Top Xlpe Line

HEATIT HISD 15-feet Pipe Heating Cable with Built-in Thermostat

  • ...th light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 12-feet Pipe Heating with Built-in Thermostat, Black

  • ...uctions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black

  • ...uctions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

HEATIT JHSF 12-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • ...meter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue.
Check Stock

HEATIT JHSF 6-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • ...meter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue.
Check Stock

HEATIT JHSF 80-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • ...meter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue.
Check Stock

Electric Water Pipe Heating Cable with Thermostat for Pipe Freeze Protection, 6ft 120V Snow De-Icing Cable with Build in Thermostat, Pipe Warmer, Heat Pipe Tape - CSA/ETL Listed

  • ✅ 003cb003e[100% Money-Back Guarantee] 003c/b003e--Customer satisfaction is our priority. If for any reason you're not completely satisfied, you can ask for a replacement or full refund, no questions asked. Buy with confidence!.
  • ✅ [High quality]--UL, ETL and CSA certified,more safer to use.Industrial grade heat shrinkage tube for connection.Each Cable consists of tough XLPE inner insulation, AL foil, a continuous ground braid as well as weather and non-supportive climatic conditions resistant PVC (high-low temperature) outer coating. Can convert 100% of electrical energy into heat without energy loss..
  • ✅ [Note]--Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight. If the ambient temperature is lower than -20°F(-29°C), please use 1" thick insulation material..
  • ✅ [Application]--Suitable for use on water filled plastic ((including PEX)and metal water pipes(including copper, galvanized, ABS plastic, PVC plastic pipes, etc).Not use for empty water pipes, fuel lines, hoses, gutters, steam lines and so on.Keeps water flowing down to -40℃..
Check Stock

HEATIT JHSF 24-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • ..., at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. The minimum bending radius is 1 inch.Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue.
Check Stock

DEWENWILS Roof Heat Cable, 6ft Heat Tape for Pipe, Gutter, Roof, Self-Regulating Cable Pre-Assembled, UL Listed

  • ...ith light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

Qmark WHT500 Utility Heater for Use in Well Houses, Utility Rooms, and Areas with Pipes and Machinery, 500 Watt, 240 Volt, Beige

  • ...ith light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don't plug in the cable for a long time for testing. When you feel the slight warm, please turn it off..
Check Stock

Amsteel Blue 7/64' Rope, 12 Strand - 600 Ft Spool, Blue

  • 7/64" is only 8 Strands. PRODUCT CODE:872 FIBER:DYNEEMA SPECIFIC GRAVITY:0.98.
  • Lifting Sling / Mining Lifting Sling / Offshore Lifting Sling / Utility Other Fishing Line, Camera Control Line, Chipper Winch Line, Control Line, Davit Face and Wing Wire, First Ashore / Emergency Tow System, General Working Line / Vessel Mooring, Gilson Wire Rope Replacement, Halyard.
  • Primary Mooring Line / Non-jacketed Pulling / Stringing Line Reef Line, Running Back Shield Hauler, Stage, Event, and Special Effects, Rigging Synthetic Extension Pendant, Trapeze Line, Trawl or Bridle Line, Tug Mainline, Tug Messenger Line, Tug Pendant, Vehicle Winch Line, Winch Line / Mining Winch Line / Offshore Winch Line / Safety Winch Line / Tug Winch Line / Utility Working Line / Mining Working Line / Offshore.
  • A size-for-size strength replacement for wire rope at only 1/7th the weight, Abrasion resistant, Durable Easy to inspect, Easy to splice, Excellent abrasion resistance, Excellent flex-fatigue resistance, Excellent wear characteristics, Extremely lightweight, Extremely low stretch, Flex-fatigue resistant,.
  • Flexible, Floats, High strength, Highly flex-fatigue resistant, Lightweight, Low stretch, Maximum strength-to-weight ratio, Non-rotational Samthane coated, Similar elastic elonga....
Check Stock

QualyQualy Fishing Line Spooler Winder with Unwinding Function Portable Fishing Line Remover Machine Fishing line Spooling Station

  • 【Key Features】 – Unique patent pending design – Line Counter tracks the amount of fishing line added to your reel - Spool spinning reels and casting reels without line twist – 1/4lb spool capacity – Clamps to fishing rods from 0.150-1.0 inch in diameter - adjustable line spooling tension bands ensure that line is spooled tightly on the reel - works with monofilament, fluorocarbon, and braided fishing line – Compact and Portable, take it anywhere you go fishing..
  • 【INTEGRATED LINE COUNTER】 – The built-in line counter tells you how much line you are adding to your casting reel or spinning reel. The Kalibrate makes it very easy to evenly split a spool of line between two reels, no more putting too much line on one reel and leaving yourself short on the second reel. The Kalibrate is also ideal for adding the correct amount of backing on a spinning reel or on a fly reel..
  • 【PATENT PENDING LINE SPOOLING TOOL】– The innovative KastKing patent pending line spooler design is simple to use and can spool both spinning reels and baitcasting reels without line twist. The 3-position clamping system can be adjusted to fit nearly any size rod and tension bands can be adjusted to apply the ideal line tension during the spooling process..
Check Stock