver board with low level signal input terminals for connections are CD players, computer sound cards, the first stage, and other audio signal source device, wiring L, GND, RW respectively: Left, the right channel.
  • Power Consumption:Input AC / DC 12V-15V power supply for the drive plate. (Recommended independent power transformer, or a separate power supply for the winding. the backlight current is 45 mA when drive plate off work.
  • 2 Resistor:R1 and R2 are two adjustable resistors of driver board,which can control the size of the hands swing..
  • Rectifier RegulatorThe backlight DC12V power meter is used for rectifier regulator of the backlight driver board Please notice that the positive and negative head interface..
  • Package Content:2 x VU Panel Meter+1 x Driver Module+1 x Cable.
Check Stock

uxcell 300mA 3W LED Chip Bulb Surface Mounted Devices Light Beads Warm White Super Bright High Power or Floodlight 4pcs

  • High Power LED, saving power,very low heat generating..
  • Note: The LED lamp board must be powered by constant current LED driving power supply, and the output parameters of the power supply are consistent....
Check Stock

RuiPuo HDMI to Component Converter HDMI to YPbPr Adapter Converter 1080P HDMI to RGB Converter for PC, Xbox, PS3, Roku, DVD Players

  • HDMI to component converter: Connect the HDMI source device to the YPbPr display (for example: input DVD through the HDMI cable to YPbPr TV playback).
  • No drivers needed, easy to install and operate. Plug and Play. Widely used with Blu-ray DVD, STB, PS3, PS4, Fire Stick, PC and all kinds of devices with 1080P HDMI output..
  • The product supports the highest resolution is 1080P, and does not support 3D and 4K (need to reduce the resolution of 720P, 1080P or lower).
  • Note:This is HDMI to component component converter. Reverse use is not supported. component to HDMI converter is not supported..
  • In order to ensure that the product works as expected, please connect it to the power supply. Package list contains: 1 x HDMI to component converter, 1 x HDMI cable, 1 x power adapter, 1 x USB power cable, 1 x user manual..
Check Stock

DGHAOP PC Case Fan Governor PWM Temperature Control 3Pin/4pin PCI Cooling Fan Speed Controller SATA Power Supply

  • The product is committed to bringing you a better computer fan controller, which can maintain the fan speed according to the speed you need.
  • The product can be connected with 3 groups of fans to adjust.
  • Fan interface: Small 3 / 4Pin fan interface.
  • Power supply interface: 4P interface of power supply.
  • The speed regulation mode is knob adjustment.
  • The product is designed on the PCI backplane of the computer, which can be more convenient for your adjustment, use and installation.
  • Built in control chip with pure aluminum heat sink for stable operation.
  • The control board is equipped with blue light indicator.
  • The speed regulation is connected to the computer power supply, with a large 4P interface for power supply. One interface meets the power supply needs of three fans, and the power supply and speed regulation are combined in one.
Check Stock