Top Temperature Module

DC 12V Electronic Temperature Controller Programmable -50 to 110 Degree Celsius Heating/ Cooling Thermostat Control Switch Module NTC Waterproof Sensor Probe Dual Color LED Display Monitor 2 Pieces

  • What will receive: you will get 2 pieces of DC 12V 200 mA temperature controllers, the measurement temperature is from -50 to 110℃(-58 to 230℉),....
  • Dual color LED display: this digital thermostat control module of dual color LED display, which show the measured temperature (red) and set....
  • Waterproof design: the NTC (10K 0.5%) probe is waterproof, and you can control the temperature at will, can also control heating or cooling according....
  • Reliable to use: the electronic temperature control switch module has been tested for consistency and reliability, and its control accuracy is 0.1....
  • Wide application: the electronic thermostat can be widely applied in intelligent home and industrial equipment, suitable for household appliances,....
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...h Buttons with multicolored caps -Joystick Module type PS2.
  • -RC-522 RFID Module with white RFID Card and RFID Keychain -High-precision RTC Real-Time Clock Module DS3231 and EEPROM AT24C32 -PIR Presence Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4....
Check Stock

HoTech 2' & 1.25' SCA Laser Collimator for Newtonian Telescope - Crosshair Model # SCA-2C

  • Retain only one optimal gear position brightness.
  • Standard hex wrench to self-calibrate coaxial problem.
  • The spot shape is a dot not a grainy elliptical point.
  • The module adopts high-end spherical module, high sensitivity and easy adjustment.
  • Adopts 3-piece glued optical glass lens for stable spotting better focusing effect and less halo.
  • Make the spot shape is a dot instead of a grainy elliptical point.
  • External effects of the product during transportation and use may cause off-axis problems.
  • You can calibrate the coaxial problem yourself by giving away the standard hexagonal wrench.
  • CNC precision lathe machining of the laser unit has a front opening from which the laser beam can be emitted.
  • Resistance to sudden changes in temperature difference.
  • The sudden temperature difference does not change the spot size.
  • It is resistant to extreme cold weather and can be used under extremely cold weather of minus -30 degrees Celsius without affecting the use effect.
Check Stock

CDM324 Microwave Module, 24GHz 15m Doppler Radar Smart Microwave Body Induction Module Single Channel Switch Intelligent Sensor Module

  • ...his is a microwave sensor module for detecting moving objects and human body. Widely used in human body sensing lighting system, anti-theft alarm system..
  • 【Parameter】 Advanced low consumption PHEMT oscillator, Provide various frequency range standards: -UK,-F,Operating Temperature:-20~60℃..
  • 【Independence】Independent transmitting and receiving route, can get the big gain. The module has many advantages such as high sensitivity, long sensing distance, wide sensing angle, high reliability, wide range of operating voltage..
  • 【High performance】 Single channel operation. High sensibility, high flexibility, low cost, operating distance is 15m. Not influenced by temperature, humidity, noise, air flow, dust, ray etc, adaptive to terrible environment.
Check Stock

Major Brands 8085A Microprocessor Unit, CISC, 8-Bit, HMOS, 3MHz, 40-Pin, CDIP, 15.37 mm W x 4.95 mm H x 52.96 mm L (Pack of 2)

  • AITIAO RTC clock module temperature range: -40 ° C to +85 ° C,the precision of digital temperature sensor is ±3°C.
  • the timing accuracy kept at ± 5ppm (± 0.432 sec / day).
  • AITIAO DS3231 High Precision RTC Clock Memory Module are CONVENIENT TO USE，because itself can be adapted to 3.3 V and 5 V system, no level conversion, it is super convenient.
  • Complete clock calendar functions include seconds, minutes, hours, day, date, month and year timing, provide valid until the year 2100 leap year.
  • Package Includes: 4Pcs DS3231 High Precision RTC Real Time Clock Module (battery are included).
Check Stock

Honeywell YTH5320R1025 Wireless Non-Programmable FocusPRO Kit with Wireless Adapter Allows to be Used with TrueZONE Panel

  • WIRELESS FOCUSPRO THERMOSTAT: Same great features of the FocusPRO thermostat – now wireless. Installs in minutes. Displays outdoor temperature and humidity. 2 month low battery warning. Dual Fuel enabled..
  • EQUIPMENT INTERFACE MODULE (EIM): All HVAC equipment is wired to the module. Module receives communication from the wireless devices..
  • RETURN AIR SENSOR: Works with the Equipment Interface Module to maintain safe indoor temperatures if power is lost at the wireless thermostat. Maintains 62 F for heating and 82 F for cooling..
  • REDLINK WIRELESS TECHNOLOGY: Powered by RedLINK reliability. No interference with other wireless devices in the home..
Check Stock

VNSZNR BMS Board LiFePO4 4S 12V 250A Smart PCB Battery Management System with Balance Leads Wires and Wireless Module for Lithium Iron Phosphate

  • ...irst,then B- P- can be conductive,voltage from P- can be same from B-, then BMS can work well..
  • ★【Module】Available connect with Android and IOS App and can review the battery status in real time by mobile phone. Through module can set the battery capacity, protection temperature, protection voltage and etc..
  • ★【BMS Activation Method】Method ①: Press the button on the module to activate the bms directly.Method ②: Charge activation, B-line must be connected to the total negative pole of the battery pack when charging. If Method ① fails to activate the BMS, try Method ② to activate the BMS..
  • ★【VNSZNR BMS】The BMS was be manufactured by high quality Mos and IC. Keep your battery long cycle service life time. Extreme low power consumption. The consumption of the whole device is less than 50uA.PCB use high anti-corrosion, high water resistance, high impedance ESD conformal Coating.It is waterproof, dustproof and shockproof..
  • ★【VNSZNR BMS】What You Get: 1pcs*VNSZNR BMS Lifepo4 4S 12V 250A, 1pcs*module, 1pcs*balance cable and 1pcs*English manual,Package also com....
Check Stock

Gel Heating Machine,Portable PRP PPP Gel Maker Heater,Plasma Bio-Filler Equipment,Instrument Autologous Serum Filler with Digital Display for Laboratory Hospital

  • 【Intelligent Function】Gel heating machine has real-time temperature display, time countdown display, automatic fault detection and buzzer alarm function, temperature deviation calibration function, and built-in over-temperature protection device. Features:Voltage: 110v/60Hz,Temperature range: room temperature + 5℃~100℃,Time range: 1min~99h59min/∞,Temperature accuracy: ≤±0.3℃,Display accuracy: 0.1℃,Heating time: ≤12min (25℃ to 100℃),Power: 150 watts,Fuse: 250V 3AФ5×20,Size: 10x7.7x6in,Net weight: 2.5 kg..
  • 【LCD Display】Portable PRP PPP gel maker heater has easy module replacement, easy to clean and disinfect, beautiful appearance, blue LCD display instant parameter information..
  • 【High Precision, Automatic Recovery Function】Optional power failure automatic recovery function, automatic start running function, improve efficiency, intelligent algorithm, ensure the whole process temperature control accuracy ≤ +03C, effectively reduce the experimental error..
  • 【Multiple Protection】Plasma bio-filler equipment can ensure the stability of long-term operation and safety in the case of unattended op....
Check Stock

NUHFUFA HSU-07 Humidity Module Humidity Sensor Module Dehumidifier Replacement Accessories Part

  • Humidity Sensor Module Temperature Sensor Fit for many kinds of dehumidifiers. Please confirm the model number of the module before purchase, you can refer to the picture on this page..
  • Good anti-interference ability and stable performance, improving machine working efficiency. Replacement is the original disassembled accessory, please do not place an order if you mind..
  • Fit for household, warehousing, tobacco, pharmaceutical and other industries..
  • Universal suitable for temperature and humidity meters, humidification equipment, dehumidification equipment, high-end air conditioners and other products..
  • If you have any problems with the accessory, please let us know if we can be of any other help and we will give you satisfied answer..
Check Stock

Getting Started with the micro:bit: Coding and Making with the BBC's Open Development Board (Make)

  • Specially designed for Microbit board. This kit includes a keyestudio sensor shield fully compatible with micro bit and other commonly used 37 kinds of sensor modules. It's compatible with both microbit v1.5 and v2, microbit board not include!.
  • Designed to learn electronics programming. Great hands on STEM kit to get started with the micro bit. The product needs to be debugged before use, such as an LED display module. Please use an external power supply and debug the backlight brightness..
  • The kit gives 37 kinds of common sensors, such as Digital LED Module, Analog Temperature Sensor, Photocell Sensor, Ultrasonic Module etc, allow you make a lot of interesting projects like Traffic Light, Magnetic Check, Temperature Test, Joystick Test, Photo-interrupter Test, Alcohol Detection and so on..
  • We have detailed tutorial( included introduction, wiring diagram, test code, driver installation, Example Projects...... Step by step to explain how to use on our wiki page..
  • Solder is very clean, everything is aligned nicely, all boards are well packed after function, voltage, current testing, protected in a beautiful box. Up to FCC and CE Standard: made from environmentally friendly components and materials..
Check Stock

4Pcs INA219 I2C Bi-Directional DC Current Power Supply Sensor Breakout Board Module I2C IIC Interface

  • INA219 module is an I2C interface with a drift, bi-directional current / power monitor integrated circuit (IC), and further expand the energy-saving....
  • INA219 I2C Bi-directional DC Current Power Supply Sensor, Working Voltage 3~5V.
  • INA219 module small size, low cost, high accuracy. It not only can monitor the voltage drop across a shunt resistor on the sensing shunt supply....
  • INA219 can be achieved within the maximum error accuracy of +1% from -40° C to 85° C temperature range, the maximum offset is 100 uV. The....
  • Appliaction:The module is used for I2C port zero drift / bidirectional current / power monitoring sensor module. The device is available in a SOT23....
Check Stock

DC DC Voltage Step Up Converter Boost Power Module 10-60V to 12-97V 1500W 30A CC CV

  • ADJUSTABLE VOLTAGE -- This is a non-isolated DC power converter module with long service life.High power and stable output, it converts 10-60VDC to 12-97VDC..
  • 97% HIGH CONVERSION EFFICIENCY -- High quality components ensures high conversion efficiency, up to 97%..
  • WIDELY APPLICATION -- This Boost Power Module is widely used for high power solar street lamp driving, various LED lighting CV driving, vehicle-mounted and mobile device power, DIY adjustable CV CC power, solar power charging, and various batteries charging..
  • DESIGNED WITH SMART TEMPERATURE CONTROL FAN -- Which will automatically work when temperature reaches about 60, and stop when temperature drops below 60..
  • NOTE: When using battery, switching power supply, solar panel, or generator as input power, please it is necessary to decrease the battery protection voltage value. Otherwise it will cause damage to the battery and the power supply..
Check Stock