Top Waveform Display Meter

Megger MIT310-EN Insulation Tester, 1000 Megaohms Resistance, 250V, 500V, 1000V Test Voltage

  • Insulation tester for testing insulation resistance, voltage, and continuity in electrical installations.
  • Average-sensing meter provides accurate readings when measuring linear loads, where the current or voltage has a sinusoidal waveform.
  • Dual digital display with analog arc function to replicate response of analog meters.
  • Measures insulation resistance from 0 to 1,000 megohms, voltage from 0 to 600V, and continuity from 0.01 to 100 ohms.
  • Safety rated to European Standard EN61010-1 Category III, 600V and IP54 rated for protection against dust and splashing water.
Check Stock

Amprobe DGC-1000A Clamp Ground Resistance Tester

  • Ground resistance tester for measuring ground resistance, current, and continuity in multi-grounded systems.
  • True RMS meter provides accurate readings when measuring linear or non-linear loads where the current or voltage has a sinusoidal or nonsinusoidal waveform.
  • Clamp-on head to measure resistance on a ground rod without the use of additional ground rods and without disconnecting the grounds under test.
  • Measures ground resistance from 0.025 to 1,500 ohms and AC current up to 10A.
  • Safety rated to European Standard 61010-2-32 Category III 300V, Category II 600V.
  • Continuity beep if the resistance is lower than 40.00 Ohms.
Check Stock

STARTO Handheld Digital Oscilloscope Kit 2.4” TFT with BNC-Clip Cable Probe and Power Supply

  • (1) Bandwidth 120MHz, dual channels, sampling rate 1Gsa/s, time base range 2ns/div to 1000s/div.
  • storage depth (record length of each acquired waveform) sampling points above 10K.
  • (2) Large 7-inch LCD TFT (true color) screen, 65535 colors, 800 x 480 pixel resolution, cursor measurement, and 4 automatic cursor modes..
  • (3)The Kiprim DS1202 oscilloscope has an automatic range function, supporting horizontal, vertical, single waveform, and multiple waveform tracking. Probe attenuation multiples: 1X, 10X, 100X, 1000X. Two trigger types: edge trigger, video trigger, three trigger methods: automatic, normal, and single..
  • (4)Built-in 6-digit hardware frequency meter, which can measure 2Hz to 20MHz, with current measurement function, measurement range: 100.0mA/V to 1KA/V. Support to connect to a computer, please contact us through Amazon for instructions and software downloads..
  • (5)This digital oscilloscope has 30 automatic measurement functions and can customize the measurement menu. Mathematical operations: addition, subtraction, multiplication, division, FFT. It also has a waveform cut-off function, which can be seamlessly connected to signal generators of....
Check Stock

Hantek 6074BD Oscilloscope with AWG, PC USB oscilloscope 4 Channels 70MHz Bandwidth 1GSa/s Sample Rate

  • 2 Channel Digital Oscilloscope + Arbitrary/Function Waveform Generator + Synchronizing Signal + External Trigger.
  • The Keys for osilloscope and waveform generator is seperated for convenient to operate it simultaneously.
  • Large and clear display (7 inch 64K color LCD display, Resolution 800x480), more clear and realistic waveform.
  • Oscilloscope: 1GSa/s Sample Rate, 200/100/70MHz Bandwidth, more than 20 kinds of auto measurement functions.
  • Powerful Trigger Function: Edge, Video, Pulse, Slope, Over time, Alternative003cbr003e 6.Arbitrary/Function Waveform Generator: 25MHz, 12 bits resolution, 200MHz DDS, Arbitrary wave/square wave/sine wave/triangle 7.wave/trapezoidal wave/pulse wave/DC is easy to simulate transducer.
Check Stock

FNIRSI 1014D Digital Storage Oscilloscope 100MHz Dual Channel Oscilloscope Signal Generator

  • ...ure 0 ~ 4000V. Up to 12 parameters measurement：VPP，VP，Vmax，Vmin，Vavg，Vrms，Frequent，Duty+，Duty-，Time+，Time-，Period.
  • Cursor measurement function, it is convenient to manually measure the period and frequency and voltage. Complete triggering function (single, normal, automatic). At any time, the waveform display (pause function) is frozen. Equipped with high efficiency One-button AUTO.
  • One-button waveform storage and screenshot. Built-in 1GB storage space, can store up to 1000 screenshots + 1000 sets of waveform data. Powerful waveform picture manager supports thumbnail browsing, viewing, detailed viewing, page turning, deletion and waveform zooming in, zooming out, moving, etc..
Check Stock

Oscilloscope Multimeter 2-in-1, Color Screen Intelligent Graphical Handheld Oscilloscope Multimeter 1MHz Bandwidth, 2.5Msps Sampling Rate, DC/AC Voltage/Current Test

  • Scope Mode: 1. The waveform refresh rate is up to 10000wfms / s. 2. Dual channel input, bandwidth up to 50MHZ, real-time sampling rate 250MSa / s, recording length up to 8k dots. 3. Cursor measurement function. 4.7 kinds of automatic measurement functions. 5. XY function. 6. One key automatic setting function, convenient for detecting and debugging..
  • Meter mode: 4 1/2 digits of the true effective value. 1. Standard voltage, current, resistance, diode, continuity, capacitance test. 2. Auto range function, convenient for testing and debugging. 3. The maximum input voltage is AC 750V, DC 1000V. 4. Independent multimeter and oscilloscope input. 5. Reading the wait function. 6. Relative measurement function..
  • USB Type-C interface supports not only power bank power supply, but also adapter charging and top computer connection. After connecting to the computer, the computer can recognize the oscilloscope as a USB flash drive and read saved images or CSV waveforms, which is useful for later viewing and analyzing waveforms or for sharing waveform data..
  • Save function: can save 4 groups of settings, 4 groups of reference waveforms, 4 images, 4 groups of waveforms in CSV format. The reference waveform can be displayed on the same screen as the measured waveform fo....
Check Stock

USB Oscilloscope, PC Based Dual Channel 25MHz Digital Oscilloscope, Handheld Mini Digital Storage Oscilloscope, Multi Functional, MIT USB Isolation, with Probe

  • ▶▶PC virtual oscilloscope◀◀ dual-channel virtual oscilloscope, the detected waveform can be displayed on the computer, image storage, display on the same screen and other multi-function computer virtual oscilloscope..
  • ▶▶Advanced◀◀ dual-channel input, 25Mhz bandwidth, 100MS/s sampling rate, 5K storage depth, fast acquisition speed, and general test requirements can be met..
  • ▶▶Weak attenuation◀◀ The 25Mhz sine wave amplitude measured by the VDS1022I oscilloscope is 904mV, according to the international standard (-3dB attenuation, 707mV), which is better than the international standard and presents a perfect waveform..
  • ▶▶Function◀◀ single channel/alternate channel trigger.
  • X-Y/FFT waveform display on the same screen.
  • 18 groups of values can be measured simultaneously.
  • multi-function to meet your measurement needs..
  • ▶▶Data recording◀◀ The waveform can be recorded/saved, and the maximum storage is 4000M, which can be read at any time. The waveform is perfect. It is a good helper for papers..
Check Stock

WonVon DDS Function Generator, 60MHz Dual-Channel Signal Generator 0.01-100MHz Arbitrary Waveform Pulse FY6900-60M Generator Function Signal Generator

  • FY6900 series Dual-channel Function / Arbitrary waveform generator is a set of Function Signal Generator, Arbitrary Waveform Generator, Pulse Generator, Analog / Digital modulator, VCO, Sweep, Counters and Frequency Meter and other functions in a high Performance, cost-effective, multi-function signal generator. Abundant shortcut keys and graphical user interface simplifies every operation..
  • The standard 3-pin power plug increases the grounding protection and effectively eliminates the leakage current on the BNC terminal.2.4 inch TFT Color LCD with 320×240 resolution, displaying parameters and graphics of the two channels at the same time.The instrument uses 14-bit high-speed D/A converter chip (5Vpp output quantization error is less than 1mV), 250MSa/s sample rate, 14bits vertical resolution.
  • Can output up to 97 groups of functions / arbitrary waveform, contains 33 groups of preset waveforms and 64 groups of user-defined waveforms. Preset waveforms: Sine, Square (Duty Cycle adjustable), Pulse (Pulse width and cycle time can be set accurately), Triangle/Ramp, CMOS(0~10V), Four channels TTL, Exponential Rise, Exponential Fall, Noise, ECG, DC etc..
  • Enable to store 64 arbitrary waveform data files, each one of waveform storage depth 8192 points * 14bit....
Check Stock

Tablet Oscilloscope,Digital Touch Screen Storage Oscilloscope Kit,with 2 Channel 100Mhz Bandwidth 7 inch Screen,Multi Functional Ultra Thin Portable USB Oscilloscope

  • ...the product. If you have any questions, you can contact us. ).
  • Fully matched 7-inch TFT LCD color display with a resolution of 800 * 480, bright colors and high contrast. The capacitive touch panel is similar to the touch mode of modern tablet computers..
  • Equipped with efficient one-button automatic device. One-click waveform saving and screenshots. The built-in 1GB storage space can store up to 1000 screenshots 1000 sets of waveform data. The powerful waveform image Manager supports browsing, viewing, viewing detailed information, turning pages, deleting and zooming, zooming and navigating waveforms..
  • High measurement voltage range, 1X can measure 0-40V, 10X can measure 0-400V, 100X can measure 0-4000V. Up to 12 parameter measurements: VPP, VP, Vmax, Vmin, Vavg, Vrms, Frequent, Duty , Duty-, Time , Time-, Period. This USB oscilloscope is equipped with a USB interface and can be connected to a computer to share its screenshots with the computer, which facilitates secondary analysis..
  • Memory compression technology, waveform refresh screen does not flicker.
  • Powerful waveform picture manager supports thumbnail browsing, viewing, detailed viewing, page turning, deletion and waveform zooming in, zooming out, moving, etc.
  • FFT display function, can analyze the sp....
Check Stock

2 in 1 Digital Oscilloscope Multimeter, Scope Meter with 2.5 Msps High Sampling, 2.4 Inch Color Screen, Automatic Waveform Capture Function, DC/AC Voltage/Current Frequency Resistance Diode Test

  • More Accuracy & Efficient: Dedicated chip, high speeds sampling rate and high bandwidth, automatic waveform capture function, one-key transform to waveform function furing measuring, software calibration technology,memory calibration coefficients, to improve your work efficiency..
  • With Multimeter Function: This 2 in 1 oscilloscope multimeter is suitable for diagnosing automotive, industrial and household electrical problems. This electrical tester is auto-ranging and 4000 counts, can accurately measure AC/DC voltage, resistance, AC/DC current, capacitance, frequency, diodes, continuity..
  • One-button oscilloscope: no need oscilloscope probe, measuring waveform directly. Fast and accurate measurement, clear waveform display. 3 waveform scanning modes: automatic/conventional/single. Mass storage, 100 data/10 waveforms..
  • Support Multi Waveform Parameters: When measuring waveforms, you can set parameters independently, such as: time base, amplitude, waveform scanning mode, etc..
  • LED Backlight & Storage / Readout -Analog broadband range up to: DC/AC ~ 1MHz, Display hold, storage / readout up to 10 waveforms and 100 sets of measurement values. 240x320 color screen with LED backlight which is always on.More clear and suitable for working at night..
Check Stock

Fluke 375 FC True-RMS 600A AC/DC Wireless Clamp Meter

  • Dual action jaw Light and slim body design Easy clamping in narrow locations Safe and easy operation Independent opening, double lever design Eliminates magnetization induced heat and noise, even in heavy current measurement No metal (iron core) exposureMeasure the fundamental waveform component using the average rectified method.
  • Measure the fundamental waveform component using the average rectified method.
  • Expanded -25 °C to 65 °C operating temperature range.
  • Connect the CT6280 flexible sensor to measure up to 4199 A in thick or paired wires.
  • Hioki flexible sensor CT6280 on the last image is not included (purchase required separately) and Drop proof design withstands drop from a height of 1 meter.
Check Stock

Fluke 325 Clamp Multimeter AC-DC TRMS

  • Digital clamp meter measures AC current to 400 amp, AC and DC voltage to 600V, and resistance to 4 kilohms.
  • True RMS sensing meter provides accurate readings when measuring linear or non-linear loads, regardless of waveform.
  • Jaw opening measures current in a conductor up to 30mm without touching or interrupting the circuit.
  • Audible continuity sensor confirms that the circuit conducts electricity.
  • Meets IEC safety standard 61010-1, and is rated for CAT IV installations to 300V and CAT III installations to 600V.
Check Stock