Top Xlpe Cable Extrusion Line

HEATIT JHSF 12-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 6-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 80-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable.
Check Stock

HEATIT JHSF 24-feet 120V Self Regulating Pre-assembled Pipe Heating Cable

  • JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com)..
  • Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional..
  • Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather..
  • ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. The minimum bending radius is 1 inch.Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Prote....
Check Stock

DEWENWILS Roof Heat Cable, 6ft Heat Tape for Pipe, Gutter, Roof, Self-Regulating Cable Pre-Assembled, UL Listed

  • Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two-year limited quality . If you are not completely satisfied with HEATIT heating cable, please don't hesitate to contact our customer service at any time, we'll try our best to solve your issues..
  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37....
Check Stock

Qmark WHT500 Utility Heater for Use in Well Houses, Utility Rooms, and Areas with Pipes and Machinery, 500 Watt, 240 Volt, Beige

  • Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two-year limited quality . If you are not completely satisfied with HEATIT heating cable, please don't hesitate to contact our customer service at any time, we'll try our best to solve your issues..
  • Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid..
  • Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket..
  • Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8'' and less than 1 1/2'' in. diameter. No crossing. No spiral. No overlap itself. Only straight..
  • Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37....
Check Stock

Gaobige Coax Cable Crimper Kit Tool for rg6 rg59 Coaxial Compression Tool Fitting Wire Stripper with Gaobige 10pcs F Compression connectors - Grey

  • ...FULLY ADJUSTABLE AND REPLACEABLE BLADES CAN STRIP CABLE PERFECTLY: Work with RG-59, RG-59 Quad, RG-6, RG-6 Quad, and RG-58, 3V, 2V, 4C, 5C. Equipped with hexagonal tools can adjust the depth of the v-shaped incision, 3 to 7 Clockwise circle, one-time peeling, keep inner core..
  • SOLIDLY BUILT CRIMPING TOOL CAN PRECISE EXTRUSION THE F CONNECTORS: Work with rg-6, rg-59 etc. Compatible for most brands of compression connectors. Portable Size, handle made of the special soft material, non-slip, comfortable to use, feel strong..
  • PREMIUM QUALITY F CONNECTORS PREFECT FOR RG6 COAXIAL CABLE: It provides a professional, secure connection for RG6 coaxial cable. Anti-corrosion nickel-plated, for indoor use.
  • LIGHTWEIGHT AND EASY TO CARRY FOR INDOOR USE: Very convenient to install a satellite tv dish /cctv , move cable tv and cable modem, or wire up the cables for your new house.DescriptionFeatures:.
  • Very easy to cut cable once you adjusted the cutting depth for cable..
  • Fully adjustable and replaceable blades can strip cable perfectly..
  • Solidly built crimping tool can precise extrusion the F connectors..
  • Premium quality F connectors prefect for RG6 coaxial cable..
  • Lightweight and easy to carry for indoor use..
Check Stock

Stihl 0000 930 4300 CF3 Pro Trimmer Line

  • The CF3 Pro Trimmer Line is formed using 3-component, tri-extrusion technology..
  • The CF3 Pro Trimmer Line is compatible with all STIHL nylon line trimmer heads, making the CF3 Pro at home on any landscape trailer or in any garage..
  • Its high-quality polyamide components ensure strong durability with excellent cutting performance..
Check Stock

DIANN 10pcs RG6 Compression Connectors RG6 F Type Connector Coax Coaxial Compression Fitting

  • Connector Type: RF Adapter, Female Jack F- Type Connector.
  • Inner Diameter of the Wiring Tube: 8.7mm.
  • High Quality:RG6 Compression Connector Made of Nickel-Plated Brass, Which Has Good Electrical Properties, High Hardness and Not Easy to Break. The Nickel-Plated Layer Has Anti-Rust and Anti-Corrosion Effects. Long-Term Use Will Not Fall Off, Will Not Change Color.
  • Easy to Install:RG6 Compression Connector’s Quadruple Sealing System Prevents Moisture From Migrating Into the Connection. 360-Degree Radial Compression Provides Excellent Radio Frequency Performance and Integrity.
  • Applications: RG6 Compression Connector Wildey Used for Install a Satellite TV Dish / CCTV, Move Cable TV and Cable Modem, or Wire Up Cables for New House.
Check Stock

SENRISE 100 X Transparent Shrink Wrap Film Bag Heat Seal Gift Packing for Homemade DIY Project Packaging Candle Jar Bath Bomb Gift 2235CM

  • EXTRUSION SYSTEM: Gradient mixing type with high-speed energy saving design, extrusion blow moulding machine gradually changed screw with same distance and different deep. Material of screw: High quality nitriding steel 38CrMoAlA,with nitriding surface HV≥800,brittleness≤2. Material of barrel: High quality nitriding steel 38CrMoAlA,with nitriding surface HV≥900,brittleness≤2..
  • DIE HEAD: Head mode of plastic toy extrustion blow molding machine, the continuous extrusion head is designed with material center coming-in type and removing the plastic melting line on the product surface, easily for material or color change, saving the time & material cost with speedy operation..
  • HYDRAULIC SYSTEM: The main hydraulic system of fully automatic precision plastic injection blow moulding machine is mainly composed of motor, pump, pressure regulating valve block, reversing valve blocks, cylinders and oil chillers. It controls platens open & close, carriage up & down, extrusion system up & down, blow pin actions, or even spinning cut and so on..
  • ELECTRICAL CONTROL: The electrical control system of plastic small bottles blowing machine is composed of operation panel, temperature control module, PLC, input & output module, proportion board, contactors, voltage s....
Check Stock

0000-930-2340 Trimmer Line .095" (280') Orange 1 Lb Roll

  • An extremely robust, long-lasting trimmer line designed for some of the toughest trimming applications..
  • This rugged line is formed using 3-component, tri-extrusion technology..
  • Its high-quality polyamide components ensure strong durability with excellent cutting performance.
Check Stock

Taiss 20PCS RG6 Compression connectors,F Type Coaxial Cable Compression connectors (Black)

  • Product name:RG6 F Type Compression connectors..
  • Product dimensions:Length before extrusion:31.5mm/1.24inch.
  • Material:The material of the connector is nickel-plated brass.Good conductivity,rust and corrosion resistance,durability and long service life..
  • Applicable to：Satellite TV,cable TV and the Internet,Audio,Video..
  • Product packaging:20PCS Compression Connector；Color:silver、black..
Check Stock