Top Pedestrian Signal Module

Agatige Frequency to Voltage Converter Module, 0-10Khz to 0-10V F/V Digital to Analog Converter Conversion Module

  • FUNCTION: The frequency of the pulse signal 0HZ to 10KHZ converts into an analog voltage signal of 0-10V. Can be used to interface switching between the PLC and the frequency converter, or interface matching such as the matching of motion control card and inverter control..
  • FEATURES: Input pulse level is 5V 12V 24V, which can be directly entered without serial resistor. The input signal frequency must maintain more than 0.5 seconds..
  • ANTI-INTERFERENCE: Conversion module's signal inputs with optical coupling isolation, which can ensure that the capability of anti-interfence..
  • APPLICATION: Frequency to Voltage Converter Module Can be used for industrial control panel PLC or other signal interface switching.
  • MAJOR SPECIFICATIONS: Output current: 5MA,Voltage: 0-10V, Input pulse level: 5V 12V 24V, Frequency: 0 to 10KHZ..
Check Stock

Logarithmic Amplifier Module ±0.4 DB RSSI Linearity with Limiting Output Can Be Used As FSK PSK Demodulation

  • AD8309 AMPLIFIER MODULE - AD8309 amplifier module, with limiting output, can be used as FSK PSK demodulation..
  • APPLICATION - Used for received signal strength indicator (RSSI) and phase detection in cellular base stations, radar and other radio transceiver applications..
  • 16mA current, 20 mV/dB slope, ‑95 dBm intercede, SMA female, 5MHZ‑500MHZ frequency range, 100 dB gain..
  • ±0.4 DB RSSI LINEARITY - ±0.4 dB RSSI linearity, RSSI scale does not change with temperature and feed voltage..
  • Logarithmic output of the logarithmic amplifier module is proportional to the logarithm of the input signal..
Check Stock

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

  • The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
  • Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
  • 4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
  • Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
  • The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..
Check Stock

Logarithmic Amplifier Module ±0.4 DB RSSI Linearity ‑95 DBM Intercede, Sma Female Can Be Used As FSK PSK Demodulation

  • 16mA current, 20 mV/dB slope, ‑95 dBm intercede, SMA female, 5MHZ‑500MHZ frequency range, 100 dB gain..
  • APPLICATION - Used for received signal strength indicator (RSSI) and phase detection in cellular base stations, radar and other radio transceiver applications..
  • Logarithmic output of the logarithmic amplifier module is proportional to the logarithm of the input signal..
  • ±0.4 DB RSSI LINEARITY - ±0.4 dB RSSI linearity, RSSI scale does not change with temperature and feed voltage..
  • AD8309 AMPLIFIER MODULE - AD8309 amplifier module, with limiting output, can be used as FSK PSK demodulation..
Check Stock

HiLetgo 5pcs Micro SD TF Card Adater Reader Module 6Pin SPI Interface Driver Module with chip Level Conversion for Arduino UNO R3 MEGA 2560 Due

  • The module (MicroSD Card Adapter) is a Micro SD card reader module for reading and writing through the file system and the SPI interface driver..
  • SCM system can be completed within a file MicroSD card .Support Micro SD Card, Micro SDHC card (high speed card)..
  • 3.3V regulator circuit: LDO regulator output 3.3V for level conversion chip, Micro SD card supply..
  • Level conversion circuit: Micro SD card to signal the direction of converts 3.3V, MicroSD card interface to control the direction of the MISO signal....
  • Positioning holes: 4 M2 screws positioning holes with a diameter of 2.2mm, so the module is easy to install positioning, to achieve inter-module....
Check Stock

5pcs HC-SR04 Ultrasonic Sensor Distance Sensor with Ultrasonic Transmitter and Receiver Module Compatible with Ar-duino UNO MEGA2560 Nano Robot XBee ZigBee

  • Induction Angle: not more than 15 degrees:....
  • the module HC-SR04 works: (1) IO trigger ranging to at least 10us high signal.
  • (2) module automatically sends eight 40kHz square wave, automatically....
  • Panel wiring, VCC, trig 's (control side), the echo (receiving end), out (empty feet), GND.
  • Note: TRIP-pin internal pull-up 10K resistor, down TRIP microcontroller IO port pin, and then to a 10us pulse signal..
  • OUT pin for this module as the switch output pin when the anti-theft module, ranging modules do not use this foot!.
Check Stock

ESP8266 Wire~Less Wi~Fi Transceiver Relay Module, 4 Channel DC 5V Smart Switch Relay Module for Smart Home Automation System IOT A~PP Con~Troller

  • SUPPORT TWO WORK MODE: Mode 1: cellphone carry on WIFI module directly. Mode 2: cellphone and WIFI module carry on router together..
  • TRANSMISSION DISTANCE: In the open environment,when mobile phone is carrying on the WIFI module ,maximum transmission distance is 100 meter. When the WIFI module and cell phone carrying on the router at the same time the signal transmission distance depends on router signal..
  • SAFE: Optocoupler isolated output, safe and reliable..
  • LED INDICATOR: On board relay LED indicator , mode option and working statue LED indicator..
  • SHOP WITH CONFIDENCE: To Provide You With the Highest Quality Service, If You Have Any Question, Please Feel Free to Contact Us.We Will Provide After-sales Service Until You Are Satisfied..
Check Stock

YVO Optocoupler Isolation Board,4 Channel Optocoupler Isolation Module PLC Signal Level Voltage Conversion Board,Can be Used for Signal Isolation,Signal Level Voltage Conversion (24V to 5V)

  • 【Widely Use】: Our optocoupler isolation board can be used for signal isolation, PLC signal level converting, level conversion between single-chip microcomputer, PLC and other signals, PNP / NPN signal to NPN signal, signal level voltage conversion and other purposes..
  • 【20K Limit Switching Frequency】: The maximum switching frequency of our optocoupler isolation is 20K..
  • 【Easy To Recognise】: Each channel of our optocoupler isolator module has been equipped with indicator, easier to recognise the working status..
  • 【Size Parameters】: Module Dimensions: 72*55*18mm (length*width*height). Mounting Hole Size: 64*47mm. Mounting Hole Diameter: 3mm..
  • 【SHOPPING WITH CONFIDENCE】: We are committed to providing you with quality services. If you have any question, please feel free to contact us by sending emails.We will provide after-sales service until you are satisfied..
Check Stock

Spectrum Analyzer USB 35-4400M Signal Source RF Frequency Domain Black Analysis Tool with Tracking Source Module Industrial Supplies

  • RF Frequency Domain Analysis Tool. Sweep Bandwidth: 33mHz---4400mHz.
  • Turn on the tracking source output bandwidth 33mhz---3000mhz.
  • Made of fine quality material, the Spectrum Analyzer has a long service life. Small and portable, high accuracy.
  • Signal Source Spectrum Analyzer. Software used on the computer side: NWT4.11.09 version.
  • Computer operating system: Winxp, Win7, Win10.
  • 35-4400M Signal Tracking Source Module is an RF frequency domain analysis tool.
  • Signal Tracking Source Module with Shell. Sweep Step: ≥33-68.75mHz/125Hz, 68.75-137.5mHz/250Hz, 137.5-275mHz/500Hz, 275-550mHz/1kHz,....
Check Stock

ACEIRMC HC-SR04 Ultrasonic Sensor Distance Module for Nano Robot XBee ZigBee by ElecRight（5pcs

  • HC-SR04 Ultrasonic Sensor Distance Module: using IO trigger for at least 10us high level signal.
  • This module has stable performance and accurate measurement distance..
  • Detection distance: 0.78~196 in/ (2cm~500cm).
  • This module is fully Compatible with GH-311 anti-theft module..
  • HC-SR04 Ultrasonic Sensor Distance Module for Nano Robot XBee ZigBee by ElecRight.
Check Stock

AD834 Four Quadrant Multiplier Radio Frequency Mixer Module Multiplier Signal Processing for Mixers Filters

  • 【High Quality】The quadrant multiplier is made of high quality meterial, adopts the differential balun to single‑ended structure, can effectively suppresses harmonics..
  • 【Feature】The quadrant multiplier module is compact design, easy to carry and store, works well for differential merging and making the output signal symmetrical..
  • 【Advantage】AD834 Quadrant analog multiplier is an important component of modern signal processing systems, 1.6mm / 0.06in Thickness PCB double panel to ensure good passing performance of small and large current..
  • 【Application】The radio frequency module multiplier is practical in work, widely used in phase‑locked loops, signal processing power of mixers, filters..
  • 【Quality Assurance】The product is manufactured under strict quality control and standard requirements, and has a high safety factor, so it can be used with confidence..
Check Stock

16mA Logarithmic Amplifier Module 100 DB Amplifier Board 5MHZ‑500MHZ SMA Detector Module for FSK PSK Demodulation Signal Reception

  • Logarithmic Amplifier Module: Logarithmic output of the logarithmic amplifier module is proportional to the logarithm of the input signal..
  • RSSI Linearity: ±0.4 dB RSSI linearity, RSSI scale does not change with temperature and feed voltage..
  • Apply to: Used for received signal strength indicator (RSSI) and phase detection in cellular base stations, radar and other radio transceiver applications..
  • Specific Parameters: 16mA current, 20 mV/dB slope, ‑95 dBm intercede, SMA female, 5MHZ‑500MHZ frequency range, 100 dB gain. Dynamic Range: 100 dB -78 dBm to +22 dBm (Re 50 O). Total Gain: 100 dB. Bandwidth: 500 MHz. Sleep Current: 003c1mA..
  • Founction: AD8309 amplifier module, with limiting output, can be used as FSK PSK demodulation. Input and Output Interface: SMA Female..
Check Stock