Top Transformer For Amplifier

Golden Age Project R1 Active MKIII Active Ribbon Microphone

  • Unmatched natural & musical sound of a classical ribbon microphone combined with the constent sound quality offered by addition of active electronics.
  • The typical large and mellow ribbon sound quality with a very smooth top end and an extended low end.
  • A Bipolar/FET descrete low-noise amplifier with a low impedance transformer less output stage, powered by standard 48V phantom power.
  • It raises the level and isolates the ribbon and gain make-up transformer from the outside world.
  • Removable microphone cable and padded case included.
  • Switchable -10db pad and 100hz low cut filter.
Check Stock

Nobsound 6P1 6.8W x 2 Vacuum Tube Power Amplifier; Stereo Class A Single-Ended Audio Amp Headphone Amplifier Handcrafted (with Headphone Amp Function)

  • This Class A single-ended vacuum tube amplifier adopts hand welding to ensure the true reality of the sound quality. This version has headphone output, which suits for 32Ω-600Ω impedance all kinds of headphones. The toggle on the front panel is to switch between speaker and headphones. Please connect your speakers (both 4Ω and 8Ω) to 8Ω and 0Ω posts..
  • This amplifier adopts transformer parallel output to reduce its internal resistance by half and achieve doubled improvement on its power..
  • Using antimagnetic transformer covers to shield current interference and achieve much lower static noise..
  • Its sound output is full of analog style. The bass part is deep and powerful and the vocal part is sweet and intoxicating.Its sound output is full of analog style. The bass part is deep and powerful and the vocal part is sweet and intoxicating..
  • It has a classic and graceful appearance. The VU meters and vacuum tubes makes it more elegant and attractive..
Check Stock

Kuuleyn Vacuum Electron Tube Valve Preamp Amplifier Board Headphone Amp Parts Musical Fidelity Kit, 6J1 Audio Tube Headphone Amplifier, Compact Electronic DIY Kit DIY Parts (Static Bag)

  • 【Funtion】Connect the 6J1 tube pre-amp between sound source and amplifier, it will effectively filter digital flavor, the music and human voice will be relatively good.
  • 【Eight 470uf Capacitor Filter】Eight 470UF capacitor filter is very clean, excellent power system to no hum, filaments are powered with DC 12V and need to be connected in series in order to reduce noise.
  • 【High Frequency And Low Proof】A coupling capacitor is an electrodeless electrolytic capacitor with high frequency and low proof.
  • 【Easy To Use】Using DC 5.5*2.1 socket and AC 12V transformer, you can also use AC 12V transformer without a plug, just need to weld the power cord onto the circuit board.
  • 【Can Yourself Assemble Them】This kit comes in parts so you can assemble them together by yourself, enjoy the process of building your own tube amplifier.
Check Stock

Pyle Car Stereo Wiring Kit - Audio Amplifier & Subwoofer Speaker Installation Cables (4 Gauge), Blue (PLAM40) & PAC SNI-35 Variable LOC Line Out Converter

  • Product 1: CAR AUDIO WIRING: Universal car stereo audio system cable and wire kit. Includes all necessary pieces to set up your amplifier and subwoofer speakers.
  • Product 1: INCLUDED AUDIO CABLES: 20’ ft. 4 gauge red power wire, 4’ ft. 4 gauge black ground wire, 20’ ft. 16 gauge blue remote turn-on, 20’ ft. 12 gauge stereo speaker wire.
  • Product 1: MORE AUDIO CONNECTION: 20’ ft. stereo RCA audio cable, 6’ ft. black split loom cable conduit - enables connection for amplifier and subwoofer speakers.
  • Product 1: CAR STEREO SOUND: Also includes (2) ring terminals 8G, (2) spade terminals: 8G, (5) spade terminals: 14-16G, (3) butt connector, (20) cable ties, (1) black grommet.
  • Product 2: Adjustable Line Output Converter.
  • Product 2: Use the SNI-35 when adding an amplifier to a factory radio to convert the radio's speaker level output to the lower amplifier (RCA) level input.
  • Product 2: Utilize Audio Transformer for Noise Isolation.
Check Stock

Taidacent OPA541 OP AMP High Power Monolithic Operational Amplifier 5A Current High Voltage Audio Amplifier Sound Amplifier Board

  • Name: OPA541 High Voltage High Current Power Amplifier.
  • Size: 96mm*64mm*41mm (length, width, height).
  • The OPA541 module is a power operational amplifier capable of operating with a power supply up to 40V and providing continuous output current up to....
  • Suitable for motor-driven speaker drive, transformer drive and audio amplifier. It can also amplify triangle wave, sine wave and square wave signals..
  • The power consumption of the module is large, and the power supply requires a certain margin. It is recommended to use a power supply with a current....
  • The output signal is recommended to use the SMA to BNC cable to directly observe the effect of the oscilloscope. Poor contact or poor quality wires....
Check Stock

AOSHIKE TPA3116 DC 12-24v 100W Subwoofer Amplifier Board Support Bass Output Digital Small Power Amplifier Board Video Audio Accessories

  • Frequency response range: input: 20 hz - 20 KHZ, output: 20 hz - 180 hz.
  • Operating voltage range: DC 12-24V(maximum voltage is no more than 24V).
  • This is a pre-amplifier, bass frequency....
  • DC 12-24V power supply, wide operating voltage, power-saving design, more than 90% power efficiency. Maximum support 100W (Bass) bass channel output.
  • Speaker impedance: bass speaker impedance: 2-8 ohm.
  • You can use a good switching power supply adapter, laptop switching power supply, or rectified filter transformer power supply, you can also use....
Check Stock

PAC AOEM-MAZ2 Interface That Allows Replacement or Addition of an Amplifier in Select Mazda Vehicles Without a Factory Bose Sound System

  • Provides 2: 1 gain and infinite attenuation.
  • Input connectors plug into factory stereo and vehicle harness.
  • Interface that allows the replacement or addition of an amplifier in select Mazda vehicles without premium Bose sound system.
  • Provides 2:1 gain and infinite attenuation.
Check Stock

Facmogu 298A Wireless Bluetooth 5.0 Stereo Audio Amplifier, RMS 40Wx2, Max 300Wx2 Dual Channel Power Amp Sound Receiver w/USB, SD Card, FM Radio for Home Speakers Theater System with Remote Controller

  • Built-in transformer -- Built-in transformer and US plug, the 2 channel Bluetooth 5.0 stereo amplifier receiver provides 300W x 2 Peak 40W+40W RMS Music Power Output, which is is perfect for your karaoke and home theater acoustic sound system..
  • 6 Inputs & Amplifer Dimension -- The digital amp box supports USB/SD card/FM Radio/ Bluetooth/2 1/4 inches microphone IN and various external sources RCA(R,L) audio input for tuner, CD player, tape deck and so on. Amplifier size: 7x5.4x2" / 18x13.8x5.5cm, weight: 2.4pounds/1.1kg. (NOTE: The frequency range of the radio reception is 87.5-108MHz).
  • USB 2.0/SD card input -- The sound amplifying mixer device features a USB/SD card input to support flash drives or SD card. Allows you to play your favorite audio files from your computer's media library when you connect it directly to the amp..
  • Multipurpose -- Recommend for home TV audio, computer audio system-game, tower Speaker, garden speaker. Small simple compact design also for car audio system..
  • 1-year Warranty -- We offer 1-year guarantee period. If you have any questions or concerns, please don't hesitate to contact us..
Check Stock

Yamaha Audio A-S1200BL Integrated Amplifier Black

  • High Quality Components delivering exceptional musical expression.
  • Toroidal power transformer with enormous energy for a pure musical sound.
  • Gorgeous level meters convey dynamics and music pulse with a nod to the nostalgic Hi-Fi era.
  • Mechanical ground concept maximises rigidity for expressive and rhythmic bass.
Check Stock

Parasound Z Amp v3 90W Two Channel Zone Amplifier

  • Compact power amplifier with multiroom features.
  • Fully discrete circuitry with Toroid power transformer.
Check Stock

PAC SNI-15 Speaker Level to Preamp Adapter

  • Transformer Isolation Between Inputs and Outputs Keep Signal in Phase.
  • Adjustable from 2 Watts to 30 Watts per Channel with Fixed 10:1 Conversion.
  • Works with Most Factory Installed Radios.
Check Stock

Onkyo TX-8020 2 channel Stereo Receiver

  • 50 W/Ch (8 Ohms, 20 Hz-20 kHz, 0.08%THD, 2 Channels Driven, FTC).
  • WRAT (Wide Range Amplifier Technology). Tuner Features : 40 FM/AM Random Presets.
  • 5 Analog Audio Inputs and 1 Output, including Phono Input for Turntable Connection.
  • Massive EI Transformer. Compatible with the DS-A5 AirPlay RI Dock for iPod/iPhone/iPad.It's not a surround sound stereo..
  • Power Output90 W + 90 W (6 Ω, 1 kHz, 1% THD,1 Channel Driven, IEC).
Check Stock