Top Pressure Meter Series

PROWELD Argon/CO2 Mig Tig Flow Meter Gas Regulator Gauge Welding Accessory for Welding Machine

  • PROWELD Argon / CO2 Regulator and Flow Meter is a pressure reduction equipment to reduce the pressure of cylinder holding various kind of gas under....
  • Outlet of the Flowmeter will fit both the female 9/16" x 18 nut or the male 5/8" x 18 fitting. It comes with a standard 1/4" barbed fitting..
  • Can retain steady pressure output even the input pressure and input flux changes. Adjustable from 10 to 60 cfh (cubic feet per hour), and is indicated....
  • Argon flow meter's body is made of high-quality brass, which can withstand harsh environments..
  • Majorly used for welding,slicing,chemical industry,analyzing,testing and other industry usage..
Check Stock

LC200A Inductance Inductor Capacitance Capacitor L/C Multimeter Meter Tester

  • This MESR-100 V2 auto-ranging capacitor ESR and low Ohm meter measuring range is 0.001-100.0R, support in circuit testing..
  • It is the series resistance inside the capacitor, and 100kHz is used to remove the impedance 1/(2*pi*F*C). When the impedance becomes smaller, the real series resistance value can be measured to determine whether the capacitor is bad/damaged or in good condition..
  • Our ESR meter only applies less than 15mV DC or peak to peak on a good capacitor, as a result we can use it as in circuit test..
  • During repairing TV, LCD, Audio board, etc. we can in circuit testing the capacitor is good or not.【Note:The Capacitance Meter is used for testing the internal resistance of the capacitor, not for testing capacitance value.】.
  • Dual terminal, for fast and easy inspect general capacitor or resistor, a printed ESR table for fast check.Equipped with a SMD alligator clip for more accurately testing..
Check Stock

BTMETER Digital Anemometer Barometer Handheld, for Wind Speed Temperature Wind Chill Tester w/Humidity, Altitude, Barometric Pressure Meter for Climbing Drone HVAC CFM BT-100WM

  • ➤【MULTIFUNCTION ANEMOMETER】BT100WM wind speed gauge meter measures not only Wind Speed, Wind Temp, Wind Chill Indicator, but also Relative Humidity, Dew Point, Barometric Pressure and Altitude. With data log, Tripod hole for mounting, it’s ideal for outdoor activities:Long Range shooting, Hunting, Sailing, Kite flying, Drone Driving, CFM air flow test..
  • ➤【HIGH PRECISION】Digital wind meter for measure wind speed range 0.67 ~ 67.1 mph( +/- 5% accuracy).
  • Wind temperature range -10~45℃,14℉-113℉(+/-2 ℃/℉).
  • Wind meter measurement altitude from 0-19685 Ft. Resolution: 0.2 mph, 0.2℉,0.1% RH. So you can be rest assured to get fast and accurate reading..
  • ➤【EASY TO USE】Measures different readings such as Max, Min, Average, Current Wind Speed, display in 5 units: mph, ft/min, km/h, m/s or knots. Temperature (Celsius/Fahrenheit), Elevation(M, Ft), Atmospheric pressure(inHg, hpa mbar). And LCD backlit screen makes it easy to read in day or at night..
  • ➤【LOG THE BAROMETER DATA】This handheld wind speed meter can also log 16 groups of barometric pressure data for record, compare and analyse the relationship between temperature, humidity, and height. It’s compact pocket sized Pro anemometer for weather station, long distance shootin....
Check Stock

co2crea Hard Travel case Replacement for Omron 10 Series BP785N / BP786 / BP786N Upper Arm Blood Pressure Monitor Cuff

  • co2CREA hard travel case replacement for Omron 10 series wireless upper arm blood pressure monitor BP786 Omron 10 series wireless upper arm blood....
  • This blood pressure monitor Omron blood pressure cuff protection case perfect for your Omron series 10 blood pressure monitor Omron blood pressure....
  • co2CREA hard travel Omron 10 series bp monitor Omron blood pressure monitor BP785N upper arm case is a build-in super quality lining reflects superior....
  • This Omron 10 series blood pressure monitor case has a comfortable hand strap, so that the Omron 10 series upper arm blood pressure monitors Omron....
  • For sale is CASE ONLY! (Omron blood pressure monitors and Omron blood pressure monitor upper arm accessories are not included).
Check Stock

Diamond Original CR8900A Quad Band FM Mobile Antenna

  • The CR8900A is pretuned to give best bandwidth and VSWR over the FM portions of 10m, 6m, 2m, and 70cm ham bands when mounted on the side of vehicle (i.e. trunk lid) using a K400 or K600 series mount..
  • Designed specifically for the Yaesu FT-8900R.
  • The Diamond CR8900A quadband is a 10 meter, 6 meter, 2 meter and 440 MHz mobile antenna. It is a 1/4 wave on 10 and 6 meters providing and a 1/2 wave on 2 meters (2.15 dBi gain) and a 2 5/8 wave on 440 MHz (5.5 dBi gain). This antenna can handle up to 60 watts FM..
  • There are two center coils and a base coil. The connector type is UHF (for PO mount). The antenna is pretuned to give the best performance over the FM portions of the 10m, 6m, 2m and 70 cm bands when mounted on the side of the vehicle (such as a trunk lip mount). Suggested mounts would include the K400 or K600 series. This antenna is not recommended for a magnet mount or through-the-roof mounts. Includes an Allen wrench for tuning..
Check Stock

Auto Meter 7004 InVision Direct Fit Digital Dash LCD 73-87 Chevy/GMC Full Size Truck

  • ...ith 4 Switchable Colors (Red, Blue, White & Green). Equipped with Peak Recall and Warning Function to Guarantee Accurate Data and Road Safety.
  • SPEC.: (Speedometer & Tachometer): Standard 3-3/8" (85mm) Dial and 3-3/4" (95mm) Opening. (Water Temp, Volt, Oil Pressure & Fuel Gauge): Standard 2"(52mm) Dial 2-1/16"(52.4mm) Opening. EVO Gauge Set Requires any 1 to 9 Cylinder Engines Only - Compatible with 12-volt Negative Ground Systems.
  • Features: 4 Color Mode, 6 Level Brightness Adjustment.
  • 4 Types of Dimmer Setting where the Color Can be Shift According to Users' Needs in Different Conditions. It is Designed for In-dash Usage, While Suitable On-dash Mounting Cups Available to be Ordered - Flat Clear Acrylic Lens with Plastic Housing, Designed to be Installed with Ease.
  • Packaged: Speedometer GPS Sensor, Fuel Level Sender, Water Temp Sensor (Thread size: 1/8 NPT), Oil Pressure Sensor (Thread size: 1/8 NPT), 3-3/8" Mounting Stand (2 pcs), Daisy Chain, Wiring Harness, Installation Manual.
  • Warranty: One-year for Non-human Factor Damage and Free ....
Check Stock

1/3 Ct Diamond Solitaire Pendant Necklace in 14k White Or Yellow Gold

  • The CR8900A is pretuned to give best bandwidth and VSWR over the FM portions of 10m, 6m, 2m, and 70cm ham bands when mounted on the side of vehicle (i.e. trunk lid) using a K400 or K600 series mount..
  • Designed specifically for the Yaesu FT-8900R.
  • Heavy Duty Hex-Style Fold-Over, Multi-band, UHF female.
  • The Diamond CR8900A quadband is a 10 meter, 6 meter, 2 meter and 440 MHz mobile antenna. It is a 1/4 wave on 10 and 6 meters providing and a 1/2 wave on 2 meters (2.15 dBi gain) and a 2 5/8 wave on 440 MHz (5.5 dBi gain). This antenna can handle up to 60 watts FM..
  • There are two center coils and a base coil. The connector type is UHF (for PO mount). The antenna is pretuned to give the best performance over the FM portions of the 10m, 6m, 2m and 70 cm bands when mounted on the side of the vehicle (such as a trunk lip mount). Suggested mounts would include the K400 or K600 series. This antenna is not recommended for a magnet mount or through-the-roof mounts. Includes an Allen wrench for tuning..
Check Stock

Amprobe LM-200 LED Light Meter

  • Dual-scale meter measures visible light from fluorescent, metal halide, high-pressure sodium, and incandescent sources up to 200,000 lumens per square meter (lux) or 20,000 footcandles (fc).
  • Powered by a 9 V battery (included), and includes a 1.5-meter wire for positioning light sensor and a protective sensor cap.
  • Manual ranging, data hold freezes readings on the display, maximum recording displays highest reading, zeroing capability resets the null point and angled light cosine correction corrects for angled light.
Check Stock

co2CREA Hard Case Replacement for OMRON Gold BP5350 OMRON 10 Series BP7450 OMRON Platinum BP5450 Wireless Blood Pressure Monitor

  • co2CREA hard travel case replacement for OMRON platinum blood pressure monitor BP5450 or OMRON Gold Blood Pressure Monitor BP5350 or OMRON 10 series BP7450 home blood pressure monitor. Hard EVA shell case is shockproof dustproof and water resistance, protect your OMRON 10 series blood pressure monitor OMRON blood pressure monitor upper arm from drops, scratches, bumps, splash, and dust..
  • This blood pressure machine OMRON blood pressure cuff protection case perfect for your OMRON platinum BP5450 OMRON blood pressure machine upper arm Bluetooth blood pressure monitor, This OMRON blood pressure monitors case has more space to accommodate the blood pressure cuff OMRON blood pressure monitors arm OMRON series 10 wireless blood pressure monitor and more accessories..
  • co2CREA hard travel best blood pressure monitor at home blood pressure monitor case is a build-in super quality lining reflects superior taste and ensures a long-lasting performance, the soft anti static lining can protect your OMRON blood pressure machines for home use blood pressure monitor Bluetooth OMRON bp monitor from bumps dents and scratches..
  • This blood pressure machine Bluetooth best home blood pressure monitor case has a comfortable hand strap, so that the OMRON blood pressur....
Check Stock

Argon/CO2 Flow Meter Gas Regulator Compatible with Mig Tig Welder Regulator with 6.6FT Gas Hose 10 to 60 CFH Output Flow 0 to 4000 PSI - CGA-580 Inlet argon flow gauge welding regulator

  • ...uality brass, being sturdy and durable, which can withstand harsh environments and have a longer life. Came with 6.6 Ft argon welding gas regulator hose and protective cover are made of impact-resistant composite material for safety and durability.
  • 【Wide Application】Idea choice for CGA 580 Tank Fitting. This Gas Pressure Regulator/Flowmeter Can Be Used with Argon, Helium and CO2 Gas Tanks (CGA-580 Inlet). So it will screw right into the Argon, Argon/CO2 tanks. IDEAL FOR Miller, Lincoln, Hobart, HTP, and most other welders! Idea choice for MIG TIG welding, cutting ,chemical and electronics industry.
  • 【Accurate Gas Flow Gague】Adjustable from 10 to 60 cfh (cubic feet per hour), and is indicated by a ball which moves up and down in the flow tube. 0-4000psi inlet pressure, easy-to-read bottle pressure gauge included, allowing you to view how much gas is left in the tank range 0 to 4000psi. Will fit both the female 9/16" x 18 nut or the male 5/8" x 18 fitting. It also comes with a standard 1/4" barbed fitting.
  • 【Good Design】Use economic style flow meter regulator and single stage piston design, combination of regulator and flow meter as one unit, compact lightweight construction, convenient for use. Argon Regulator is a ideal choice for professional....
Check Stock

Ancel S3000 EVAP Automotive Smoke Machine Leak Vacuum Diagnostic Tester with Oil Level Gauge & Air Flowmeter for All Vehicle Boat Truck Motorcycle

  • ...nsation/EGR system, vacuum system, turbine system, intake manifold, vacuum line, etc..
  • [High performance and high-quality metal structure] Compared to other simple smoke leak diagnostic testers, the ANCEL S3000 smoke machine not only has a built-in air pump, but also has a pressure gauge and an adjustable flow meter. The compressor generates air pressure from 0.8 to 14.5 psi, allowing smoke to be easily introduced into the tested sealing system, speeding up the leak detection process..
  • [Pressure gauge+adjustable flow meter] You can judge whether the tested system has a leak by the pressure change of the pressure gauge. By adjusting the size of the flow meter, you can also better control the amount of visible smoke to locate specific leaks. There are separate air mode and smoke modes to meet your different needs..
  • [Easy operation] A few simple steps can help you detect leaks in the vehicle system. (1) Add tobacco oil (USP mineral oil/baby oil), you need to buy it separately. (2) Check the power cord (12V DC car battery). (3) Connect the system and test for leaks..
Check Stock

Auto Meter 6970 Cobalt Digital Boost Gauge,2.3125 in.

  • Features Auto Meter's E-Z View Digital LED Display System which maximizes readability and minimizes distracting high speed digit changes.
  • Includes data acquisition grade solid-state pressure transducer, providing unmatched accuracy and durability even in the harshest environments.
  • Auto Meter’s race proven digital stepper motor electric instruments provide unmatched accuracy which is further increased by utilizing a self calibration sequence during power up.
  • Gauge kit includes 1/8” NPT stainless steel pressure transducer, wiring harness, mounting hardware, and detailed instructions for installation.
  • 12 and 16 volt compatible, compatible with nearly every street car or race car electrical system.
Check Stock