Top Temperature Transmitter Module

REC S550 DIY Hexacopter Drone Development kit (Value Pack)

  • - Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   Expansion feedback module,users can get plane details in real time.   Make very setting clear and exactly output result..
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Great control distance: 1.1km on the ground, 2km in the sky.   Fast response time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.  High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.   Strong anti-jumping,DSSS(Direct sequence spread spectrum) technology..
  • Pls note: Support Max 3-4S battery (Optional, only included in ARF Version).
Check Stock

Sekonic L-358 Flash Master Light Meter

  • Hi-Res 800 x 600 SVGA LED Backlit Screen 4:3 ratio, Auto Rotate Sensor, Remote Control.
  • Sekonic RT-32 Radio Transmitter Module installs easily, enabling wireless.
  • Dust-proof and splash-proof (JIS Standard Water Resistance Class 4).
  • Incident readings of three-dimensional subjects are taken using the Lumisphere fully extended.
  • Up to 9 readings can be stored in memory for meter averaging and contrast evaluations in Aperture and Shutter priority modes.
  • Exposures accurate down to a tenth-of-a-stop for both ambient and electronic flash light readings.
Check Stock

ALMOCN 4 Set 433MHz RF Wireless Transmitter and Receiver Kit High Frequency Super Regenerative Transceiver Module for Arduino Raspberry pi

  • Great influence on the antenna module reception, preferably connected to the 1/4 wavelength of the antenna, typically 50 ohm single conductor. The....
  • Wireless Transmitter Modules allow your Arduino to wirelessly comunicate with other arduinos, or with radio frequency (RF) controlled devices that....
  • Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high....
  • Frequency used to receive, decode and oscillation resistor should match with the transmitter..
  • Application:Usually used for remote control systems, such as Remote control rolling gates, smart car, smart home, etc..
Check Stock

Bewinner Qi Standard Wireless Charger Transmitter Module - 3 Coils - Multi-Level Protection - Wide Compatibility - Universal Micro Interface - DIY Wireless Charger Parts …

  • 【High Efficiency Wireless Charging Coil】Wireless charging output 5V/1A,Wireless charging conversion efficiency 75%,High charging efficiency saves....
  • 【Three Coils】This wireless charger transmitter module uses 3 coils for full charging..
  • 【Easy to Use】Compliant with Qi wireless charging standard, power 5W. Support for dual USB 2.4A output. Support micro USB interface input.The....
  • 【Multi-Level Protection】With over temperature protection. When the temperature is higher than 60 ° when charging, the charging is automatically....
  • 【100% Satisfaction Guarantee】If you have questions about the product or are not satisfied with it, please contact us at any time, we will provide....
Check Stock

Oiyagai 3pcs 433MHz RF Wireless Transmitter and Receiver Module Kit for Arduino/Arm/McU/Raspberry pi (433MHz)

  • 3 x Transmitter module (433MHz) & 3 x Receiver module(433Mhz).
  • These modules are used for projects when you need to communicate wirelessly between 2 devices.
  • It is possible to increase the range by adding a small length of cable which the device will use as an aerial..
  • VCC voltage module operating voltage and good power filtering.
  • Antenna position has also affected the reception of the module, the installation, the antenna as possible straight away from the shield, high pressure, and interference source.
Check Stock

Skytech 5301P Fireplace Remote Touch Screen Programmable Thermostat

  • THERMOSTAT: This remote control system can be thermostatically controlled when the transmitter is in the THERMO mode (THERMO must be displayed on the screen). To set the desired room temperature, press the MODE button to place the transmitter into thermo mode, then press the UP or DOWN touch buttons to select the desired room temperature. The highest set temperature is 99 ºF (32 ºC)..
  • PROGRAM FUNCTION: This remote has two program segments: A weekday segment and a weekend segment. Use this function to set the time and temperature for the fireplace to turn On/Off..
  • SAFETY: This remote control has a COMMUNICATION –SAFETY function built into its software. It provides an extra margin of safety when the Transmitter is out of the normal 20-foot operating range of the receiver. At all times and in all OPERATING MODES, the transmitter sends an RF signal every 15 minutes, to the receiver, indicating that the transmitter is within the normal operating range of 20 feet..
  • CHILDPROOF LOCK: This remote control includes a CHILDPROOF “LOCK-OUT” feature that allows the user to “LOCK-OUT” operation of the appliance from the transmitter..
  • BATTERY OPERATED: The transmitter operates with (4) AAA batteries that are included. The receiver operates with (4) AA b....
Check Stock

X10 LM465 Lamp Control Module

  • Enables X10 remote control for a plug-in light.
  • Requires TM751 Transmitter. Lamp plugs into the module.
Check Stock

QWinOut ARF/PNP Full Set Hexacopter DIY Drone Kit Tarot 690mm Frame with 750KV Motor GPS PIX 2.4.8 32 Bit Flight Controller (ARF)

  • – Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   Expansion feedback module,users can get plane details in real time.   Make very setting clear and exactly output result..
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Great control distance: 1.1km on the ground, 2km in the sky.   Fast response time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.  High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.   Strong anti-jumping,DSSS(Direct sequence spread spectrum) technology..
  • Pls note: Support Max 3-4S battery (Optional, only included in ARF Version).
Check Stock

Acxico 2Sets Laser Sensor Module For Arduino AVR(KY-008 Laser Transmitter +Laser Receiver Sensor Module Non-modulator Tube)

  • Model: 1*Laser Receiver Sensor Module+ 1* KY-008 Laser Transmitter Module.
  • Laser Receiver Sensor Module uses the non modulated laser receiver, please use in the room where without the light, the sunlight or other lamps and lanterns will interfere, suggested in the dark environment use..
Check Stock

Wireless HDMI Transmitter and Receiver - HDMI 4K @30Hz HD Extender Converter Adapter Kit for 4K Player Streaming Video Audio from Laptop/PC/Tablet/Phone to TV/Projector for Conference,Education Game

  • ➤ HDMI TRANSFER ADAPTER - Built-in 2.4GHz/5GHz dual-band WiFi module, high-sensitivity dual antennas, our HDMI dongle wireless transmitter has a....
  • ➤ HDMI WIRELESS TRANSMITTER - Our HDMI wireless transmitter and receiver support signal sources in laptops, personal computers, cameras, PS3/4, and....
  • ➤ PLUG AND PLAY - By plugging the receiver into the power supply, the transmitter into the signal device, they start transmitting pictures or videos....
  • ➤ HIGH-PERFORMANCE TRANSMITTER RECEIVER - 4 kinds of ports- audio, Type-C, HDMI, and VGA, support wireless or wired connection to meet all needs of....
  • ➤ PERFECT PRIVACY PROTECTION - One-click connection and disconnection button on the receiver, super convenient and fast to protect your privacy.....
Check Stock

QWinOut DIY F450 450mm Airframe 2.4G 6CH RC Quadcopter ARF Combo Full Set Drone with GPS APM2.8 Flight Controller (All Parts Included for Ready to Fly, Unassembly)

  • - Integrated backup power supply and failure backup controller.
  • redundant power input and fault transfer function.
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Multiple function remote control system,including helicopter,airplane and slider three type flying machine and five models,cover almost every popular model.   3.5 inch colorful screen 320×480 resolution,clear display menu and graphs.   Expansion feedback module,users can get plane details in real time.   Make very setting clear and exactly output result..
  • RadioLink AT10 2.4Ghz 10CH RC Transmitter with R10D Receiver PRM-01 Voltage Return Module: Great control distance: 1.1km on the ground, 2km in the sky.   Fast response time only 3ms to the operation,faster then the other transmitter 20ms,even ten channels also let you feel it.  High channel resolution reaches 4096,0.25us per resolution let all the servos keep tranquil.   Strong anti-jumping,DSSS(Direct sequence spread spectrum) technology..
  • Pls note: Support Max 3-4S battery (Optional, only included in ARF Version).
Check Stock

Durablow TR2003 Gas Fire Fireplace On/Off Remote Control Kit + Thermostat + Timer for Millivolt Valve, IPI Module, Replaces Wall Switch or Thermostat (Input 100-240VAC)

  • ★★ ATTENTION: This device is NOT a power supply unit. It is a switch designed for connecting to Millivolt valve, or to electric spark ignition module, or can replace wall switch..
  • ▼ All battery powered R.F. 2-button transmitter and receiver box kit gives wireless remote control to a gas heating appliance, such as gas fireplace, fire pit, stove. ▼ This is a simple On/Off remote control, gives an instant & manual control of the flame and heat..
  • ▼ Receiver with LEARN function, snap-on wall plate, and 18-inch wires with connectors to connect MILLIVOLT valve, or electric spark ignition module, or to replace wall switch. ▼ Receiver box dimension: 2.6"x2.4"x1.54". (measure your wall outlet box first).
  • ▼ Replaces Cross Reference Model #: SKY, 1001, 1001-A, 1001TH, 1001T, 1001D 1410, 1410T, 1410-A, 1410TH, RG04-1M, UN3. ▼ LEGAL DISCLAIMER: The Brand name & Model # (if listed) are for cross reference only. All Brands, Trademarks & Model Numbers remain the property of their respective owners..
  • ▼ Includes: Remote transmitter, receiver box, wall mount cover plate, screws, slide switch, wires with connectors, manuals / instructions. ▼ FCC approved. Operates at a range of 20-foot & non-directional RF signal. ▼ Transmitter operates (2) 1.5V AAA bat....
Check Stock