Top Servo To Ttl Converter Board

Geekstory BN-880 GPS Module U8 with Flash HMC5883L Compass + GPS Active Antenna Support GPS Glonass Beidou Car Navigation for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

  • BN-880 is suitable for Open source flight controller, not for flight control with SCM.
  • Bn 880 gps module is dual module compass, with and electronic compass IC HMC5883L.
  • Bn 880 gps module has flash to save configuration. So you do not need to reset next time when you use it.
  • DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable.
  • When you use it for Raspberry Pi, there is no driver needed but you need to install software.
Check Stock

DIYmalls BN-180 GPS Module TTL Dual Glonass GPS + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk Aircraft CC3D Betaflight Flight Control

  • BN180 GPS Module can show your speed. When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to....
  • When you power up bn 180 GPS module the first time in a new location, it always takes longer to find satillites. This is referred to as “cold....
  • Data Level : TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable.
  • BN 180 gps doesn't have flash and compass. If you need it, please buy bn-880 gps module via "Visit the DIYmalls Store".
  • If you have any problem, please contact seller as follow: click "DIYmalls"(you can find "Sold by DIYmalls" under Buy Now button), in the new page,....
Check Stock

Geekstory BN-220 Dual GPS Glonass Module Navigation TTL Level 9600bps + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control

  • BN-220 gps module has flash to save configuration, so you do not need to reset data next time when you use it. But it has no compass. If you need gps with flash and compass, please buy bn-880 from Geekstory..
  • When you use it for Raspberry Pi, there is no driver needed but you need to install software.
  • The TX LED flash means gps module output normally.The PPS LED flash means gps module locate your place..
  • Data Level : TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable.
  • BN 220 gps module documentation link cannot be displayed. If you need technical documentation, please click “Ask a question” to em-ail us.
Check Stock

USB to TTL Serial 3.3V UART Converter Cable with FTDI Chip Terminated by 6 Way Header Works with Galileo Gen2 Boards/BeagleBone Black/Minnowboard Max and More

  • Moyina USB TTL +3.3V levels (signals only, VCC= +5V) Serial cable is a range of USB to TTL serial UART converter cables featuring FTDI's FT232RL USB....
  • Provides a fast, simple way to connect devices with a TTL level serial interface to USB. Support EEPROM, Vendor ID re-write and Mprog3.5.
  • Provides access to UART Transmit (Tx), Receive (Rx), RTS#, CTS#, VCC (5V) and GND connections. RoHS compliant and CE approved.
  • Operating system Compatibility: Windows 10/8/7, Windows Vista, Windows XP, Windows 98, Windows ME, Linux and Mac OS. Please check for details in....
  • The USB side of the cable is USB powered and USB 2.0 full speed compatible, while the other end is a 6 way, 0.1”, Single-In-Line (SIL) pitch gold....
Check Stock

BotBrain Robotics Control Board

  • Basic Stamp microprocessor, the board uses sensor inputs, a program, and servo outputs to operate a robot using the Parallax pBasic language.
  • Features include 8 sensor inputs and 5 servo outputs, all with polarized connectors as well as a built-in piezo "speaker".
  • Holes on side on the side of the board bolt to Merkur parts.
Check Stock

CP2102 6 in 1 USB to TTL Serial Adapter Module USB to TTL 485 232,TTL to 232 485,RS232 to 485 + 4P Dupont Cable Jumper Wire Female to Female for Nextion Display Beitian GPS Arduino Windows

  • -cp2102 serial adapter module supports usb to ttl, usb to rs232, usb to rs485, ttl to 232, ttl to 485, 232 to 485..
  • -USB specification 2.0 not 3.0, compatible with arduino,Windows XP/7/8/10 32bits/ 64bits, Linux etc..
  • -You need to set the dip switches for different conversion purpose..
  • -Before make 6 in 1 usb to ttl module work, you need to install cp2102 driver..
  • -cp2102 usb to ttl adapter widely used with nextion display, beitian gps, esp-01s adapter, sim7000a board etc..
Check Stock

9 Pieces JST Y Connector 3 Pin JST Plug Splitters Servo Extension JST Male to Female RC Servo Extension Cord Wire Cable Compatible with RC JR Futaba RC Car or Airplanes (Mixed Style)

  • Package includes: you will 9 pieces of servo extension cord, 3 pieces of male JST to female JR (Futaba) cable, 3 pieces of male to 2 female Y harness, 3 pieces of male to 3 female Y harness.
  • Abundant quantity and diverse styles that can meet your various needs.
  • Appropriate sizes: the servo extension cord measures approx. 15 cm/ 5.9 inches in length, universal size for your use, the color is white, black and red.
  • Extensive usages: these JST male to female are compatible with Futaba and JR servo, plane and helicopter servo connection or receiver connection, also nice for remote control car, RC car and more.
  • Well made: JST connector is made of quality PVC material, with good insulation and flame retardant.
  • The interior is made of tinned copper, which has a good transmission and low resistance.
  • Useful function: the servo extension wire is suitable for jumping from board to board, or can be applied to control panel cable remote control unit, which is male to female.
Check Stock

10 pcs 3.93inch JR Style Servo Extension Cable Lead Wire - 3-Pin JR Plug Male to Male RC Servo Wire Extension Cord

  • 3-Pin JR plug male to male connector servo extension lead wire cable..
  • There is a 3 pin JST RE connector on each end. This is a simple 3 wire cable. Ideal for jumping from board to board, or something else..
  • Practical range: For Airplane, Helicopter, Quad co-pterter , Multi-coater RC car servo connection or receiver connection..
  • Packaging quantity ：10 Pcs * 10cm JR 3pin male to male plug servo extension cables wires cords leads..
Check Stock

Canon EOS 6D Mark II DSLR Camera with Canon EF 75-300mm f/4-5.6 III Lens + Canon EF 50mm f/1.8 STM Lens + Fully Dedicated TTL Flash + 64Gb SDXC Card + FB-150 Flash Bracket (22 Items kit)

  • ...with 1-year Seller Warranty and includes:.
  • Canon EOS 6D Mark II - 26.2MP Full-Frame CMOS Sensor - DIGIC 7 Image Processor - 45-Point All-Cross Type AF System - Full HD Video at 60 fps.
  • Digital IS - 3" 1.04m-Dot Vari-Angle Touchscreen LCD - Dual Pixel CMOS AF and Movie Servo AF - Native ISO 40000, Expanded to ISO 102400 - 6.5 fps Shooting.
  • Time-Lapse & HDR Movie - Built-In GPS, Bluetooth, & Wi-Fi w/ NFC. Optical viewfinder offers approximately 98% coverage of the frame and has a magnification of 0.71x..
  • Canon EF 75-300mm f/4-5.6 III Lens - EF Mount Lens - Aperture Range: f/4-45 - DC Autofocus Motor - Minimum Focus Distance: 4.9' - 58mm Filter Thread Diameter. Canon EF 50mm f/1.8 STM Lens - EF Mount Lens/Full-Frame Format - Aperture Range: f/1.8 to f/22 - Optimized Lens Coatings - STM AF Motor Supports Movie Servo AF - Manual Focus Override - Metal Lens Mount - Rounded 7-Blade Diaphragm - Minimum Focus Distance: 14"..
  • SanDisk 64GB Ultra Class 10 SDXC UHS-I Memory Card - Great choice for compact to mid-range point and shoot camera - Twice As Fast As Ordinary SDHC Cards, Allowing You To Take Pictures And ....
Check Stock

15 Pcs Servo Extension Cable JST Y Connector 3 Pin JST Plug Splitters Male to Female Servo Adapter JST Extension Servo Wire Connector Compatible with RC JR Futaba RC Car or Airplanes, 3 Styles

  • You Will Get: the package comes with 15 pieces of servo extension cables, including 5 pieces of male JST to female JR (Futaba) cable, 5 pieces of male to 2 female Y harness, 5 pieces of male to 3 female Y harness, sufficient quantities and multiple styles can satisfy your different using needs.
  • Proper Size: the servo connector is about 15 cm/ 5.9 inches in length, suitable size for your to use, with colors of white, black and red.
  • Wide Application: these JST plug splitters are compatible with Futaba and JR servo, plane and helicopter servo connection or receiver connection, also suitable for remote control car, RC car and so on, providing a lot of usages for you.
  • Nice Craftmanship: the JST plug connector is made of quality PVC material, which has good insulation and flame retardant, and the interior is made of tinned copper, featured a good transmission and low resistance performance, you can rest assured to use it.
  • Practical Function: the servo wire connector can be applied for jumping from board to board, or nice to control panel cable remote control part that is male to female.
Check Stock

Canon EOS 6D Mark II DSLR Camera with Canon EF 75-300mm f/4-5.6 III Lens + Canon EF 50mm f/1.8 STM Lens + Fully Dedicated TTL Flash + 64Gb SDXC Card + FB-150 Flash Bracket (22 Items kit) (Renewed)

  • ...with 1-year Seller Warranty and includes:.
  • Canon EOS 6D Mark II - 26.2MP Full-Frame CMOS Sensor - DIGIC 7 Image Processor - 45-Point All-Cross Type AF System - Full HD Video at 60 fps.
  • Digital IS - 3" 1.04m-Dot Vari-Angle Touchscreen LCD - Dual Pixel CMOS AF and Movie Servo AF - Native ISO 40000, Expanded to ISO 102400 - 6.5 fps Shooting.
  • Time-Lapse & HDR Movie - Built-In GPS, Bluetooth, & Wi-Fi w/ NFC. Optical viewfinder offers approximately 98% coverage of the frame and has a magnification of 0.71x..
  • Canon EF 75-300mm f/4-5.6 III Lens - EF Mount Lens - Aperture Range: f/4-45 - DC Autofocus Motor - Minimum Focus Distance: 4.9' - 58mm Filter Thread Diameter. Canon EF 50mm f/1.8 STM Lens - EF Mount Lens/Full-Frame Format - Aperture Range: f/1.8 to f/22 - Optimized Lens Coatings - STM AF Motor Supports Movie Servo AF - Manual Focus Override - Metal Lens Mount - Rounded 7-Blade Diaphragm - Minimum Focus Distance: 14"..
  • SanDisk 64GB Ultra Class 10 SDXC UHS-I Memory Card - Great choice for compact to mid-range point and shoot camera - Twice As Fast As Ordinary SDHC Cards, Allowing You To Take Pictures And ....
Check Stock

MakerFocus PWM Servo Motor Driver IIC Module 16 Channel PWM Outputs 12 Bit Resolution I2C Compatible with Raspberry Pi 4 3B+ 3B Zero/Zero W/Zero WH and Jetson Nano

  • Note: The Raspberry Pi and Servo in the photo are not included. User Manual: Please get the link from the operation guide below.
  • Note: 1.If you only connect 5V power supply to USB interface, servo cannot be driven.
  • 2.You should connect higher power supply for higher-power servo.
  • 3.Make sure servo are connected properly, otherwise they will not move..
  • Servo Motor Driver: You may have tried to control a robotic arm or a hexapod walker by using the Raspberry Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver Board for you..
  • Raspberry Pi connectivity, compatible with Raspberry Pi 4 3B+ 3B 2B+ 2B Zero/Zero W/Zero WH and Jetson Nano..
  • Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales).
  • Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal..
Check Stock