Top Turbine Blade

AUECOOR 1000 Watts Solar Panel Wind Turbine Kit(Hybrid System) : 6 x 100W Polycrystalline Solar Panel+ 400W Wind Turbine Generator+ 2000W Pure Since Wave Inverter(Peak 4000W)+Accessories

  • High module conversion efficiency and excellent performance in low light conditions, higher efficiency than the traditional panel..
  • This panel is designed to withstand high wind and snow loads, offer weather-resistant outdoor durability and longer life span. Corrosion-resistant aluminum frame for extended outdoor use, allowing the panels to last for decades..
  • This pure sine wave type of inverter, faster and more sensitive reaction.
  • Aluminum alloy housing, not rust, heat-resisting, cold-resistant as well as anti-corrosion..
  • 400W 5-Blade Wind Turbine with a 2.5m/s start up speed for constant and efficient power generation exceeding a similiar 3-blade turbine.
  • Warranty:6-year material and workmanship warranty,25-year power output transfer warranty.
  • friendly 24H/7D service.Solar kit will be delivered in multiple packages ..
Check Stock

AUECOOR Solar Wind Hybrid System: 400W Wind Turbine Generator+ 120W Flexible Monocrystalline Solar Panel for Off Grid 12V Battery Charging

  • High Conversion & Waterproof: Each Solar Panel 120W Guaranteed under full sunshine. This solar panel module conversion efficiency can comes up to 20.5%, It has excellent performance even in low-light environments. The solar panel and junction box are completely water resistant. Suitable for outdoor use in all weather conditions..
  • Good Bendability :flexible design enables the solar panel to be curved to a maximum 30-degree arc, mounted on a curved roof, RV, travel trailer, marine, van, truck, boat, cabin, tent or any other irregular surface..
  • Thin and light weight: This 120W solar panel is only 0.1inch (2.5mm) thick, it weighs approximately 4.4 pounds(2.0KG), making transportation and installation a breeze..
  • Easy installation:this solar panel is easy to transport,ang,and remove,pre-drilled holes for easy installation.
  • Each solar panel with 90cm of special cable with Male/Female connectors attached to the junction box.
  • 400W 5-Blade Wind Turbine with a 2.5m/s start up speed for constant and efficient power generation exceeding a similiar 3-blade turbine.
Check Stock

Turbonator Dual Fan,64mm/2.5in Intake Turbo Fan Diameter Aluminum Alloy + Rubber Car Air Intake Turbonator Dual Fan Turbine Supercharger Gas Fuel Saver Turbo (Red)

  • FEATURES: Increase the intake air volume of the combustion chamber by the turbofan, improve the combustion efficiency of the combustion chamber gas and thus enhance the horsepower..
  • WORKING PRINCIPLE: ABS new material fan blade draws air into the combustion chamber at a higher rate, Improve the atomization degree of the combustion chamber, increased horsepower and gasoline savings..
  • MATERIAL: ABS new material fan blade+Aluminum alloy pipe. ABS material is corrosion resistant, heat resistant, high hardness and does not produce metal debris entering the combustion chamber. Aluminum alloy pipes are corrosion resistant, durable and lighter in weight..
  • INSTALLATION POSITION：The turbine is installed in the intake hose of the engine, and the best position is 10cm-30cm / 3.94 "- 11.8" before the throttle valve. Note: suitable for car models with inlet pipe diameter greater than 2.5 inches..
  • PACKAGE and SIZE : 1 x Intake Fan,3 x Rubber Loop,Intake turbine size: 7.5cm x 6.5cm/ 2.9inch x 2.5inch..
Check Stock

Turbo Turbocharger 13900-62D51 Snowmobiles ATV RHB31 VZ21 Fits for Mini for Suzuki for Small Engine with YA1/F6AT 500-600ccm, for Motorcycle Water and Oil Cooled

  • ★★100% brand new, very good quality.Careful manufacturing improves turbine power..
  • ★ This turbine blade of made rare metal Ni, which has the advantages of good working blade under high temperature environment, large power and long service life..
  • ★This turbocharger volute produced made of high quality silicon molybdenum, which can not creep under high temperature and prolong its service life..
  • ★Through the comprehensive and high-precision static and dynamic balance detection technology, the use time and reliability are increased, and the car owners have no worries.
  • ★ This turbocharger is built to match the performance of original equipment for specific vehicles.Before purchasing a high-quality turbocharger, please check the picture carefully. The necessary accessories for the installation are already in place and easy to install. It is recommended to find a professional master to install..
Check Stock

Pikasola Wind Turbine Generator Kit 400W 12V with 5 Blade Wind Generator Kit with Charge Controller Wind Power Generator for Marine RV Home Windmill Generator Suit for Hybrid Solar Wind System

  • ★ Feature: Starting with 2.5m/s Low wind speed.
  • High wind energy efficiency. Wind turbine kit suitable for boat, RV, cabin, home, etc..
  • ★ Wind Blade: 23.8 inch in length, the longer blade will generate more power. The blades are made of Nylon carbon fiber which special on waterproof, corrosion resistant, lightweight..
  • ★Wind Generator: Three-phase permanent magnet synchronous motor. Efficient and compact ac generator with high performance NdFeB permanent magnet..
  • ★Rotating Aluminum Alloy Body: With yaw adjustment system, the wind direction position is automatically read and the rotor position is adjusted to capture the maximum wind energy. The tail fin is designed according to the aerodynamic principle..
  • ★Real Parameter, Not False: Our product parameters are Real & Actual, not False. Base on designed after repeated experimental testing. Pls remember to contact us if you have any questions after received wind turbine. We should take charge of our product..
Check Stock

640 Watt Solar Wind Hybrid Kit : 400W 12V/24V Wind Turbine Generator+2pcs 120W Flexible Monocrystalline Solar Panel + Solar Charge Controller+ Wind Controller+ Accessories

  • The Solar &Wind Hybrid Power Kit is ideal for remote areas to generate power in all year. Solving the pure solar panel system low efficiency problem in low temperature and strong wind.Hybrid Kit can help you to generate power in all seasons and save energy..
  • 400W 5-Blade Wind Turbine with a 2.5m/s start up speed for constant and efficient power generation exceeding a similiar 3-blade turbine.
  • Good Bendability :flexible design enables the solar panel to be curved to a maximum 30-degree arc, mounted on a curved roof, RV, travel trailer, marine, van, truck, boat, cabin, tent or any other irregular surface..
  • High Conversion & Waterproof: Each Solar Panel 120W Guaranteed under full sunshine. This solar panel module conversion efficiency can comes up to 20.5%, It has excellent performance even in low-light environments. The solar panel and junction box are completely water resistant. Suitable for outdoor use in all weather conditions..
  • Easy installation:this solar panel is easy to transport,ang,and remove,pre-drilled holes for easy installation.
  • Each solar panel with 90cm of special cable with Male/Female connectors attached to the junction box.
Check Stock

Thames & Kosmos Wind Power V4.0 STEM Experiment Kit | Build a 3ft Wind Turbine to Generate Electricity | Learn About Renewable Energy & Power a Small Model Car | Weatherproof for Outdoor Use

  • Build and experiment with a real, working 3-foot tall wind turbine to learn how wind is one of the most promising sources of clean, renewable energy available today..
  • Single-piece blade construction for improved durability and better aerodynamics..
  • Generate electricity to charge a battery and power a small model car..
  • New weatherproof battery box can be left outside!.
  • Includes stakes to secure the turbine to the ground..
Check Stock

Pikasola 400W Wind Turbine Generator AC 12Volt Economy 3 Blades Windmill for Wind Solar Hybrid System 2.5m/s Start Wind Speed,400w Windmill Generator for Home

  • 1. Principle: horizontal shaft wind turbine generator, refers to the horizontal installation of shaft, parallel to the ground. The wind drives the blades to generate kinetic energy, which in turn drives the engine to generate electricity. Core components: blade + generator (engine) + rotating body + wind tail.
  • 2. Wind blade: 60cm in length, made of nylon carbon fiber. The longer the blades are, the more kinetic energy they generate and the more power they produce. Nylon material waterproof, corrosion resistant, lightweight, high efficiency..
  • 3. Generator: three-phase permanent magnet synchronous motor. Efficient and compact ac generator with high performance NdFeB permanent magnet. A fully integrated voltage regulator that automatically shuts down when the battery is fully charged. The fan is controlled by MPPT intelligent microprocessor, which can effectively adjust current and voltage.
  • 4. Rotating body: with yaw adjustment system, the wind direction position is automatically read and the rotor position is adjusted to capture the maximum wind energy. The tail fin is designed according to the aerodynamic principle, with low starting speed and low vibration..
  • 5. Remarks: our products are designed through repeated experiments and tests, and the parameters ....
Check Stock

SMV Industries 8 ft Windmill - Green and Yellow

  • ★ Feature: Starting with 2.5m/s Low wind speed.
  • High wind energy efficiency. Wind turbine kit suitable for boat, RV,....
  • ★ Wind Blade: 23.8 inch in length, the longer blade will generate more power. The blades are made of Nylon carbon fiber which special on waterproof,....
  • ★Wind Generator: Three-phase permanent magnet synchronous motor. Efficient and compact ac generator with high performance NdFeB permanent magnet..
  • ★Rotating Aluminum Alloy Body: With yaw adjustment system, the wind direction position is automatically read and the rotor position is adjusted to....
  • ★Real Parameter, Not False: Our product parameters are Real & Actual, not False. Base on designed after repeated experimental testing. Pls remember....
Check Stock

PIKASOLA 1000W 24V Permanent Magnet Wind Turbine Generator 3 Blades Economy Homes Windmill for Wind Solar Hybrid System 2.5m/s Start Wind Speed with Controller for Wind Solar System (24V)

  • 1. Principle: horizontal shaft wind turbine generator, refers to the horizontal installation of shaft, parallel to the ground. The wind drives the blades to generate kinetic energy, which in turn drives the engine to generate electricity. Core components: blade + generator (engine) + rotating body + wind tail.
  • 2. Wind blade: 37.4 inch in length, made of nylon carbon fiber. The longer the blades are, the more kinetic energy they generate and the more power they produce. Nylon material waterproof, corrosion resistant, lightweight, high efficiency..
  • 3. Generator: three-phase permanent magnet synchronous motor. Efficient and compact ac generator with high performance NdFeB permanent magnet. A fully integrated voltage regulator that automatically shuts down when the battery is fully charged. The fan is controlled by MPPT intelligent microprocessor, which can effectively adjust current and voltage.
  • 4. Rotating body: with yaw adjustment system, the wind direction position is automatically read and the rotor position is adjusted to capture the maximum wind energy. The tail fin is designed according to the aerodynamic principle, with low starting speed and low vibration..
  • 5.Remarks: our products are designed after repeated experimental testing, and the parameters....
Check Stock

Dyna-Living Wind Turbine Generator 400W DC 12V 3 Blade Wind Turbine Motor with Charge Controller for Home Use Boat or Industrial Energy(Not Included Mast)

  • [Low Noise and Durable]- The wind turbine motor adopts a three-phase DC permanent magnet synchronous generator, free running, low noise and long service life. Teflon wire is heat resistant, which is not easy to damage the wire when the machine is overloaded. It is smooth in operation, good wind resistance for double-row bearing..
  • [High Wind Energy Utilization]-The coil is made of Teflon wire, which is resistant to high temperatures. It has effective regulation of current and voltage, with high wind energy utilization factor, which contributes to the annual energy output..
  • [High-Quality Blades]-The blade is equipped with a copper inlay part that does not damage the nylon fiber when the bolt is tightened, the blades are not easily deformed or broken. The working temperature is -40 ° C ~ 80 ° C, do not worry about the temperature being too low and causing the leaves to freeze..
  • [Unique Design]- The wind turbine generator adopts a permanent magnet rotor alternator and with a special kind of stator design, efficiently decreases resistance torque guarantees stability. The blades using reinforced glass fiber helped with optimized structure and aerodynamic shape, it enhanced wind power coefficient and power generating capacity..
Check Stock

Cutting Edge Power DC Wind Turbine Project Motor Generator

  • Voltage output: 0-30V . Maximum Generator Output: 15 watts.
  • 1/8" (3mm) shaft diameter. Shaft has a flat spot for attaching the blade.
  • Two 3/16 spade terminals for power connection.
Check Stock