Top Display Lcd Module

LANTRO JS 1.14 Inch TFT Color LCD Display Module ST7789 8Pin IPS 135x240 TFT Display Screen Module

  • The module is a low-power consumption character LCD Module with a built-in controller..
  • The module can be easily interfaced with a MCU..
  • Display Format: 20 Characters x 4 lines..
  • Fully assembled and tested Serial LCD 20x4 Module..
Check Stock

waveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard

  • Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
  • Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
  • 1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
  • 10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
  • Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.
Check Stock

WayinTop 20x4 2004 LCD Display Module with IIC/I2C/TWI Serial Interface Adapter (Yellow Green/2004)

  • 【20x4 LCD Display】With this shield, you can display whatever you want by programming the for Arduino board. Therefore, this is a perfect choice to make your project more interesting and vivid! Totally display 20 characters in one row, 4 rows can display 80 characters..
  • 【IIC Interface Adapter】No need to buy the adapter extra, this kit contains a IIC/I2C/TWI Serial Interface Adapter, with witch you can start your project at any time..
  • 【Easy to Use】 Less I/O ports are occupied, only four - VCC, GND, SDA (serial data line), SCL (serial clock line). Address of the module: 0x27.
  • 【Support IIC Interface】It only takes two I/O port thus saving more for other usages. You can adjust the contrast by the potentiometer at its back. If you don’t want the back light, you can also unplug the jumper cap at the LCD back..
  • 【Widely Applications】LCD display module based on the popular controller, works great with for Arduino and other micro-controllers..
Check Stock

Naroote Display Module, TFT LCD Touch Panel Serial Port Module + ILI9341 5V/3.3V 2.8\ 240x320 -Product Quality Assurance

  • ...ries 4.3" TFT LCD module can be controlled by any MCU. This offers 1 G Hz Cortex A8 CPU driving device and 128 Flash memory for HMI projects. You also get RS232/TTL UART Interface and USB port. This is an excellent choice for your Arduino and Raspberry Pi projects..
  • Clear, Detailed, Hi Res HD - Our Smart HMI TFT LCD display offers excellent 480x272 high resolution with 4-wire resistance touch screen. Rich 262K (18bit) color for high color restore. Rectangular ratio 16:9 display format conversion. 70°/70°/50°/70° wide viewing angle, adjustable brightness（300 cd/m²) , TTF Font and contrast (500:1) offers you the ultimate project experience to accomplish more with improved results..
  • Ultimate TFT LCD Display Module for Industry - SCBRHMI Intelligent TFT-LCD Module Model STWC043WT-01 is a customer favorite for a wide range of industrial and business applications. You get highest quality with the most usable functions. Often purchased for equipment in medical, beauty, engineering, industrial control, electric power, civil electronics, automation, traffic, new energy, and IOT applications..
  • Generous 3 Year Warranty - We make SCBRHMI products to last and work well on the job. If this breaks, return it and we will replace it at no cost. Our displays ....
Check Stock

ACEIRMC 2pcs 1602 LCD Keypad Shield 1602 LCD Expansion Shield Board Blue Backlight 4.5-5.5V for Arduino R3 MEGA2560 Nano Due Duemilanove Robot (5pcs)

  • 1602 LCD Shield Module Display V3 for Arduino R3 MEGA2560 Nano DUE.
  • This is a 16x2 LCD Keypad module for Arduino Diecimila Duemilanove,MEGA1280, MEGA2560 board..
  • Blue Backlight with white words, adjustable backlighting.
  • 4 Bit LCD Library,V3 design, pins out for easy connecting.
  • 1602 LCD Keypad Shield 1602 LCD Expansion Shield Board Blue Backlight 4.5-5.5V for Arduino Duemilanove Robot.
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • ...Sensor HC-SR501 -Distance measurement module HCSR04 -Sound sensor detector module with programmable threshold -LM35 temperature sensor -Tilt detector module -Servo SG90 motor -Stepper motor (5V) -Motor driver module for stepper motor ULN2003.
  • 5V Active Buzzer -5V Passive Buzzer -LCD 1602 16 characters * 2 lines -LED Display Driver MAX7219 -LED Matrix Display of 8*8 -7 Segments Display 1 digit -7 Segments Display 4 digits -Simple Relay Module - Infrared Remote Control 38kHz - 38kHz Infrared decoder receiver (type 1838) - Infrared phototransistor (Flame sensor) - Infrared LED - Light sensor (Photoresistor).
  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

5 Pieces I2C Display Module 0.91 Inch I2C OLED Display Module Blue I2C OLED Screen Driver DC 3.3V~5V(Blue Display Color)

  • What will you get: there are 5 pieces OLED display module with blue display color, self-illuminated and no need backlight.
  • Power-saving display: the I2c oled display performs better than the traditional LCD display and with lower consumption sicne the IIC (I2C communications) simplifies connections.
  • Please note that these I2C OLED display module comes without pin headers.
  • More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
  • Good compatibility: this i2c oled display module is compatitable with Raspberry Pi 4B/3B+/3B/2B/Zero, compatitable with Arduino, also compatitable for ESP8266, ESP32, STM32, etc..
  • Product manual: as shown in the instructions.
Check Stock

JM Set of 3 pcs Transparent 3D Floating Frame Display Holder/Box/Frames for Challenge Coins, AA Medallions, Antique, Jewelry,Gift, White, 2.75 x 2.75 x 0.75 Inches

  • What will you get: there are 5 pieces OLED display module with classic display color, self-illuminated and no need backlight.
  • Power-saving display: the I2C oled display performs better than the traditional LCD display and with lower consumption the IIC (I2C communications) simplifies connections.
  • Please note that these I2C OLED display module comes without pin headers.
  • More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
  • Good compatibility: this i2c oled display module is compatible with Raspberry Pi 4B/3B+/3B/2B/Zero, compatible with Arduino, also compatible with ESP8266, ESP32, STM32, etc..
  • Product manual: as shown in the instructions.
Check Stock

Treedix 3.5 inch TFT LCD Display 320 x 480 Color Screen Module Compatible with Arduino UNO R3 Mega2560

  • Color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor)..
  • Composed of a color TFT-LCD panel, driver IC, FPC and a back light unit..
  • The module display area contains 320x 480pixels..
  • This product accords with RoHS environmental criterion..
  • Compatible with Arduino UNO R3 Mega2560 DUE..
Check Stock

2004 204 20x4 Character LCD Display Module HD44780 Controller Blue Blacklight

  • Durable hard PCB board and metal, ideal for 1602 interface.
  • Welded by reflow soldering, no burrs, comfortable and safe.
  • Power supply IC and SD card slot, convenient to uses.
  • Transparent protective film covered on the display protect it from damage.
  • Suitable for beginners of LCD color display module,SCM learners and LCD enthusiasts.
Check Stock

Boost Buck Converter, DC 6-55V to 0-50.00V Wireless Digital Adjustable Programmable Step-Down Communication Version Buck Power Supply Module LCD Constant Voltage Buck Converter(DPS5005)

  • The constant voltage and constant current programmable control power supply module put the collection of analog integration and digital control functions in one..
  • This module has power-down stored function and can store 10 groups preset value..
  • Compared with the traditional analog power supply, it is more convenient to quickly extract the voltage or current required..
  • LCD display on the module has the function digital voltmeter and ammeter..
  • On the setting data interface, you can adjust over-voltage value, over-current value, over-power value, data set and LCD brightness.This module has many advantages, small size, advanced function, good visual effect, high operability, high-precision, being used independently, being inset into the device and been widely applied..
Check Stock

DC Variable Power Supply WZ5005 Adjustable Switching Power Supply with 4 Digit LCD Display for Lab Equipment and Electronic Testing

  • ...erature and undervoltage protection for long time usage..
  • EASY OPERATION-- USB to TTL module (U2T)/RS485 to TTL module (T485) can be selected with remote connection control for necessary test requirements..
  • EQUIPPED WITH LARGE LCD DISPLAY-- Adjustable switching power supply is designed with 1.8-inch high-definition LCD screen with LCD 4-digit display, support PC upper computer, support for Android APP..
  • DATA HOLD FUNCTION FOR EASY DATA STORAGE-- Variable power supply comes with convenient and quick data storage, key lock function to prevent misoperation..
  • AUTOMATICALLY SHUT OFF FOR SAFE TESTING-- The output over?voltage (OVP)/over?current (OCP) data can be set through the buttons on the panel, and the over?temperature protection (OTP)/under?voltage protection (LVP) is built?in. When the output voltage, current and device temperature exceed the protection value, input voltage is less than the protection value, the power supply is automatically shut off to protect the safety of electrical equipment..
Check Stock